An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 20 times.
An expert who has answered 20 questions.
Re: the front right side of the screen is flickering
Its a lil pricey but its actually an issue with the faceplate...the display has to be replaced.Its a common problem on the pioneer decks with the motorized faceplates. look on ebay for just a faceplate.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The following will help you out. The first is for the vehicle and the second for the stereo. Good Luck.
Left Front (+)
Left Front (-)
Right Front (+)
Right Front (-)
6" x 8" Side Panels
Left Rear (+)
Left Rear (-)
Right Rear (+)
Right Rear (-)
it may have a connection problem(flexible strip) to the PCB that has dislodged, or the display itself has developed a problem. Couple of questions, is it entire characters that are missing, or parts of same. Is the unit still operating normally?
Hit me back here and we shall get to the bottom of your problem.:)
All name brand radios have a standardized color codes coming off the harness.
Yellow- Constant Black- Ground Red- Switch power Blue- Antenna Blue/white- Amp turn on White- Left front + White/black- Left front - Gray- Right front + Gray/white- Right front- Green- Left rear side Purple- Right rear side.......the black stripes are your negative speaker outputs.
Here is the solution:
There are a series of surface mount resistors in the front right corner of the main board on the top side of the board. Front right while facing the unit looking in. Those surface mount resistors need to be resoldered, they are heat stressed. If you know how to solder, go ahead and do it. If not, I adise you to take it to a shop to have them reflowed. There are a line of them all in series with each other in that right front corner of the main board. That is the only way to fix this problem, have the solder reflowed.
The problem is not the faceplate for any of you, it is inside the main unit. If you know how to solder, you can fix is very easy. First take the top off the unit, there is 1 screw in the back middle. Then take the CD player out. It has 2 screws holding it in at the front corners at the bottom of the CD deck. Use a number 2 phillips and take out the gold screws holding the CD deck in place. Then you can pull out the CD deck, and be careful not to damage the ribbon cable connected from the CD deck to the main board. The deck can just sit up and over to the left to get it out of the way for what needs to be soldered.
Look inside the main unit on the board and you will see in the front right corner a series of surface mount resistors all connected in series. Just reflow that solder on them with a small amount of new solder added and the display will once again work perfectly. That solder is very heat stressed, that is the problem. I have fixed dozens of these over the last few years. Make sure you put it back together the same as it came apart, and you are done.
there are two screws on left and right of display on the arms that it flips . take them out and you can slip it off now the ribbon is probably bad so dont be suprised if it tears when you try to remove it . they are such a tight fit i doubt if the connection is dirty they break from the constant bending ..