Question about Kenmore Elite Oasis 27052 Top Load Washer
The F1 error code indicates either that the pressure signal is out of range or the pressure hose is blocked. This
would mean that the control board is defective or the pressure hose is
pinched or blocked somewhere between the control board & the outer
tub. You can check the pressure hose by removing the rear panel &
looking where the drain hose is coming out of the back of the cabinet.
Posted on Jan 13, 2009
Try replacing the motor coupler between the motor and pump three small pieces about 18.00 dollars at sears parts store.
Posted on Feb 04, 2009
Tips for a great answer:
Aug 21, 2011 | Kenmore Elite Oasis 27052 Top Load Washer
Thank you for your question.
The F1 fault code on this washer indicates that the water level pressure transducer signal is out of range. The pressure transducer air hose tubing being pinched or crimped can cause this. A failed pressure transducer on the machine control board can also cause it.
The first image below shows the method for accessing the pressure transducer tube that runs from the bottom of the washer tub to the machine control. I recommend checking this air hose for pinches, twists or crimps.NOTE: Be sure to unplug the washer to disconnect electrical power before accessing internal components.
If you find no problems with the pressure transducer tube, then the machine control board will need to be replaced. The procedure for accessing and replacing the machine control board is shown in the second image below.
Jan 09, 2011 | Kenmore Elite Oasis 27052 Top Load Washer
Nov 19, 2009 | Kenmore Washing Machines
May 29, 2009 | Kenmore Oasis HE 27082 Top Load Washer
Apr 25, 2009 | Kenmore Oasis HE 27082 Top Load Washer
Jan 31, 2009 | Kenmore Elite Oasis 27052 Top Load Washer
Jan 13, 2009 | Kenmore 23822 Top Load Washer
Nov 18, 2008 | Kenmore Oasis HE 27087
Aug 02, 2008 | Kenmore 22422 Top Load Washer
398 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: