An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 20 times.
An expert who has written 20 answers of more than 400 characters.
Re: front and back wipers are not working
Have you checked wiper fuse? start simple get a 12v light tester and open up cowl to access wiper motor then check if power is getting to wiper motor if isnt check and replace fuse, if persists replace wiper relay, then check to see if power is getting to wiper motor if it is and still no wipers you need wiper motor its simple start at fuse check it then move to relay check it and move to wiper motor check it and your done!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
As far as I know, your sound will drastically improve if you run them +- and +-. Connect the one speaker correctly (+-) and then with the music still playing, try swapping the wires on the other speaker around and see which sounds better + to + or + to -
Hope this helps
I would try using an electronic cleaner on the pot(s) to see if that helps. Many times either the surface of the coil, the wiper, or both become contaminated with excessive residue and fail as you describe. Shaking it or moving it quickly sometimes removes enough of the contamination for it to temporarily function again. But if you clean all of the gunk off, it will work like new. Try this inexpensive Radio Shack product. If it doesn't fix the problem, you'll need to replace the pot.
Hope this helps. If it does, please rate as "FixYa".
Possibly you need to return the amp and get a new one cause that could mean an internal problem and its deffective, you could try replacing the fuses or try changing the ground wire, this problem is very unusual
Initially what can be suggested is to try and redo the fuse insertion again but wiggle them a bit when installed. It might also be of help if you spray the insertion points or fuse clips with an electronic contact cleaner prior to reinserting the fuses. In some instances, the fuse clip/holder need to be manually scraped for corrosion or grime/dirt. It is also possible that a wire might have been dislodged that leads to the wiper motor.
switch off the amp then take off all the wires off including the speaker wire and then reconnect the wires on like before the problem is that the amp is on protection and if that dont work then get it repaired another thing is make sure ur amp fuses havent blown.