An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.
Re: Machine Error 8460N Laser Printer
To get the machine error code
Get into maint mode
Within 2 seconds hit:
This will put you in maint mode.
This will give you the machine error code.
press 99 to exit maint mode.
Let us know what the machine error is.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
You might try taking out the fuser and replacing it. First of all, I'd let the machine sit for at least 30 minutes if you've recently printed anything, as it needs time to cool down. After that, press the button on the upper right side of the device to release the cover. Then release the chute gate to its upright position. Release the two tabs on each side of the fuser to unlock the unit and slowly pull it out of the machine. To replace it, push the fuser connectors into the slot firmly to make sure it is properly seated . Lastly, close both of the levers you opened earlier to remove the fuser. Make sure the chute is also lowered to the position it was in before. You can then close the front cover. Hopefully that will resolve all your printer issues. If not, you may need to contact a support technician. Good luck!
Hello - This is a good question.,. and you have got me stumped! What I would do is contact the manufacturer's tech support line, they would be far better suited to provide a more accurate answer... Best regards, Ck
THIS IS HOW YOU WILL RESOLVE YOUR ISSUE OF REPLACE PF KIT1 ON UR Brother MFC-8460N All-In-One Printer
1) Turn off printer 2) Press and hold menu button and turn on. Keep holding button until you see maintenance on display. 3) Press 88. This brings up parts replacement menu. 4) Press Up arrow until you see the part you replaced (laser, fuser, pf kit1, pf kit mp). 5) Press the OK button. 6) Power off and restart printer
THIS WILL DEFINATELY RESOLVE THE ISSUE
REPLACE PF KIT1 : THIS IS IN REGARDS TO THE MAINTENACE DISPLAY THAT YOU HAVE ON YOUR PRINTER
TAKE CARE AND HAVE A NICE DAY..
You may need to clean the cartridge contacts, but usually if you reset the printer you can clear this false error message. See detailed instructions here. (Make sure you change the cartridges with the machine ON.) If the cartridge should actually pop out, see here.
I hope this information allows you to resolve this issue. If you need further assistance, please post back with a comment to this thread. If I've managed to answer your question or solve a problem, please take just a moment to rate this post....thanks!
ithink . brother printer is best, we can always reffil untial drum isnot scarch, some time drum life is endinging as u say iit can be reset . after this we get 100% life. there is no need cheap and tools for reset it. reffiling before we reset cartage by adjusting cartage sides white ring. and we can also reset reffiling after . this treak is secre to tech.
The fuser oil sits on top of the fuser and has silver contacts on it. Sometimes the contacts in the machine get bent. Turn off the printer and check the contacts and if bent use needle nose pliers to make straight again. Make sure the contacts on the fuser oil are not drity.