- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
You have to start outside. First regrade slope of soil away from foundation. Add a drain and tile to direct water away from house. If necessary dig down along foundation wall and add membrane. In the basement, add a sump pump to pump out water to keep moisture out. Clean basement wall, and add some waterproofing paint.
Thank you by you request, I hope everything is fine.
I will try to help you.
Do this :
Lookat the circuit to be measured, in this case I chose to check an outlet. In thiscase I need to check if an outlet is live.
Keep fingers behind the fingerprotectors
Thevoltage in a house circuit will range from 120 Volts in the wall outlets, to220 Volts at the range and dryer outlet. Both of which can kill instantly. Thisis where extreme care and safety must be observed. Inspect leads and probes fordamage and cracks. If any damage or cracks is found DO NOT USE, THROW AWAY!!!Keep fingers behind the finger guard as seen in the picture.
200 Volts AC scale
Choosea range which exceeds the voltage you expect to measure. You will need tochoose the AC scale.
Measuring wall outlet to test forvoltage. Thank you in advance,sincerely. Blessing. If you need further assistance, please reach me. E.CUADRAMANAGUA, NICARAGUA. C.A.
It sounds like the trolley is jammed against that bolt in front of the motor housing. If so, remove the bolt and then run the opener until the door closes. Now locate the 'up limit' control on the side of the motor housing and turn it 2 full turns in the opposite direction of the arrow printed on the cover.
Hey how you doin.
I had the same problem during a trip around Australia, some bull dust built up around the lens area. The only thing I did to rectify the problem was to blow it out with a tyre inflator at a road house when I stopped for petrol. No problem since then.
You may have some fine sand wedged in the cover area aswel.
Good luck 'R'
If you take a picture using the optical viewfinder, does the camera actually record the picture? If so, you may have the LCD turned off in the camera mode (there are three options: standard, detailed, and off). With the camera in the shooting mode, press the "DISP" button and see if the LCD turns on.