Question about Apple iPhone Smartphone

1 Answer

Now the only thing that appears non the Iphone is a picture of a USB connecting to itunes

Now the only thing that appears on the Iphone is a picture of a USB connecting to itunes

Posted by on

  • Anonymous Mar 22, 2009

    this did not work for me

  • Thomas Lim
    Thomas Lim May 11, 2010

    Have you tried powering it off and then on then restarting the computer then using the Itunes?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 53 Answers

Sync to itunes and follow the instructions

Posted on Feb 18, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a problem with my iphone it is unlock and y dont now the password


Place in to forced recovery mode using itunes.Use the following steps to place your device into recovery mode. If the device is already in recovery mode, you can proceed immediately to step 6.

Disconnect the USB cable from the iPhone or iPod touch, but leave the other end of the cable connected to your computer's USB port.
Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the the iPhone or iPod touch to turn off.
If you cannot turn off the device using the slider, press and hold the Sleep/Wake and Home buttons at the same time. When the device turns off, release the Sleep/Wake and Home buttons.
While pressing and holding the Home button, reconnect the USB cable to iPhone. When you reconnect the USB cable to iPhone, the device should power on.
Note: If you see the screen pictured below, let the device charge for at least ten minutes to ensure the battery has some charge and then start with step 2 again.
Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears you can release the Home button:Use iTunes to restore the device.
If you don't see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.

When using recovery mode, you can only restore the device. All user content on the device will be erased, but if you had previously synced with iTunes on this computer, you can restore from a previous backup

Jan 19, 2010 | Apple iPhone Smartphone

1 Answer

When i switch on my ipod touch, it's telling me to connect to my computer and when I do connect, it's still the same thing


you may have to restore it....but you'll lose all your data here's how...
  1. Verify you have iTunes 7.5 or later. Apple recommends using the latest version of iTunes.
  2. Disconnect the USB cable from the iPhone or iPod touch, but leave the other end of the cable connected to your computer's USB port.
  3. Power off the device (Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the the iPhone or iPod touch to turn off.
  4. Press and hold the Home button while reconnecting the USB cable to iPhone. When you reconnect the USB to iPhone, the device should then power on. 

    Note: If you see the message "Charging... Please Wait" or you see the screen pictured below, let the device charge for at least 10 minutes to ensure the battery has some charge and then start with step 2 again.
  5. Continue holding the Home button while iPhone starts up. While starting up, you will see the Apple logo.
  6. When you see "Connect to iTunes" on the screen, you can release the Home button and iTunes will display the recovery mode message: 

Sep 06, 2009 | Apple iPod touch

2 Answers

The ipod is writtig 'ipod disabled connect to itunes'


You'll hv to restore the ipod..here's how...
  1. Verify you have iTunes 7.5 or later. Apple recommends using the latest version of iTunes.
  2. Disconnect the USB cable from the iPhone or iPod touch, but leave the other end of the cable connected to your computer's USB port.
  3. Power off the device (Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the the iPhone or iPod touch to turn off.
  4. Press and hold the Home button while reconnecting the USB cable to iPhone. When you reconnect the USB to iPhone, the device should then power on.

    Note: If you see the message "Charging... Please Wait" or you see the screen pictured below, let the device charge for at least 10 minutes to ensure the battery has some charge and then start with step 2 again.ht1808_01.jpg
  5. Continue holding the Home button while iPhone starts up. While starting up, you will see the Apple logo.
  6. When you see "Connect to iTunes" on the screen, you can release the Home button and iTunes will display the recovery mode message:
    ts1275.png
    ht1808_02.jpgIf you don't see the "Connect to iTunes" screen, then disconnect the USB cable from iPhone and repeat steps 3-6.

Aug 27, 2009 | Apple iPod touch

1 Answer

Itouch is diabled someone put a password on it and all that comes up is the number pad for the password. will not connect to itunes either


  1. Verify you have iTunes 7.5 or later. Apple recommends using the latest version of iTunes.
  2. Disconnect the USB cable from the iPhone or iPod touch, but leave the other end of the cable connected to your computer's USB port.
  3. Power off the device (Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the the iPhone or iPod touch to turn off.
  4. Press and hold the Home button while reconnecting the USB cable to iPhone. When you reconnect the USB to iPhone, the device should then power on.

    Note: If you see the message "Charging... Please Wait" or you see the screen pictured below, let the device charge for at least 10 minutes to ensure the battery has some charge and then start with step 2 again.ht1808_01.jpg
  5. Continue holding the Home button while iPhone starts up. While starting up, you will see the Apple logo.
  6. When you see "Connect to iTunes" on the screen, you can release the Home button and iTunes will display the recovery mode message:
    ts1275.png
    ht1808_02.jpgIf you don't see the "Connect to iTunes" screen, then disconnect the USB cable from iPhone and repeat steps 3-6.

