Question about JVC KD-S6060 CD Player

1 Answer

EJECT? LOAD? Device will not eject the disc .READ. >>HELP<<

I need help... My JVC KD-S6060 Car CD Player has a problem. I let the battery run down on my corsa to flat... i manage to get some one to jump it for me but as they were doing so they accidently crossed the - + leads and had a bit of a spark... then correct them selfs. I Start the car I Run the car for a while to recharge my battery... After the car had started the cd player was playing the current cd. No Problem.. A day or so later i decide to change the CD in the device. I Push eject.. It says EJECT For 1 second but does nothing..other than kick me out onto radio. does not eject the cd... I have tried Using these methods but no luck. Hold CD and EJECT for 2 seconds - Says eject but does not Hold ATT and EJECT for 2 seconds - " " DOES ANY ONE NOW THE PROBLEM OR A FIX Have i possible sent a current into a motor or chip inside and need to replace parts. Can i possibly reset the whole device to resart it?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 156 Answers
Re: EJECT? LOAD? Device will not eject the disc .READ. >>HELP<< - JVC KD-S6060 CD Player Car Audio Receivers

Hold ATT, SEL and EJECT.

Posted on Jun 16, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Newly installed in a camper from the leisure battery,power to the unit and will load the cd then the unit goes dead.Press the eject button and the unit illuminates and ejects and again goes dead

Do you have power going to both the red and yellow wires? The red wire generally goes to a switched power source and the yellow should be constant. Both wires need to have power going to them in order for the unit to work properly.

Nov 01, 2011 | JVC KD-S6060 CD Player

1 Answer

The CD does not want to eject. Any sollutions?

try either pressing the reset switch if there is one, or disconnect power to the radio for an hour or so.

Aug 31, 2010 | JVC KD-S6060 CD Player

1 Answer

Six disc changer will not play, eject, or load. making eject noise nothing happens.

it sounds like the photo sensor has failed this unit detects disc and loads them if it blows it thinks it has a disc and will try to eject it over and over

time for a new stereo sorry

Jun 25, 2010 | JVC KD-G110 CD Player

1 Answer

My cd won't eject. the car recently had the altenator replaced and everything in the car was reset. could this have affected the cd player?

Some players get set to a default like when it was fresh out of the box when power is removed. Since you radio from the factory knows there is no disc in it, it thinks there is nothing to eject. Push the reset button and your disc should eject.

Jun 20, 2010 | JVC KD-S6060 CD Player

1 Answer

6 discs in system, won't play or eject

take it manually by opening the unit

Jan 20, 2010 | JVC KD-G110 CD Player

2 Answers

Jvc kd-sx770 car stereo--radio works, but cd player doesn't

Hello beeswing70,

The player is recognizing that a CD has been inserted but is not able to read it.

Sometimes the lens assembly becomes contaminated and obscures the laser. I'd try using a commercial "lens cleaning CD" two or three times and then try a CD again. These lens cleaning CD's are widely available. If cleaning does not help, the player need professional service.

Hope this helps.

May 25, 2009 | JVC KD-SX770 CD Player

1 Answer

Jvc kd lx111 deck wont eject cd

I just had this problem today and when I attempted to eject the CD it would give me an error message that stated (ERR 32). Apparently this means that there is something blocking the movement of the screen, a little manipulation should help the issue. Another variable could be the Eject lock feature, essentially a "child lock" for your disc. When this lock is activated it prevents the CD in the deck to be ejected. You can change this by holding down the blue source button and the eject button simultaneously for about 2 or 3 seconds. A message should appear saying "No Eject" and one that repeatedly flashes "Eject on" These two things seemed to help me alot when I had this issue. If those things don't work I would recommend calling JVC, much to my suprise they were actually really helpful. Their number is 1-800-252-5722.

Nov 07, 2008 | JVC KD-LX111 CD Player

1 Answer

My JVC KD-G331 Cd Player Won't Work In My Clio (X reg)

Hi, did you fix this problem?
I'm having exactly the same issue myself.

Jul 03, 2008 | JVC KD-S6060 CD Player

Not finding what you are looking for?
JVC KD-S6060 CD Player Logo

516 people viewed this question

Ask a Question

Usually answered in minutes!

Top JVC Car Audio Receivers Experts


Level 3 Expert

93922 Answers

xxxxxx xxx

Level 3 Expert

4679 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a JVC Car Audio Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides