Question about Pioneer Vsx-821-k 5.1 Channel A/v Av Home Theater Receiver Hdmi 3d Ipod Ready

Open Question

My pioneer vsx-821-k keep reading on the dashboard "overheat" then it goes off

Once it goes off, i press the power button it comes on again for 2 seconds and goes off, i still dont know the problem, even the local service technician failed ,could someone please give a technical advise?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: stand by button flashes but receiver wont turn on

I have vsx-d812 that has an AMP ERR in error menu. the troubleshooting was found to be Q696 and Q697 in the DC prot. area on "C" board, up near front toward diplay in center of c board. You can get access to error codes on VSX pioneer unit by pressing "enter" and "adv. surr." simultaneously for 2 sec. The display should show what error code you are experiencing. I believe there are three diff. error codes. 1) AMP ERR 2) OVERLOAD 3) BOAD ERR (not mistyped) I hope this helps pinpoint error code for ya.

Posted on Jan 12, 2008

Ad
dragster301
  • 12 Answers

SOURCE: Pioneer VSX-918V-K Standby Light Flashes but will not turn on.

unplug it and press the power buton and then hold the power button, and while your holding the power button, plug it back in

hope it worked!!!

Posted on Jul 31, 2009

  • 4 Answers

SOURCE: Pioneer VSX-816

With the receiver off, press ENTER + ADVANCED SURROUND keys continuously for 2 sec. and it will tell you the fault it encountered. Even if it has a short, it will still protect the speakers; however, it is still a good idea to disconnect all speakers before doing this.

Posted on Aug 12, 2009

  • 128 Answers

SOURCE: My Pioneer VSX-D1S A/V receiver will not power on

Unit is pretty old I had one of these back in 98-99.

Time to upgrade a service tech is going to cost you $150 just to open it up and figure out whats bad.

Pioneer ok but check out Denon's line of receivers Onkyo is good too but they have a high rate of repairs

Pioneer doesn't make them like they used to that D1S was a tank, had tons of audio / video inputs was one of the first with video upconverting had lots of power and a great front display panel. BUT technology has come along way and pioneer hasn't kept up. They even stopped making high end TV's a few years ago even though they were regarded as the best sets out there.

check this out
Denon AVR-4310CIgoogle it they sell for ALOT less than sticker I bought one for $1299 with a 5 year warranty

Hope that helps


Posted on Feb 19, 2010

Testimonial: "@thebigdoghim, thanks for the very constructive feedback. I was 80% certain that the cost to diagnose the problem alone would be in the triple digits."

  • 1 Answer

SOURCE: Pioneer VSX-1019 with a flashing red MCACC

you can "release" the error by pressing the "down arrow" and the "zone 2 on/off" for 2 seconds.

Posted on May 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Pioneer av no hdmi output after power surge


internal fuse was blown check motherboard if you know how to open panel if niot take to technician

Feb 26, 2014 | Pioneer VSX-821-K - 5.1 Channel A/V Home...

1 Answer

Pioneer VSX-821-K receiver overheating


If you can obtain an ohm meter, check the speakers by touching the leads to the meter and see what it says. The meter should be set to measure < 1 kohm. If it shows lower than 4 ohms you have a bad speaker. If you have multiple speakers on one channel then it cannot handle the drop in resistance and it is overheating.

Jan 27, 2014 | Pioneer Audio Players & Recorders

1 Answer

Pioneer vsx 821 k


Check in the setup menu to see if the volume limiter has been set by mistake

May 27, 2013 | Audio Players & Recorders

1 Answer

Owner's manual for Pioneer Model: VSX-821-K|


Hi Arthur,
Download the manual here

Hope this helps.Thanks!
Please rate this answer.

Dec 09, 2011 | Audio Players & Recorders

2 Answers

On my Pioneer receiver (model # vsx-9100tx) MCACC light keeps flashing and system will not power on. Please advise.


Hi the mcacc light keep's flashing and will not come on. Can you help with this thank you Lee

Dec 22, 2010 | Pioneer Elite VSX-9100TX Receiver

3 Answers

Pioneer VSX-1019 with a flashing red MCACC


you can "release" the error by pressing the "down arrow" and the "zone 2 on/off" for 2 seconds.

Mar 11, 2010 | Pioneer VSX-1019AHK A/V receiver

4 Answers

Pioneer vsx-d814 will not power on after power surge


I pressed the front Enter and Advanced Surround for 2 seconds on my VSX-D814 and that worked. Thanks.

Mar 21, 2008 | Audio Players & Recorders

3 Answers

Stand by button flashes but receiver wont turn on


I have vsx-d812 that has an AMP ERR in error menu. the troubleshooting was found to be Q696 and Q697 in the DC prot. area on "C" board, up near front toward diplay in center of c board. You can get access to error codes on VSX pioneer unit by pressing "enter" and "adv. surr." simultaneously for 2 sec. The display should show what error code you are experiencing. I believe there are three diff. error codes. 1) AMP ERR 2) OVERLOAD 3) BOAD ERR (not mistyped) I hope this helps pinpoint error code for ya.

Oct 07, 2007 | Pioneer VSX-816-K/S Receiver

Not finding what you are looking for?
Pioneer Vsx-821-k 5.1 Channel A/v Av Home Theater Receiver Hdmi 3d Ipod Ready Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pioneer Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5114 Answers

John
John

Level 2 Expert

509 Answers

T-Comtech Repairs
T-Comtech Repairs

Level 2 Expert

417 Answers

Are you a Pioneer Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...