Question about Homedics Health & Beauty

Open Question

Homedics lithium electronic scale SC315 shows Err after changing battery.

When I changed the battery, keep getting Err message.

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: electronic bathroom scale lithium battery spent

I had a problem changing the battery too. I just couldn't get it out and was afraid of prying too hard because I might break it. So I called customer service to ask them (a bit extreme) but they basically just told me to take a small screwdriver (I used a hair pin) and pop it out. I tried again by pushing down on the opposite side instead of lifting and it popped right out. The battery is just a small electronic one like in a car's keyless entry controller.

Posted on Dec 10, 2008

Ad
  • 1 Answer

SOURCE: Err 1 message on Taylor Lithium Elec Scale model 7346

This is a reply I received from Taylor customer support. I have followed this procedure enough times to wear out the original battery and still get the Err 1 message. You may have better luck.

Thank you for your e-mail. The reboot below may clear the error from
your scale. You may need to do this several times to completely reboot
the system. Please let us know if you have any questions or continue to
display the Error.


1. Remove the battery from the scale
2. Set the scale on the floor without the battery in place.
3. Stand on the scale for 10 seconds (still without the battery)
4. Carefully replace the battery without turning the scale on.
5. Using only one foot, tap the scale or apply just enough pressure to
turn on the display. (It should show dashes or zero's) IMMEDIATELY
REMOVE YOUR FOOT.
6. Let the scale turn off
7. Step on the scale for a weight reading


Regards,


Linda DLT
Consumer Relations
Taylor Precision Products
& Salter Housewares
2220 Entrada del Sol, Suite A
Las Cruces, NM 88001
Toll free - 800-289-0944
866-843-3905
Direct - 575-526-0944 ext 3172

Posted on Jun 24, 2009

skaterkid307
  • 86 Answers

SOURCE: How can I fix the Taylor LIthium Scale?

take it to were you got it or instuctions show u

Posted on Feb 20, 2010

  • 1 Answer

SOURCE: Kitchen scale, Salter, model 2006: change batteries

The 1 part just slides off.

Posted on Jun 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have changed to batteries twice but I Continue to get error messages. What to do now?


If the batteries are good the hassle has to be with the electronics.

If the pressure sensor is in the on position when booting, that could result in the error message you are getting - make sure it is open when booting up the unit.

Nov 05, 2015 | Homedics SC-405 Digital Bath Scale

1 Answer

What kind of battery do I need for Homedics Lithium Electronic Scale


Here are the Instructions for SC300:

http://web.archive.org/web/20061029012330/www.homedics.com/prod/getpdf.aspx?name=SC300.pdf

Page 2 says the scales require a 3 volt CR2032 lithium battery. These can probably be found wherever batteries are sold - WalMart, Target, etc.

Dec 09, 2014 | Homedics Health & Beauty

1 Answer

I keep getting Err after replacing battery


my scale keeps reading err when I step on it

Jun 01, 2014 | Homedics Digital Scale

1 Answer

I have a homedics SC-512 scale, I changed the battery and it says err 3?


Here is a link to the manual. I has been hard to find. http://mx.homedics.co.uk/cms/mx/manuals/Bathroom/SC-512-0EU_IB.pdf

Aug 11, 2012 | Homedics SC-512 HealthStation Body...

2 Answers

Scale keeps showing lo no weight


Try taking the battery out and putting it back in, also there should be a small reset button. You will need a toothpick to push the reset button. Allow time for the scale to reset before stepping on it.

Apr 19, 2011 | Homedics Digital Scale

1 Answer

The taylor lithium electronic scale says 00 and then ERR. there is no ERR2. should i change the batteries? it never said lo.


If you get an "Err" or "Error" message, you will need to step off of the scale, wait a few seconds and then step back onto the scale.

Aug 10, 2010 | Taylor & Digital Scale Lithium Scale

1 Answer

How can I fix the Taylor LIthium Scale?


take it to were you got it or instuctions show u

Feb 09, 2010 | Taylor "TAYLOR" 73304072 LITHIUM BATH...

4 Answers

Err 1 message on Taylor Lithium Elec Scale model 7346


This is a reply I received from Taylor customer support. I have followed this procedure enough times to wear out the original battery and still get the Err 1 message. You may have better luck.

Thank you for your e-mail. The reboot below may clear the error from
your scale. You may need to do this several times to completely reboot
the system. Please let us know if you have any questions or continue to
display the Error.


1. Remove the battery from the scale
2. Set the scale on the floor without the battery in place.
3. Stand on the scale for 10 seconds (still without the battery)
4. Carefully replace the battery without turning the scale on.
5. Using only one foot, tap the scale or apply just enough pressure to
turn on the display. (It should show dashes or zero's) IMMEDIATELY
REMOVE YOUR FOOT.
6. Let the scale turn off
7. Step on the scale for a weight reading


Regards,


Linda DLT
Consumer Relations
Taylor Precision Products
& Salter Housewares
2220 Entrada del Sol, Suite A
Las Cruces, NM 88001
Toll free - 800-289-0944
866-843-3905
Direct - 575-526-0944 ext 3172

Feb 11, 2009 | Taylor & Digital Scale Lithium Scale

1 Answer

Err message


The "Err" problem is a very common one but no one so far could predict the reason causing this.It means that there has been an
error in the scale measurement.The only solution mentioned everywhere is to Step off the scale until its LCD screen blanks and Step back on the scale.

Jan 20, 2009 | Homedics Glass Digital Scale - Advanced...

1 Answer

ERROR message


This link allows you to troubleshoot directly with the company...I hope this helps.

http://www.taylorusa.com/advantage/root/contact.html

Jan 02, 2009 | Taylor 7506 Precision Tech Lithium Battery...

Not finding what you are looking for?
Health & Beauty Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Homedics Health & Beauty Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Ankit Chandel
Ankit Chandel

Level 2 Expert

141 Answers

Cindy Wells

Level 3 Expert

5189 Answers

Are you a Homedics Health and Beauty Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...