Question about Samsung HL-R4266W 42" HDTV-Ready Projection Television

1 Answer

Samsung tv wont come out of standby

Samsung tv LE32RE74Bd just over two years old was working fine this morning switched off tv using button on it when came to switch it on tonight all we get is the standby light continually flashing. No picture no nothing. Have tried switching it off at mains still does the same when plugge in to mains. Is this likely to be a costly repair?

Posted by on

  • 1 more comment 
  • john289 Jan 24, 2009

    Well almost the same. When switching on using either the remote or set button, the standby switch clicks for about 3 minutes before we eventually get a picture

  • eadnus Mar 08, 2009

    Two week ago, my 3 years old Samsung LN-S4041D/XAA 40" LCD TV has to wait 10 min to have a picture after I turned it on. One week later, it didn't have a picture at all, no matter how long I’ve waited. My TV is connected to the DirecTV box and the Sony home theater system. I can hear the sound from the speaker but no picture. The stand-by light was turning on and off itself until I unplug the power. The same problem occurred again when I plugged it back. Would it be the problem with the TV, DirecTV remote, or anything else? The TV price has been dropped dramatically. Is it better to buy a new one than fix it?

  • Anonymous May 14, 2009

    When switching Samsung Tv on keeps switching to stanby for about 45mins then will eventually come on

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 98 Answers

Not expensive but very hard to find the exact problem.

Both are not the same problem.
Mostly, your case related IR module problem.

the other below, yours are poewr board or thermostat problem.

Posted on Mar 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sony kp41s5u rear projection tv constant blinking standby


Power supply or set is not allowing set fully on as a problem in any of a number of areas in the set. Try unplugging set for a while to see if that helps or have a tech look at it.

Dec 23, 2012 | Projection Televisions

1 Answer

Won't turn on


Possible there is a problem with your power button try to check it if it is still functional. Read light means standby power meaning your TV still working. If you cannot do it by yourself fixing it try to bring your TV at your nearest TV shop to check the power button.

Hoping for your kind approval to make my rate Solved for this problem.


Best regards,


Philip

Nov 15, 2007 | Panasonic PT-43LC14 43" Rear Projection...

1 Answer

Sony KL-50W2U rear projection TV stuck in standby


Try holding down the power button until it turns off and then turn it on again.

Nov 29, 2012 | Sony KL-50W2U

1 Answer

My Samsung HLR5067 was working fine last night. I left the house open and it dipped in temp (only to 40 degrees or so though)...Woke up this morning and it wont turn on at all. Just beeps a few times,...


Tv projection Lamp might be some how the causes again.Tries unplug,replug tv back like about an hour later.Try it again,should work now.If not,yes the projection lamp,might have been kill by the cold weather.

Dec 06, 2010 | Samsung HLR5067WX 50" Rear Projection HDTV

1 Answer

Samsung 50" r p tv switches off


Replace your Lamp BP96-01073A Fox has them $109.00 1-800-227-5369

Dec 29, 2009 | Samsung HLN5065W 50" Rear Projection...

1 Answer

Samsung 50" rear projection tv switches off after a few seconds


probably need to replace the Ballast and Power Supply Board. If lamp has not been replaced, I would replace that too. can call 1-800-samsung for nearest service center.

Dec 29, 2009 | Samsung HLN5065W 50" Rear Projection...

1 Answer

I have just bought a new wide screen Samsung TV but I can't work out how to switch it off completely. It always goes into standby mode


Have you tried pressing the standby button, and then the on/off button afterwards? Sometimes they need combinations of buttons, to work. It happened to me. I dont know if it will, but i hope this helps! :-)

Jul 24, 2008 | Samsung Projection Televisions

1 Answer

Samsung rear projection problem


sounds like you may need a new lamp.about 150.00 to 200.00$

Jan 19, 2008 | Samsung HLN5065W 50" Rear Projection...

Not finding what you are looking for?

Open Questions:

See all Samsung HL-R4266W 42" HDTV-Ready Projection Questions

Samsung HL-R4266W 42" HDTV-Ready Projection Television Logo

262 people viewed this question

Ask a Question

Usually answered in minutes!

Top Samsung Projection Televisions Experts

The Wyzzyrd

Level 2 Expert

83 Answers

Donald Griswold
Donald Griswold

Level 1 Expert

8 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

Are you a Samsung Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...