Question about Fagor LFA-65 IT Dishwasher

1 Answer

7 BEEPS!!!!!!!!!!! Hi, I have a problem with my Fagor dishwasher - Model LFU 65IT. When I tried to switch it on tonight, it wouldn't start and then it beeped seven times. I consulted the manual and the troubleshooting section says "temp no detect" - something to do with the temperature sensor apparently but it doesn't say what. Any ideas please?

Posted by on

1 Answer

Re: 7 BEEPS!!!!!!!!!!!

Please contact the Fagor America Service Center toll free: 1-877-743-2467. A customer service representatives will discuss the problem with you. If on-site service is required, they will coordinate that for you.

Posted on Jun 22, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

How to clean between glass in oven door

split the door carefully and wash it . dry really well before putting halves back together unless you do not care if it explodes when used.

Mar 19, 2016 | Fagor LFU-45IT 18 in. Built-in Dishwasher

1 Answer

My Fagor dishwasher di not finish the cycle and has water in the bottom of the machine which has not drained. Now it will not start and just beeps. How can I drain the water and get it to start and fu

A small amount of water in the bottom is normal (it allows the pump to be pre-primed). Do not remove the water (as long as it is only a little in the center well).

Nov 03, 2014 | Fagor Dishwashers

1 Answer

Fagor dishwasher not completing cycle showing f6

The heater or thermostat is faulty and not allowing the dishwasher to complete cycle as water is not getting hot enough. Try to run a cold or short cycle and see if is completed.

see explanation of fault codes in this manual.

Sep 21, 2014 | Fagor Dishwashers

1 Answer

Fagor dishwasher showing f6

Please check fault codes on page 70 in this manual.

F6 would mean the water is not getting heated. I am not sure which model you have but if there is only a cold water inlet connection then either heater or thermostat is faulty. If you have both hot and cold water inlet then you may have to check if hot water is getting in at right temperature. Easiest way to confirm is to run dishwasher in cold cycle (short rinse) and see if it goes through. The heater would get used in warm/ hot wash cycles and drying.

Sep 19, 2014 | Fagor Dishwashers

1 Answer

Why does my fagor dishwasher stop mid cycle and show f 6 with several beeps

I have already provided answer to a later post on this topic. Heater problem.

Sep 19, 2014 | Fagor LFA-013 Stainless Steel Built-in...

1 Answer

Fagor LF 65IT beeps 4 times a few minutes after switching on and all lights flashing on display

This is a flood warning. You must have water in the bottom of your machine which has raised the float and activated the flood switch. Open the lower front panel on your machine and for where the leak is coming from.

Apr 03, 2012 | Fagor LFA-65 IT Dishwasher

2 Answers

Fagor dishwasher LFU-65IT, when switched on it sounds 9 beeps. have referred to manual which indicates that 9 beeps means "not even" please explain

Hello, mh

I was trying to help you out here. Maybe this will help some? I was going back to some customers that asked questions in the past and it appeared that no one answered them, so I thought I would take some of my personal time to see if I can help. Even though this site may not have your exact model or brand, This link will help you tons. Here is a link to about everything you want to know about your dishwasher, from repair to trouble shooting it,pictures, video's. Just scroll around and you will see tons of information to almost any question you might have on your dishwasher. If you go to this link and click around, I am sure you will find out so much about your dishwasher, you will know more that the company that made it. Here Is the link for you to click on>>

Please if this helped you at all, if you can find the time to rate my help and some kind words written would be appreciated for my free help , I would appreciate it. Here is also my direct link to my own pages of other areas of my expertise for other problems you might have in Automotive,Appliance, and Electronics. Drop In anytime for my help. Thanks,Mike

Aug 26, 2011 | Fagor LFA-65 IT Dishwasher

1 Answer


Check the plug and the electrical lead for continuity first, and check the fuse again ni case that has blown again because of an electrical fault.

Jan 16, 2011 | Dishwashers

1 Answer

Beeps eight times

Correct - lack of water pressure at the dishwasher, not the same as whether there is pressure from the line going to the dishwasher. There may be a clog or a valve that is closed.

Nov 21, 2007 | Fagor LFA-65 IT Dishwasher

Not finding what you are looking for?
Fagor LFA-65 IT Dishwasher Logo

Related Topics:

1,128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Fagor Dishwashers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

 Robert Marsolais
Robert Marsolais

Level 1 Expert

25 Answers

Are you a Fagor Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides