Question about Pinnacle Dazzle DVC 90 (210100371) Video Capture

1 Answer

Video and sound out of "syc"-Dazzle DVC90 video capture device

Tried to capture vhs tape to dvd - when played back sound and video out of syc.....

Posted by on

  • Anonymous Apr 03, 2009

    However mine goes out of Sync when traansferring direct to DVD without using the hard disc so that can't be the reason

  • byronfblour Apr 08, 2009

    Sound and video out of sync now nothing will appers on the screen.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

The sound sync problem has been round since the very start of DVD conversion.

However, the general rule is defrag the hard drive before rendering or capturing and also make certain that all running apps are shut down (messengers, etc)

Another common problem is the video drivers - always keep those fully up to date with the latest drivers from the card makers (same for sound drivers) and also the latest DirectX from MS

Posted on Feb 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

When I try to capture a VHS feed, importing from video composite, I get the message saying "no input signal". My VCR is old. Is it possible that this is the cause, or are there other things that I should...


Likely the VCR is unable to function properly anymore, however it would not hurt to check the cables. Some cables when they get old develop shorts in the wires this is also a probable cause. Try new cables first then a new VCR.

Jan 23, 2014 | Pinnacle Dazzle Video Creator Platinum...

2 Answers

Movie playing faster than the speaking


is the video a few seconds faster than the sound. Like you'll see a mouth talking then hear it a second or two later?

Apr 06, 2010 | Pinnacle Dazzle Video Creator Plus Video...

1 Answer

My DVC 100 will capture video but will not capture sound everything is setup correctly


Hi,
Welcome to fixya,
I understand that you have a problem with regards to your Dazzle DVC 100 and the problem you encounter is regarding to the sound. Is this no sound, or garbage sound? If no sound did you connect the audio cable properly? Could you please check your device manager.

Click on Start>Control panel>system>hardware>device manager>sound and video games controller> right click on video capture device uninstall it.
Right click on dazzle audio device uninstall it also. Restart your computer. After restarting let your computer detect and install the driver device. Open your IDVDR and try it again.

Dec 08, 2009 | Pinnacle Dazzle DVC-100 DVD Recorder

1 Answer

Crackly sound when recording vhs tape to disc


try new cables going from the vcr to the video capture (yellow red white)

Dec 01, 2009 | Pinnacle Dazzle DVC-100 DVD Recorder

1 Answer

I have a dazzle dvc90 and vista 64 bit, they don't seem to work together.


Hello,

Currently, Pinnacle does not have 64-bit drivers for the DVC90 to work with the 64-bit Vista. This may be the reason you are running into trouble. I would recommend contacting Pinnacle and have them contact you when they release the 64-bit drivers.

Good Luck
C2Solutions

Aug 20, 2009 | Pinnacle DAZZLE DVD RECORDER Video...

1 Answer

Driver Installation Error


I think cannot support the DVC90 drivers on vista.

Jul 09, 2009 | Pinnacle Dazzle DVC 90 (210100371) Video...

1 Answer

0.008 seconds - no capture, no preview.


Going to the Pinnacle support part of their website in downloads and downloading the latest drivers for the relevant model number worked for me.

Mar 02, 2009 | Pinnacle Dazzle Video Creator Platinum...

1 Answer

Dazzle DVC 90 does not work in Vista


Hi there!

Try unplugging the DVC90 and uninstalling it from Device Manager. Then go to the Control Panel and delete all the drivers you find. Reboot and try the installation again. If I remember correctly you can run PCLUSB2.exe first to get the drivers on your hard drive and then plug the device in. When you do that just point the driver install to the folder that the drivers got installed to.


Have fun!

*Your vote is highly appreciated. Thanks in advance!

Dec 30, 2008 | Pinnacle Dazzle DVC 90 (210100371) Video...

3 Answers

Audio/video synchronization problem


I have tried several versions of Pinnacle products over the years, and have had serious problems with ALL of them. Constant crashes, re-boots, glitches, dropped frames, etc. Sound lagging behind the picture is one of many problems, and can be avoided only be capturing short clips and editing them together. A real pain. i finally gave up on Pinnacle and bought Sony Vegas Movie Studio Platinum. It has a longer learing curve than Pinnacle, but in the long run it has more features and is very stable. Sony Vegas also works with Vista. Pinnacle 10 does NOT, depsite what Pinnacle and the salespeople tell you.

Mar 17, 2008 | Pinnacle Dazzle Video Creator Platinum...

Not finding what you are looking for?
Pinnacle Dazzle DVC 90 (210100371) Video Capture Logo

1,282 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pinnacle TV Accessories Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Soulvisitor
Soulvisitor

Level 3 Expert

1113 Answers

Jazz Boyce
Jazz Boyce

Level 1 Expert

728 Answers

Are you a Pinnacle TV Accessory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...