Error 1 code now says dry function - Electrolux Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

please tell me how much load you are putting in it

existing error codes for Samsung fridges run from 1 up to 13, in the majority of models as far as I could find out.
You might be having two error codes instead of one code
error 1 and Error 5.
Error 1 refers to 1. Ice Maker Sensor:
Ice Maker sensor connector missing, contact failure, electric wire cut, short-circuit, Ice Maker sensor failure.
Indicates an error when the temperature sensed by Ice Maker sensor is higher than 150 or lower than -58.
Error 5 refers to 5. Ice Maker Function Error:
Ice ejector and level failed three times or more.

1. Press the User Mode key. (Looks like a little man head. Some people call it the function or additional function key.)
2. Press 2 and 8 on the keypad at the same time.
3. Press the User Mode key on the control panel.
4. COPIER Icon
5. Press the Function icon
6. Press the Clear Icon
7. Press the Err Icon
8. Then ok.
9. Exit
10. Power off
11. Wait 1 min.
12. And Turn on machine

clearing error code E000051-0000 in canon IR2200

Try to reset the printer follow this stepTo reset the error

1. Additional functions (push)
2. Function (choice)
3. Error (choice)
4. Error code choice (wait)
5. Reset (push)
6. Right power supply off
7. Right power supply on

Yes! judging by all the cascade break downs, I would suggest replacing the motherboard, HP has a history with motherboard issues.

How to clear the error code:
1. Enter Service Mode: Press * Additional Functions, 2&8 simultaneously, then * Additional Functions again.
2. Then select the [COPIER] option. Under [COPIER], select the Function tab.
3. Under the [FUNCTION] tab, select the [CLEAR] option.
4. In [CLEAR] there is a selection E355-CLR. Select it and hit OK.
5. Reboot the machine.
If the error occurs again:
1. Make sure the connection is secure and tight to the Main-Controller board from the connector cable to the Serial Number board below.
2. Reseat the Main-Controller board into its slot.
3. Go into service mode and clear the error code as explained above.
* If the error still continues, you probably have a bad Serial Number board and it needs to be replaced.

ID sensor error

dirty id sensor-- pull out the drum unit and from the right door clean the id sensor (above the drum)with a dry cloth

Unplug
move ink cartridge to center
remove ink cartridge
knock off the mountain off dried ink where the ink cartridge normally sits

plug back in
press function 7
tel/dial key slowly 4 times
*
1
set
91
set
1 (for off)
set
stop

look in the bottom of the paper tray and push backstop flush up to the paper

CD Changer Error Codes: If problems arise during CD changer operation, the following error codes may appear in the display:
ER-1: No magazine loaded.
ER-2: Problem in the disc loading function.
ER-3: Error in the disc loading function.
ER-4: Error in the disc unloading function.
ER-5: Error in the magazine position.
ER-6: Error in the laser pickup position.
ER-7: Error in the laser focus on the disc.

The error is being generated because you are trying to order on a value not in your selected fields e.g EFFECTIVE_DATE

You only have TRANSACTION_TYPE in your select statement