Question about i-mate JASJAR Cellular Phone

5 Answers

My jasjar is blocked, and presents the sign USB v0.60 when connected on my PC to syncronize, or Serial when not connected. What can I do?

Posted by on

  • 3 more comments 
  • christouwrc Jan 12, 2009

    I did not understand the solution #1 presented.

    What must I do - a step by step solution please!!!

  • christouwrc Jan 12, 2009

    I have looked into the official site of imate, but cannot find the official firmware. Anyway, even the start-up CD that was provided with my phone is NOT operating.

    Can you please give me other advise?

  • christouwrc Jan 12, 2009

    I think that I found out some things...

    Do you suggest anything due to the fact that I have Vista on my PC?


  • christouwrc Jan 13, 2009

    Hi!

    As I have written in your email as well, the USB is NOT recognized when running the utility.

    Has this anything to do with Vista?

    Please advice


  • christouwrc Jan 15, 2009

    Thanx my friends!

    At last, I have managed to unblock it - the issue was on the firewall, once deactivated, then I could follow the steps:

    1. Run the mtty utility
    2. Once completed the "set 14 0" order, then I needed only the hard reset

    So, this is how it worked.

    Regards


×

5 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 45 Answers

Download the official firmware from i-Mate and try flashing it. You will need to connect the phone to a laptop and run the flash on it. If the computer is not recognizing the phone, you will need to get the phone into serial mode. This forum may help you out.

Posted on Jan 12, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 837 Answers

Where did you get the phone?

Do you have the original SIM card for it?

What SIM card are you using in it?

Posted on Jan 12, 2009

  • Jay Glendenning
    Jay Glendenning Jan 12, 2009

    In summary :



    What is Sim Free? A sim free phone is a phone that is not locked to the sim card of a specific carrier.

    What is Unlocked? An unlocked phone is a phone that can work with any sim card and/or GSM service provider. Please note that at least one of the GSM Bands in the phone should match the GSM service prodiver's bands.

    What is a Sim Card? A sim card is a small flat rectangle plastic that contains a microchip. This microchips is the heart of your phone, it contains your phone number, your address book, and the necessary information for your phone to work. All sim cards look the same, but the microchip inside is different for every GSM service provider.

    What is a GSM service provider? A GSM service provider (carrier) is a company providing you with a working line and phone number. To do this, they will provide you with a sim card.

    My GSM service provider does not have sim cards, why? If your service provider does not have sim cards, then it does not use GSM technology. Our phones will not work with non-GSM service providers.

×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • i-mate Master
  • 13,433 Answers

You will need to flash a new firmware to the jasjar, I happen to have the same phone you got there, actually its the same phone just under a diffrent name, O2 XDA EXEC.

all the instructions you will need are on this website
http://wiki.xda-developers.com/index.php?pagename=HTC_Universal

If you need more assistance from me I would appriciate if you accept my solution so we can communicate better.

Posted on Jan 12, 2009

  • 3 more comments 
  • Ekse Jan 13, 2009

    Hi sorry for not responding it happens that I actually went to bed, Yes I updated it on vista also, I don't remember actually what Rom I used but I now have windows mobile 6 on it, if you have any spesific questions let me know, we can even do a remote support session so I can move the mouse and see the screen and help you with it, you got really lucky today, you got someone who happens to have the same phone and real experience with it.

    let me know, also my email is nikoht@gmail.com let me know.


  • Ekse Jan 14, 2009

    When would you be available so we can look into it together?

  • Ekse Jan 14, 2009

    Enter the Bootloader Mode

    http://wiki.xda-developers.com/index.php...

    Bootloader mode: Hold light(1) and power buttons(2) together and
    reset with stylus(3). (The light button is on the front edge of the
    phone, near the volume slider(1)). In bootloader mode please keep in
    mind that the backlight is turned off, therefore the screen is hard to
    read in poor light.


    In this mode you can flash in a firmware. I wonder if the phone is unlocked etc. we really need to look into this together over remote support.

    When would you be available? I'm on Finland time, its 6:10 in the morning right now, GMT+2


  • Ekse Jan 14, 2009

    Let me know when your available and we can solve the problem together.

  • Ekse Jan 14, 2009

    Are you able to enter the bootloader mode for firmware flashing? when you are in the bootloader mode is the device detected on the computer?



    I will not be available for much longer now, and we will have to get back together later.

×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 818 Answers

Download the official firmware from i-Mate and try flashing it. You will need to connect the phone to a laptop and run the flash on it. If the computer is not recognizing the phone, you will need to get the phone into serial mode.
Sergio

Posted on Jan 12, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,550 Answers

You should then download the latest firmware from i-Mate .

Upgrading the firmware will solve the problem mostly.

Posted on Jan 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Connection with PC by USB


Be sure the USB cord being used is not just a charging cord(it will have the "trident" picture on it if it is for data transfer)

Oct 07, 2012 | Android Galaxy Ace

1 Answer

Hello people I've a problem with my samsung sgh g600 I can not connect to the pc it does not connect her help me please


this worked for me ......


Unplug usb cable from phone

Type *#52828378# into phone

and this comes up

1 Trace setting
2 OTA type setting
3 Serial test
4 TFS reset

select 3 serial test

and this comes up

1 PPP UP
2 Serial download
3 Run TCK

Select 2 Serial download

The phone will reboot and once its rebooted connect usb cable and pc studio will work.

THANKS

Jun 29, 2010 | Nokia 6233 Cellular Phone

1 Answer

IMate JASJAR and WM6.1?


A good place to start with is here. You'll find that some links seem to be broken, but there are lots of informations all over the place.
Cheers! Carlos

Apr 16, 2010 | i-mate JASJAR Cellular Phone

1 Answer

I try to update the win and now my phone is off


you've to start upgrading rom.Wm5 was best option!try reading this and don't upgrade rom without reading instructions.
http://bit.ly/9P4heb

Mar 24, 2010 | i-mate JASJAR Cellular Phone

1 Answer

I lost my windows while installing a ROM. plz help jasjar i mate


i lose my windows version 61. how i can install new windows xp

May 05, 2009 | i-mate JASJAR Cellular Phone

1 Answer

Pc sync problem


i loaded the disk onto vista and it works great. can even write txts on keyboard and send via the phone connected to the usb. but cant get it to work on xp!!! hmmmmm!!!!

Mar 20, 2009 | LG Secret ? KF750 Cellular Phone

3 Answers

My samsung G600 wont connect to my pc studio 3 on computer?


If you are using pc studio you must first check that it is set to use it.Try this first:-
1,settings-phones settings-USB settings-pc studio.
2,If not then check that your pc USB's are switched on.

Aug 25, 2008 | Samsung SGH-G600 Cellular Phone

1 Answer

Jasjar


When you upgrade to a new firmware version, the phone's memory is completely wiped. It will be very hard to get your information back.

Download the official firmware from i-Mate and try flashing it. You will need to connect the phone to a laptop and run the flash on it. If the computer is not recognizing the phone, you will need to get the phone into serial mode. This forum may help you out.

Jul 13, 2008 | i-mate JASJAR Cellular Phone

Not finding what you are looking for?
i-mate JASJAR Cellular Phone Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top i-mate Cell Phones Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Jax Planet
Jax Planet

Level 2 Expert

921 Answers

yadayada
yadayada

Level 3 Expert

61168 Answers

Are you an i-mate Cell Phone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...