Question about Pioneer SD-P50A5-K 50" Rear Projection Television

3 Answers

I have a pioneer p5073k it comes on then goes off

After a couple of months nothing now

Posted by on

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

I had the same problem it was IC2601 STK4274 I also purchased a set of service manual I can share with you
czecha@hotmail.com

Posted on Oct 24, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Need to program channels that don't appear?

Posted on May 24, 2009

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

I would check your maine power fuse I ran in to this problem and found my main fuse problem needed to be pinched together to make it tighter no problem since make sure you have the right fuse the only other thing ie un solder the regulator clean it off and re solder this is common in these set's hope this help's rocky

Posted on Jan 24, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Pdp433-pg pioneer display which media receiver ?


give Tops Electronics in Haverhill Ma a Call they had a couple in stock about a month ago 978-374-9877 158

Dec 10, 2009 | Televison & Video

1 Answer

TV picture goes out after 10 minutes of viewing with popping sound


It can be a couple things. Something bad on the power board. Or the vertical output circuit. How long ago did you purchase the television. Your best course of action is to have it serviced.
If you need any information or other assistance let me know.
Thanks,
Lee

Jun 24, 2008 | Pioneer SD-582HD5 58" Rear Projection...

1 Answer

Sony TV goes to standby - constant red light


The Power Supply has gone. It needs replacing.

Jan 04, 2009 | Televison & Video

1 Answer

51mp392h/17 Magnavox video goes out after a few but sound works


More than likely the SSB board. Part# 313912725871 cost around $200.00 or more. Plugs into the signal board on it's edge like memory in a computer. The only thing is these sets are junk, and this is just the beginning of your problems. Don't waste your money on fixing this set. They don't hold up to repair. Trust me on this, been fixing sets for over 20 years.....my full time job. Buy a Pioneer,Panasonic,Hitachi,Sony or a high end Sharp WITH an extended warranty. Nothing lasts anymore, but with the above sets, you have a chance of it lasting a few years and getting service if needed. Otherwise the other sets are disposable....no parts available. NEVER buy China made anything!!!! You might get 6 months, then it's ready for the junk pile. No service,No parts, No nothing.

Dec 22, 2008 | Philips Magnavox 51MP392H Rear Projection...

1 Answer

My sd-533hd5 keeps blowing the 5 amp 125v fuses


Yes! it sounds like a power supply problem! or the flyback in the main board needs replaced ( part is in the $70.00 range

Dec 12, 2008 | Pioneer SD-533HD5 53" Rear Projection HDTV

1 Answer

When i turn the power on it looks like the tv is going to come on but the lamp lite (on display) blinks and then goes out. the screen takes a little bit of a glow but no picture. all display lamps go out...


The place you purchase the set from has to help you or guide you in the right direction so you get the set service, if they dont tell them you will bring the setback to them for a refund or exchange,the manufacture is the responsible one but stores also have something to do.

Oct 01, 2006 | Samsung HL-R7178W 71" HDTV

1 Answer

Problem with board


Problem is theres several boards inside this set and it may not be the same repair. Even if it was a shop cannot warranty a set for more then the manufacturer warranty's the boards. They , the manufacturers only warrantee these boards for 90 days. Its just something that happens .. Its not planned or anything. When was repairing pioneer sets I ran into this situation all the time. As a matter of fact with any projection set I ran into this situation. Its like if you take in your car for brakes, then a month later the water pump goes bad, is the mechanic going to fix the water pump for free?? I think not! Its the same thing as there are hundreds of parts in a TV set, and just because you replace a few of them , you can not garantee all of them. See my point?? Good Luck

Jul 28, 2006 | Pioneer SD-532HD5 53" Rear Projection...

Not finding what you are looking for?
Pioneer SD-P50A5-K 50" Rear Projection Television Logo

Related Topics:

445 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pioneer Televison & Video Experts

The Knight
The Knight

Level 3 Expert

69718 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

6364 Answers

Are you a Pioneer Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...