Question about Jenn-Air SVE47100 Slide-In Electric Kitchen Range

1 Answer

Jenn air mod. # sve47100 oven not heating

I was baking at 450 then it stopped heating. I checked continuity on both elements, they were good. Every thing else works.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Jenn-Air Master
  • 2,118 Answers

When you checked the elements for continuity did you remove at least one of the wires off of it,if not it will check good.if the elements are good,unplug it,pull it out and remove the back wall so you can get at the wires,plug it back in and make sure you're getting 240 volts to the bake element and 120 volts to the broil,if you have 240 volts coming to the machine at the plug and you don't have 240 at the bake element check for broken wire,if wires are good you have a bad clock assy. the relay on the computer board is bad and you'll have to change out the clock assy. unfortunitly you can't get this clock anymore but you can send it out to have it rebuilt,go here and get info,hope this helps
http://www.repairclinic.com/PartDetail/Oven-Control-Board/71002331/695629

Posted on Dec 12, 2012

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

protek480
  • 1714 Answers

SOURCE: My Jenn-Air SVE47100 slide in electric range does

Obviously it does not work fine. The thermostat sensor or the stat itself could be an issue. Can you see the sensor 'bulb'? Clean it with oven degreaser and steelwool. What is the temp in the oven with a 'oven thermometer'? Is this consistent with the oven readout?

Posted on Sep 24, 2009

localwonder
  • 6784 Answers

SOURCE: F1 fault code? Jenn-Air SVE47100

HI. This is concerning the relay board that is installed in your unit. I would recommend to inspect the entire wiring harness that is linking the relay board to the elements, and other power component's. If the harness is ok, and connected tightly, and correctly, this will confirm that the relay board has failed. It must be replaced in the case. Be sure to inspect all wiring harness connections for corrosion before you replace the board. This could be as simple as a failed connection.

PRB Part Number is #71002144




Posted on Nov 14, 2009

t955i
  • 30 Answers

SOURCE: Jenn-Air SVE47100 Oven Won't Heat

are you still getting power to the oven? breaker ok? there may also be a fusible link somewhere on the circuit

Posted on Nov 21, 2009

  • 842 Answers

SOURCE: bake element burned out on

HI,
You should have 120 to the element when not in bake mode, while in bake mode you should have 220 - 240 volt. Sounds like you lost a relay to send the additional power to the element, or you have a High Limit thermostat which could be open. This is a safety device to protect the unit from over heating, this only goes if temperatures increase higher the safety levels, normally set about 200 degrees or so along the air flow channels. I would trace from the elements to the clock and find the missing source of current.
I hope this helps
Be safe with electricity......

Posted on Jul 26, 2011

Testimonial: "Perfect! it was the high limit thermostat.Thank You for your help"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bake element burned out on my Jenn-Air SVE47100 Slide-In Electric Kitchen .I replaced it but oven does not heat ,when i turn oven on and check each terminal of bake element (and broil element)from ground i...


HI,
You should have 120 to the element when not in bake mode, while in bake mode you should have 220 - 240 volt. Sounds like you lost a relay to send the additional power to the element, or you have a High Limit thermostat which could be open. This is a safety device to protect the unit from over heating, this only goes if temperatures increase higher the safety levels, normally set about 200 degrees or so along the air flow channels. I would trace from the elements to the clock and find the missing source of current.
I hope this helps
Be safe with electricity......

Jul 26, 2011 | Jenn-Air SVE47100 Slide-In Electric...

1 Answer

My oven doesn't bake properly. Everything takes extra long to cook and even when I give it extra time the food usually isn't baked all the way through.


Hi,
If your electric2_bing.gif oven is not heating then you probably have a bad heating element in your oven. This is not that hard to fix yourself...
Check out this tip that I wrote about the Oven not heating problem..

Oven Problems Electric2_bing.gif Oven is Heating Slowly or Poorly
http://www.fixya.com/support/r4511800-oven_problems_electric_oven_heating

heatman101

Aug 11, 2010 | Jenn-Air SVE47100 Slide-In Electric...

1 Answer

Jenn-Air SVE47100 Oven Won't Heat


are you still getting power to the oven? breaker ok? there may also be a fusible link somewhere on the circuit

Nov 21, 2009 | Jenn-Air SVE47100 Slide-In Electric...

1 Answer

Baking element replaced but still won't heat


you may have triped half your 220v breaker. (you should have shut it off when reparieng wire or it would have been live and zaped you) Or something in line with the wire that shorted blew out like a fuse in the range.

Nov 21, 2009 | Jenn-Air SVE47100 Slide-In Electric...

1 Answer

My Jenn-Air SVE47100 slide in electric range does


Obviously it does not work fine. The thermostat sensor or the stat itself could be an issue. Can you see the sensor 'bulb'? Clean it with oven degreaser and steelwool. What is the temp in the oven with a 'oven thermometer'? Is this consistent with the oven readout?

Sep 24, 2009 | Jenn-Air SVE47100 Slide-In Electric...

1 Answer

My Jenn air SVD48600P heating element dose not heat


Hi. I believe this info. may assist you in getting your bake and broil up and running:

When your heating element burns out, you have to replace it because they are not repairable. If, when the heating element burns out, the infinite switch that controls it also fails, you have to replace it too.

May 31, 2009 | Jenn-Air SVE47100 Slide-In Electric...

2 Answers

I HAVE A JENN-AIR SVE 47100 IT STARTED TO PRE-HEAT AND STOPPED AT 140 DEGREES NOW IT WONT GO OVER 100 DEGREES BROIL OR BAKE ELEMENTS NEITHER IS GETTING HOT CHECKED HI LIMIT IT'S OK NO TROUBLE CODES JUST NO...


Probably relay control. I have similar problem.
Best estimate I have had is $300, relay control circuit board, Part #12001689 costs $225.
I am getting a NON Jenn Air. Repair record not so good.
Check Consumer Reports

Feb 26, 2009 | Jenn-Air SVE47100 Slide-In Electric...

1 Answer

Sve47100 oven doesn't heat


Some times a company changes vendors for the controls and connections change location. But does the wiring diagram indicate a relay board in the back of range. It could be damaged form the element short

Jan 03, 2008 | Jenn-Air SVE47100 Slide-In Electric...

1 Answer

Bake oven element blew


Could be the oven selector switch or the thermostat that failed form thhe element shorting out. You will have to have a ohm meter to check these

Dec 15, 2007 | Jenn-Air SVE47100 Slide-In Electric...

Not finding what you are looking for?
Jenn-Air SVE47100 Slide-In Electric Kitchen Range Logo

383 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jenn-Air Kitchen Ranges Experts

Mike Carew

Level 3 Expert

969 Answers

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

 Fix Your Board
Fix Your Board

Level 3 Expert

310 Answers

Are you a Jenn-Air Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...