Question about Televison & Video
My receiver started a down load which I stopped as I was watching a program. After that my remote quit working! was it something I did. ( batt is good ) I shut off the receiver, and restarted it manually but nothing would work from the remote. I unplugged the receiver, re-plugged in, but no go! Remote is 5.3 IR
Have the remote tested to see if it is sending signal (infrared is most common) as most shops have a tester you point the remote at and press buttons and the test unit reacts.
many digital cameras can also in a very dark room be tested in the same way, push buttons with remote pointed at the camera and look for a tiny flash in response on the camera display
Other possible reason is a bad remote receiver but that rarely happens.
Posted on Dec 06, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I have found a solution to the question. This remote will allow a user to control a SONY receiver by pressing the "Use Mode Key" at the top of the remote, and AV1 or AV2 button, in the first line of buttons toward the top of the remote, at the same time and this allows for control of an unlimited number of SONY receivers
Posted on Nov 22, 2007
i have a zenith mbr remote that stop working ,so i now have a one for all but i need a code to make it work.
Posted on Mar 01, 2008
The problem for me was the TV giving off IR signals that interfered with DISH's poorly designed remote. When the TV's room ambient light sensor was turned on and it became dusk outside the DISH remote would stop working. Moving the receiver away from the TV helps but the problem is not eliminated until the light sensor is turned off.
Until DISH corrects this poor design there may be no other viable solution.
Posted on Aug 04, 2009
The following instructions will enable the Bell 9242 remote to operate a Bell 5900 receiver. Remove back battery cover. Just below the "Bell" lettering on the front of the remote, there is a half moon shaped plastic insert "key" that slids out downward. Turn over the plastic key and reinsert back into postion and replace the battery cover. Success!
Posted on Oct 17, 2010
SOURCE: Bought new Vizio 55"
Had same problem - turned off Adaptive Lumina, Backlight control, and Ambient light sensors on the Vizio advanced picture settings and the Dish remote now works. Vizio was emitting an infared signal that interfered with the Dish remote signals with these settings on. TV still works and looks just fine... But best of all Dish remote works too.
Posted on Jan 01, 2011
Tips for a great answer:
Sep 26, 2016 | Universal Televison & Video
Mar 12, 2013 | Chamberlain KLIK1 Remote Control
Oct 31, 2011 | DISH Network IR Remote Control
Jun 23, 2011 | DISH Network IR Remote Control
Apr 15, 2010 | Logitech Harmony 550 Remote Control
May 04, 2017 | 1998 GMC Jimmy
Jun 20, 2009 | Hunter Ceiling Fan Remote Receiver...
Oct 13, 2008 | VIA Computers & Internet
Mar 18, 2008 | Sony DHG-HDD250 200-Hours Video Recorder
47 people viewed this question
Usually answered in minutes!