Aug 13, 2009 | Apple iPod touch

1 Answer

Messed up iphone


turn off your computer and make sure to turn off itunes.
turn it back on including itunes, then plug in your phone.
restore your phone using itunes
if you are not using at&t then go to intotheiphone.com and run thier program to unlock your phone to use it with tmobile etc; if not, then just register it in itunes.
Good luck
Justin
please remember to leave feedback

Apr 05, 2009 | Apple iPhone 3G

2 Answers

Restore problem with emergency call display all time


Your iPhone is not factory unlocked. This means if you purchased it from the USA you need a deactivated ATT SIM card to get it past the activation or use a program called QuickPWN to Jailbreak + Activate your iPhone

Feb 11, 2009 | Apple iPhone Smartphone

3 Answers

Restore problem with emergency call display all time


have you tried to reinstall itunes on your pc? it will be the iphone driver that is missing from your pc if you make a bacup of your itunes files in the itunes folder and then re install the most recent itunes from apple this will re install the driver needed to find the phone through itunes.

Jan 27, 2009 | Apple iPhone 3G

1 Answer

My iphone is blocked and only i see on the screen the pineaple pi


I recommend restoring the old non-hacked firmware. To do this, you will need to put it in Recovery Mode, and then iTunes will ask to restore it.

Instructions:
1. Verify you have iTunes 7.5 or later. Apple recommends using the latest version of iTunes.
2. Disconnect the USB cable from the iPhone or iPod touch.
3. Power off the device (Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the the iPhone or iPod touch to turn off.
4. Press and hold the Home button while reconnecting USB cable. When you reconnect USB, the device should then power on.
*Note: If you see the message "Charging... Please Wait" or you see the screen pictured below, let the device charge for at least 10 minutes to ensure the battery has some charge and then start with step 2 again.
5. Continue holding the Home button while iPhone starts up. While starting up, you will see the Apple logo.
6.When you see "Connect to iTunes" on the screen, you can release the Home button and iTunes will display the recovery mode message.
*If you don't see the "Connect to iTunes" screen, then disconnect the USB cable from iPhone and repeat steps 3-6.
7. Click OK, and restore device.

From: Apple Support Article


Best Regards,
Sam




Was this information helpful? Please rate it!

Dec 11, 2008 | Apple iPhone Smartphone

4 Answers

My iphone won't sync with itunes. it did at first but now keeps coming up with an error I have an original iphone, never been jailbroken or any such thing, and can not currently get it to sync with itunes...


Recharge
Make sure iPhone is charged. Connect to a USB port and look for the lightning bolt battery icon in the upper right. If you don't see this icon, then iPhone is not charging. The battery will charge to 80% in an hour.
Note: If you put your computer into sleep mode while iPhone is connected via USB, iPhone may not charge.


This screen means to keep iPhone connected so it continues charging. Please note:
If iPhone is not sufficiently charged it will not show up in iTunes
Use a high-power USB port such as the one on your computer, or use your iPhone AC adapter.
Don't use the USB port on your keyboard because it is a low-power port and iPhone will not charge.
Make sure you are using USB to charge. Accessories that use FireWire to charge are not supported with iPhone.
If you see the red part of the battery image flash three times and then the screen goes black, it means that iPhone is not receiving power to charge.

If the above steps dont resolve follow the following steps :
Retry with a different USB port.
Note:
Don't use the USB port on your keyboard because it is a low-power port and iPhone will not charge.

If the above steps dont resolve follow the following steps :
Restart

Try restarting iPhone. To turn it off, press and hold the Sleep/Wake button until the red slider appears. Slide your finger across the slider to turn off iPhone. To turn iPhone on, press and hold the Sleep/Wake button until the Apple logo appears.

Does iPhone appear frozen or stuck? Try pressing and holding the Home button for at least 6 seconds to close a frozen application. Then try restarting iPhone again.

Note: If that doesn't work, try restarting your computer.
If the above steps dont resolve follow the following steps :
Reinstall

Reinstall iTunes 7.7 or later.
Get the latest version of iTunes (7.3 or later) from http://www.apple.com/itunes/download/

Thanks.

Oct 21, 2008 | Lands Phones

7 Answers

Iphone doesnt detect in Itunes and Usb wall charger doesnt work.


Based on your message it looks like Itunes reupdated the firmware of your Iphone back to the original factory firmware hence it is back to the Locked firmware. When you hit restore in Itunes it will check the Apple website for the correct firmware and load it. You will have to have the phone unlocked again. I would suggest you go to a cellphone repair center and have them unlock the phone again.

Aug 18, 2008 | Apple iPhone Smartphone

Not finding what you are looking for?
Apple iPhone Smartphone Logo

Related Topics:

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Apple Cell Phones Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18384 Answers

Lesley Cameron
Lesley Cameron

Level 3 Expert

371 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you an Apple Cell Phone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...