Question about Whirlpool RMC275PD Microwave Oven

Open Question

Whirlpool Gold microwave won't turn on

My Whirlpool Gold built-in microwave model# XNR1677406 won't turn on, it starts to and then says " DOOR"  in the timer screen. How to I troubleshoot this problem?

Posted by on

4 Suggested Answers

SOURCE: Microwave does not heat

Just had the same experience with the identical model. Removed the cover (a challenge because of the security screws), revealing valuable troubleshooting directions intended for an experienced technician. However, I think the info is well within the reach of a typical DIY person, does not require any dangerous power-on conditions. However, make sure that you discharge the HV capacitor before trouble shooting. In my case, it appears that the HV diode is open, have ordered a replacement on the internet for $3.18, easy to replace. Hope it works. Good luck.

Posted on Jul 14, 2007

MicrowaveSvc
  • 8820 Answers

SOURCE: Whirlpool Gold Microwave Model GH7155XHS

This is usually caused by either a bad door switch, a loose door switch mount, or a problem on the control panel.

Even though a door switch clicks, it may still be bad inside. Its continuity must be checked.

Door switch or mount trouble can be caused by slamming the door or by opening the door while it's cooking without hitting the Stop pad first.

If you or someone you know decide to look into it, we have critical information on safety, disassembly and door switches at our site, and our link is at our listing here on FixYa: http://tinyurl.com/yzjozk

You can find helpful exploded view diagrams and order parts by entering your full model number here: http://tinyurl.com/gv383

If you think the problem is on the control panel, we repair these nationwide by mail for $39.95 postpaid in most cases.

Please feel free to contact me directly if you need more help.

We're happy to help and we appreciate your thoughtful rating of our answer.

William E. Miller, AS-EET
prototech@usa.net
http://www.microwavedisplay.com

Posted on May 09, 2008

MicrowaveSvc
  • 8820 Answers

SOURCE: damaged inner seal tape on whirlpool microwave door window

Normally you have to separate the door panels (as shown in the attached photo) and then you'll see the previously hidden screws you need to remove.

Or you can watch a YouTube video (not a video I made) that demonstrates how it's done.

You can usually find helpful exploded view diagrams and order parts by entering your full model number here.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

54e249f.jpg

Posted on Dec 08, 2008

milten1
  • 1304 Answers

SOURCE: How to replace the door handle on Spacemaker built in Microwave

take a small flat edge and pop out the plastic trim on the inside of the door, you will have to pry a bit but it will pop out, be very ccareful as it will break quite easily,,,,, the back of the handle is now accessable
two screws

Posted on Oct 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have to slam the door very hard for it to close correctly what would cause this problem?


Incorrectly adjusted door catch. They have movement on them to allow a tight seal due to the microwave capability.

I just found the specs and instructions on it.

Whirlpool Gold 2 0 cu ft Velos SpeedCook Oven

Mar 09, 2016 | Whirlpool Gold 2.0 cu. ft. Velos SpeedCook...

1 Answer

My whirlpool gold GT4185SKQ-2 microwave won't heat


It's not door switch. It's the microwaves are not being produced. Do to safety issues DO NOT take apart. Replace

Jul 24, 2014 | Whirlpool Microwave Ovens

1 Answer

Microwave oven will not start after I put in the time. It says open and close door and press start. Still won't start


Probably a bad door switch or mount. The door switch help file is here.

On some models though (you didn't mention yours) the door circuit is very complicated, and may be showing the door error due to a blown fuse or cavity TCO.

Accessing the cavity TCO for testing and possible replacement will require you to remove the oven from the wall.

If so, the installation instructions are very handy, and it's best to have two people since the microwave can be heavy and awkward.

You can download Whirlpool owner's manuals and installation instructions here.

The drawing below shows what to check:

12_20_2011_2_42_28_am.jpg

You can find handy exploded views and order parts by model number
here.

At our Web site, we have a video available showing how to remove a typical over the range control panel assembly in under 5 minutes.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Dec 04, 2011 | Whirlpool Microwave Ovens

1 Answer

My microwave not starting


My microwave on top of stove oven,whirlpool gold. When i closed the door but it keep said"door"and won't start.

Jul 21, 2011 | LG MS-0744Y Microwave Oven

1 Answer

My Whirlpool Gold microwave oven just died, no lights on the digital pad, and no light when opening the door. Model # GT4175SPS Year 2005


Hi,
Here is a tip that will help you to figure out what is wrong with yourMicrowave Oven....

Microwave Oven Basic Troubleshooting Tips

heatman101

Apr 17, 2011 | Microwave Ovens

1 Answer

Whirlpool gold microwave gt4175sps - problem: will


Hi,

It sounds like there may be a diode or relay on the control that has failed. This could cause both symptoms you are explaining here. In either case the control board/keymembrane would need replaced. The cost of these would be about $173.00 for parts. Unfortunatly this repair would most likely cost more than the value of the product. Sorry for the bad news.

Apr 18, 2010 | Whirlpool GT4175SPS Stainless Steel 1200...

1 Answer

I have a Whirlpool gold accubake microwave / oven combo model number GMC305PDS07. The microwave will not turn on and will display "DOOR". I think it is thinking that the door is open?. Please help.


Press and hold the DELAY START TIME button for +5 secs and a chime will sound. The option to toggle between SND HI and SND LO will come up, pressing Delay Start Time will change it between these options.

Jul 18, 2009 | Whirlpool RMC275PD Microwave Oven

Not finding what you are looking for?
Microwave Ovens Logo

Related Topics:

710 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Microwave Ovens Experts

William Miller
William Miller

Level 3 Expert

8820 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

sonic boom...
sonic boom...

Level 3 Expert

1557 Answers

Are you a Whirlpool Microwave Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...