Question about EPoX EP-8NPA SLi (819366003576) Motherboard

1 Answer

When i turn on my computer beep code is appear

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Check your RAM memory, it mai be from them, or the CPU most of the time. There are more than one thing that are not working whell, it depends on what kind of beepeng you hear and your BIOS. these are the codes for AMI BIOS:one shortDRAM refresh failure (Problem with memory)two shortParity circuit failurethree shortBase 64K RAM failurefour shortSystem Timer failurefive shortProcessor failuresix shortKeyboard Controller / Gate A20 failureseven shortVirtual Mode Exception erroreight shortDisplay Memory Read/Write failure (fault with video card)nine shortROM BIOS Checksum error (fault with BIOS chip)ten shortCMOS Shutdown Read/Write erroreleven shortCache memoryone longPassed (no errors)one long, two shortVideo failureone long, three shortBase / Extended Memory failureone long, eight shortDisplay / Retrace Test failure

Posted on Dec 06, 2012


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Computer won't come on

All computers have beep error codes, if you provide the following details I may be able to help.
1 Make and model of PC
2 error code ( you can count the code for example: 123 could correspond to
Beep - pause- beep beep - pause - beep beep beep
3 does the fan turn
4 does the monitor turn on ok
5 can you hear the hard drive an DVD rom spin a little then go quiet or do they spin and then chuntle on for a little while

Nov 25, 2016 | Computers & Internet

2 Answers

My Dell laptop makes 12 beeps and won't start, why?

Unfortunately, they are bad news and omens of *****!

  • Beep Codes - General Hardware - Laptop - Dell Community > ... > Laptop > General Hardware There is a comment in the User's Guide that you should make a note of beep codes when contacting Technical Support but there is no list of the beep codes - this ...
  • Dell Optiplex and Vostro Beep Codes and Error Messages ... 1. OptiPlex Beep Codes. The computer might emit a series of beeps during start-up if the display cannot show errors or problems. This series of beeps, called a beep ...
  • Beep Codes and PSA Diagnostic Chart - Desktop Wiki - Dell > Support Forums > Desktop > Desktop Wiki Identifying Dell Computer Models Using the Model Code. On Sept 26, 2005 the System Setup program on certain Dell Dimension™, Inspiron™, and XPS™ computers was ...
  • Alienware Computer Does Not Turn On or Go Into Windows ... Dell support article tagged with ... The following tables illustrate the Beep Codes for Alienware Mobiles and ... For a laptop computer see if you can access the ...
  • Dell Inspiron 15R (N5110) Beep Codes Diagnostic Indicators > ... > Inspiron 15R (N5110) How to identify beep codes: When a laptop or computer first powers on, it goes through an initial set of diagnostic tests to make sure vital components are preforming ...
  • Dell Motherboard Beep Codes - What They Mean > ... > Computer Hardware Support 2010-05-23 · Technicians and computer users alike can use beep codes to troubleshoot hardware problems on all kinds of machines. This article lists Dell beep codes ...
  • Dell BIOS Post Codes - BIOS Central Dell BIOS Beep Codes; Dell BIOS System Messages; Dell BIOS Post Codes . Dell BIOS Beep Codes:
  • Step-By-Step: Deciphering BIOS beep codes - TechRepublic Discover what the beeps your computer makes at start up mean. ... Step-By-Step: Deciphering BIOS beep codes. ... Dell BIOS Beep codes for Dell computers ...


    Jul 31, 2016 | Dell Computers & Internet

    1 Answer

    My alienware m11x has this problem everytime i turn it on it beeps and doesnt stop beeping lights comeup and fan but no display either

    * Make sure the laptop is using the AC adapter
    * Turn on or restart the computer
    * When the Dell logo appears, press F12 immediately. If you wait too long and the operating system logo appears, continue to wait until you see the Microsoft Windows desktop, and then shut down the computer and try again
    * Select Diagnostics from the menu and press Enter
    * If a failure is detected, the computer stops and beeps, press Y to retest the component that failed

    Oct 14, 2013 | Alienware PC Systems Computers & Internet

    1 Answer

    When rebooted computer beeps 3 times and will not turn on

    Is it a long beep or a short beep? Beep codes are used by the BIOS during the POST to report certain initial system errors.

