- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The phone has a predetermined limit on how far your phone can be away from its base. You have to either move the base closer to the phone or move the phone closer to its base. Weak batteries can cause this problem too. Batteries cannot be recharged forever. Replace the batteries with new ones.
Unplug the power and phone cords from the wall outlet and let it sit for 30 minutes or more "the longer the better" This may reset the processor ic back into normal operation, if it fails! the only solution is replace your phone system, because the repair to your phone would not be cost effective.
this depends on what phone you have. most pjones when you open the back of the battery cover, their is a connect button really small. look around the base for a connect button and press the base connect button first, then the phone. after abit they should connect to each other. plaese let me know if this does not work
This is the usual message that the phone gives when the battery has died and it has lost connection with the base unit. The usual fix is to remove and reinstall the battery, then place the unit on the charger for a full charge. This will usually fix the problem that you discribed. If after a full charge, you still get that message, you will most likely need a new battery. Good luck...
/* Style Definitions */
mso-padding-alt:0in 5.4pt 0in 5.4pt;
font-family:"Times New Roman";
Ge Telephone Solutions Handset can not link. • If any handsets become inoperable, place it on the main base
cradle for 20 seconds to re-register. No dial tone • Check or repeat installation steps • Make sure the base power cord is connected to a working
electrical outlet. • Make sure the telephone line cord is connected to the base unit
and the modular phone jack? • Disconnect the base from the wall phone jack and connect another
phone to the same jack. If there is no dial tone on the second phone, the
problem might be your wiring or local service. • The handset might be out of range of the base. Move closer to
the base. • Make sure the battery is properly charged (for 16 hours). • Ensure the battery pack is installed correctly. • Did the handset beep when you pressed the TALK/CALL BACK button?
Did the in use indicator come on? The battery may need to be charged. http://www.home-electronics.net/ge/pc/IB/25922GE2_IB.pdf
Either the phone is not registered to the base unit or the RF module is broken. It could be a bad battery but unlikely unless very old or you have not charged it.
You should check the manual for registering the phone to the base unit.