Question about Samsung SyncMaster 743N/743NX,SyncMaster Magic CX743N

1 Answer

Samsung sync master 743nx power on only 3 sec then fade what is the problem then?

My samsung sync master 743nx problem is when i plug it, it power on but for only 3-4 secs. but the power blue light still there. someone can help me solve the problem. i know little bit about basic electronix but i don't know where to pinpoint the problem.pls help for GOD will help you too when extending help to someone like me.GOD BLESS...

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 236 Answers
Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Samsung 920nm sync master Black screen


Samsung sync master monitors were well known for bad capacitors, if you have a esr capacitor meter you can check in circuit, if not look for dome shape at the top of the capacitor, a dead give away it is open, also check for poor solder connections in the power supply inverter board area.

Jun 20, 2012 | Samsung Computers & Internet

1 Answer

How do you turn the samsung hm3700 bluetooth on? How do you snyc it to your phone?


To turn on the Samsung HM3700 headset, slide the power switch up. (You can see it's location on the image below). The indicator light below the power switch will blink blue 4 times (purple or red means your battery is low). If it stays blue it is ready to sync with your phone.2_29_2012_5_42_10_pm.jpgThere are 3 ways to sync this device to your phone:
  1. Once the headset is on, hold down the talk button for 3 seconds. (the blue light will stay lit for 3 minutes once you enter pairing/syncing mode).
  • Activate Bluetooth on your phone and search for the hm3700 (keep them close to each other).
  • Select the headset and enter a PIN number if asked.
2.) Active Pairing: Once you have held down the talk button for 3 seconds and the blue light is on, press and hold the talk button again to make the blue light purple.
  • The device will try to automatically connect to your phone for 20 seconds. Your phone should not be connected to other Bluetooth devices during this process.
3.) FreeSync is an application you can download if you have an Android (from the Android Marketplace). It allows you to access your headset settings and I believe it can read your text messages for you (text to speech).
For more information the user manual for your Samsung HM3700 Bluetooth headset can be found here: http://downloadcenter.samsung.com/content/UM/201111/20111116163119314/HM3700_UM_America_B_Rev.1.0_110923_screen.pdf

Feb 29, 2012 | Samsung Cell Phones

1 Answer

When I power on my I-Inc Ic194D, the blue does come on, after 1 or 2 secs, the screen will blink with white light and it will blink every other 1 or 2 secs. Nothing shows up. Can someone help?


Make sure the DVI or VGA cable is securely plugged into both the computer and monitor. If this doesn't work, try plugging the monitor into another computer. If it works when attached to a different computer, then the issue lies with the computer and not the monitor.
Good luck. Please rate if this was helpful.

Mar 02, 2011 | Computers & Internet

1 Answer

Need diagram info for master and slave driver


The BIOS is AMI. Under ADVANCED SETUP:
The options listed for 1st,2nd ,3rd Boot device include:

IDE-0 means Pri master ?
IDE-1 means Pri slave ?
IDE-2 means Sec master ?
IDE-3 means Sec slave ?


hope this helps

Dec 06, 2010 | Samsung TS-H492 (TSH492AWRBH)...

2 Answers

I have a wii fit board, when you power it up, it


Had the same problem. It's a sync problem.
First, best to double check you have fresh batteries.
Next, turn the board upside down and remove the cover from the battery compartment.
Open the small hatch cover on the front of your console unit.
Now start wii fit from the disk menu item.
Next, press the small red button inside the balance board battery compartment. The blue lights will blink for approx 3=5 sec.
While they are blinking, press the red button on the console (in the hatch compartment).
This should re-sync your board and the light stays lit.
Good luck.

Apr 07, 2010 | Nintendo CTA Digital WI-BBP Wii Fit...

1 Answer

My samsung monitor syncmaster 743nx is not turning on..plss help me...tnx


How to troubleshoot a Samsung SyncMaster 743NX LCD Monitor? My Samsung SyncMaster 743NX monitor turns on slowly. I mean,last week when I started up my pc,it took 5-10 mins before my monitor displayed anything. I know the pc is already turned on because I've already heard the Windows Vista start up tune play. The problem is now getting worse as it now takes 20-30 mins before my monitor displays anything. Please help.

Mar 11, 2009 | Computers & Internet

4 Answers

I just bought the hfblu-10k bluetooth headset today. i followed instructions to sync it with my lg vx5300 verizon phone and my phone was unable to detect the headset. i also tried syncing it with my acer...


I was given this bluetooth after a buddy of mine could'nt figure it out. I figured out how to sync it by following that longer than 5 secs. idea that's posted here. I did'nt have a manual so I just put in "0000" and it worked! So try that...Good Luck. Thanx4Hating

Nov 27, 2008 | Cellular Innovations HFBLU-CX1 Wireless...

1 Answer

Scratching noise in SyncMaster 743NX


But if that happens without having it connected to a source/device its on the main board of the monitor that you are having an issue with

Apr 06, 2008 | Computers & Internet

2 Answers

Won't pair with my Samsung mobile phone


I too had trouble pairing with my phone. Here's what worked for me:
Just make sure when you're first syncing this to your cell phone, hold the main button for a REALLY long time. NOT till it flashes (keep on holding it). It will eventually go from flashing to a SOLID blue light, and that's when you sync. It'll probably take like 30-60 secs of holding.

Mar 27, 2008 | Samsung WEP200 Headset

Not finding what you are looking for?
Computers & Internet Logo

297 people viewed this question

Ask a Question

Usually answered in minutes!

Top Samsung Computers & Internet Experts

Ekse

Level 3 Expert

13434 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18429 Answers

asber

Level 3 Expert

296 Answers

Are you a Samsung Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...