    If you're hearing beep codes after you turn your computer on, it typically means that the system has encountered some kind of problem before it was able to display any kind of error information on the monitor.

    Follow the steps below to determine what system problem the beep code is representing.
    Difficulty: AverageTime Required: Anywhere from 10 minutes to a few hours depending on the cause of the beep code

    Here's How:

    1. Power on the computer or restart it if it's already on.

    2. Listen very carefully to the beep codes that sound when the computer begins to boot.

      Restart your computer if you need to hear the beeping again. You're not likely to make whatever problem you have worse by restarting a few times.

    3. Write down, in whatever way makes sense to you, how the beeps sound.

      Important: Pay close attention to the number of beeps, if the beeps are long or short and if the beeping repeats or not. There is a big difference between a "beep-beep-beep" beep code and a "beep-beep" beep code.

      This is all important information that will help determine what issue the beep codes are representing.

    4. What steps you take to solve a particular beep code will differ depending on the BIOS manufacturer.

      Choose the correct beep code troubleshooting guide below based on your motherboard'sBIOS manufacturer:

      Tip: Not sure what brand of BIOS is on your motherboard? See this How To Determine Your Motherboard BIOS Manufacturer guide for some helpful advice.


    1. Still can't figure out what the beep codes mean? Let a community of computer support enthusiasts help out! Post the details of your problem in the PC Support Forum.

    Jan 03, 2013 | Dell Precision T5500 Computer Workstation ...

    1 Answer

    Long beep and continue acer motherboard N1996.

    1. Beep codes indicates that there is some problem with your RAM memory sticks installed into your computer motherboard.
    2. For detailed information about the beep codes, refer your motherboard user manual as there are different kind of beep notifications for different problems.
    3. Try removing the RAM from your motherboard, clean of any dust, replace it back to the motherboard and try starting your system. Repeat the step for atleast 10 times, until your system starts up.
    4. If still the problem, persists, try replacing your RAM and try again as this will help us to find out if the problem is with RAM or not.

    I hope this is helpful to you.
    Please rate the solution provided.

    Jun 29, 2010 | Computers & Internet

    1 Answer

    Computer won't restart....

    it appears that this is a memory problem, based on the codes that you specified.

    the reference for this is:

    Aug 09, 2009 | Computers & Internet

    1 Answer

    Screen won't appear upon start up and I get 3 beeps but no screen

    3 beeps POST code (power on self test) means RAM problem.
    Reseat the RAM module/s and boot up your computer.
    If you have two RAM modules, remove them both and insert one at a time to test them, to determine which module is faulty.
    If it still doesn't work then replace the RAM module/s

    Apr 02, 2009 | Everex StepNote NC1500 Notebook

    1 Answer

    F2 and F3 code appearing along with annoying beeping

    i think f3 error code has something to do with the temp probe maybe it is the problem. the temp probe is located if you open the door directly in the back wall. it looks like a prong. should read 1100ohms the f2 error code though usually has something to do with the keypad i would check all the connections maybe they are loose.

    Jan 04, 2009 | Kenmore 40494 / 40495 / 40499 Electric...

    1 Answer

    Screen won't appear upon start up and I get 3 beeps but no screen

    what you are hearing is a beep code, if its 3 short beeps then its the memory which has developed a fault and it may need to be replaced

    Nov 16, 2008 | Acer Aspire 5100 Notebook

    Not finding what you are looking for?
    EPoX EP-8NPA SLi (819366003576) Motherboard Logo

    67 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top EPoX Computers & Internet Experts

    Steven Burn
    Steven Burn

    Level 2 Expert

    187 Answers


    Level 3 Expert

    76070 Answers


    Level 3 Expert

    778 Answers

    Are you an EPoX Computer and Internet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides