Question about Frigidaire GLER341A Electric Dryer

1 Answer

Our 2-year old Frigidair dryer, Model # GLER341A was working fine-I removed the dry clothes, put in the next load, turned it on and it sounded like a load of chains was in it.. When I opened the door lights were flashing behind the drum as it turned. I removed all but 4 items, tried again - same thing. What has happened??

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 686 Answers

Could be rear drum bearing. possible heat element broke and is rubbing on back of drum those light you say you saw was probably your heat element arcking on the metal in other words sparking

Posted on Mar 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Admiral 6.5 Cu. Ft. Super Capacity Electric Dryer not drying load


does the admiral aed4475tq have a reset button it will not turn on it is only 9 months old

Nov 29, 2009 | Dryers

1 Answer

There is no heat when dryer is on


you need chek :
if your apliance is gas dryer:
1-thermal fuse.
2-sensor flame.
3-ignitor.
4-gas valve.

if is electric dryer:
1-thermal fuse.
2-heater element.

Oct 05, 2009 | Dryers

1 Answer

Gas dryer wont dry close


replace the gas valve coils. they sit right on top of the gas valve. they are black and round, and clide down over a shaft. remove screw from plate holding them, and slide them up and off, replace, and it will run....turn gas off while working on unit:)

Sep 16, 2009 | KitchenAid KGYS750LQ Gas Dryer

1 Answer

LG dryer (model DLE3733W) takes forever to dry the clothes.


check your vent hose for a clog. If dryer dont vent clothes wont dry.

Aug 25, 2009 | LG DLE3733 Electric Dryer

1 Answer

Take too long time to get cloth dried


how much are you putting in ? Is it a 220 volt dryer? May have a dead line (electris) to heating coils, or thermaostat is not functioning and letting the dryer coils get to operating temperature. Your heat setting control may be faulty. I wouls look at heat control first.

Jul 02, 2009 | Frigidaire GLER341A Electric Dryer

1 Answer

Dryer drum sounds like filled w/ chains


Your rear drum support is worn out. It must be replaced.
It is a ball and cup design.

Jan 12, 2009 | Frigidaire GLER341A Electric Dryer

1 Answer

Dryer belt broke on my dryer.


I use a putty knife to press against the spring clips to pop the top. Then I use a quarter inch nutdriver to remove the screws holding the front panel on. I remove the wires from the door switch and lift out the front panel. I remove the drum and put the dryer on a work bench or a tailgate. I inspect the blower wheel(most of the time they get loose). I get the ball of lint out of the front panel filter housing. I vacuum out the dryer with my shopvac. I oil the rollers and idler and inspect the drum slides for wear. I loop a new belt rib side down to the drum and set it back in the dryer. With my left hand I drop the belt under the motor pulley and raise up the idler looping the belt on it and let the tension hold the idler. I manually slowly turn the drum to make sure the belt is secure and not twisted. I place the front back on. Snap the top down and give her a try. Piece of cake.

Jan 11, 2009 | Maytag PYE3300 Dryer

1 Answer

Dryer wont turn back on.


Hi!! Relax your thermal fuze has shorted out..replace your thermal fuze and all is fine..Good luck..the fuze is located by the motor blower inside the machine its white oval around 2 inches and has 2 wire leads to it good luckk.

Jan 04, 2009 | Kenmore 64992 Electric Dryer

1 Answer

Frigidaire LEQ332DSO Squealing Noise


sounds like rear bearing is dry you will need to remove drum to get to it pop clips in top and raise 2 phillips scews 1 in each side remove front remove belt from drum lift drum up in rear and remove ck to make sure plastic bearing is not worn down to metal bracket if it is it will need to be replaced

Jul 07, 2008 | Frigidaire GLER341A Electric Dryer

1 Answer

Frigidaire Dryer takes too long to dry.


First thing I would do is to take the drum out of the dryer and make sure the back is not all clogged up with lint. That is a very common problem with Frigdaire dryers. The back is where the dryer draws the heat from and it sounds like you have plenty of heat. The only place the heat will go is up and that may be why you are geting burn marks. I wold also clean out the front where the lit filter is that to gets blocked up. I think if you check all that ad clean it out good the dryer should work just fine.

Jan 12, 2007 | Frigidaire GLER341A Electric Dryer

Not finding what you are looking for?
Frigidaire GLER341A Electric Dryer Logo

Related Topics:

208 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frigidaire Dryers Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Electrolux
Electrolux

Level 3 Expert

4342 Answers

Tim Whalen

Level 3 Expert

3056 Answers

Are you a Frigidaire Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...