- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
You have to first diffentiate the power from the speakers. The ORANGE, RED and BLACK are the power. Connect the RED to continuous supply of the battery which is available in the accessories socket, the Orange to the switched power which is also available in this socket. The Black should be connected to the best ground available, check all these using a good meter. Next greys, the greens, one with the red mark on the wire to be connected to the positive of the speaker , the black mark to the negative. repeat this for allthe other wires and test. Now if you think that on balancing to one side the bass is better, reverse one side of the polarity of the speaker.can be the front speakers or the rear. I think you can get this right. Good day
1. Press SRC/OFF and hold until the unit turns off. 2. Press M.C. and hold until CLOCK SET appears in the display. 3. Turn M.C. to select the inital setting. After selecting, perform the following procedures to set the intial setting. CLOCK SET: 1. Press M.C. to display the setting mode. 2. Press M.C. to select the segment of the clock display you wish to set. Hour-Minute As you select segments of the clock display, the selected segment flashes. 3. Turn M.C. to adjust the clock.
usually the wires come with some labels at the end...just follow the labels. You might need to connect the memory wire to a constant 12v supply (not affected by ignition switch). Take note not to reverse the polarity of the speakers or else it would sound dull coz of the low freqs cancellation when wired wrongly. Caution: never reverse the supply polarities too! If you don't have rear speakers you can choose the front speaker connection instead. You might need to to adjust the fader later.
1.Switch OFF the unit 2.Hold the "^" Audio botton (located @ the lower left) for 2 seconds. 3.Select HOUR or MINUTE by using Left/Right arrow. 4.Set the desired time using +/- button. it accourding to manual and works to me when I tested it..
Depends on the type of car you have. Do you have a harness or are you going to splice all the wires? Does your car have a premium sound system? Are you going to run an amplifier now or later on in the future??
if you have a wire harness from the original install then they are 99% of the time just color coded or you can order a replacement manual from there website http://parts.pioneerelectronics.com/model.asp?modelNum=KEH2200QR