Question about Audio Technica Audio-Technica 200 Series Freeway ATW-252 Professional Microphone

1 Answer

Disasimbel freeway atw-t202 for repair

Droped not working

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Might just be the mic wires came loose...I have oner and the mic is held in by a small rubber O-Ring and as people drop it it falls out and can short out

Posted on Jan 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My mic wireless mic sounds like it has a ground loop hum when it is in standy mode and when it is all the way on. I've switched cables and batteries what could be causing this hum?


You could try another power adapter on the receiver, maybe this one blew the filter capacitor. I doubt your problem being the mic, rather check the receiver. Luck !

Nov 10, 2014 | Audio Technica Audio-Technica ATW-T202...

2 Answers

Changing frequencies on wirleless microphone


No, the ATW-R200 series are fixed-frequency units.
Short of soldering new crystals in, you're stuck with the frequency you've got.

Sep 21, 2009 | Audio Technica Audio-Technica 200 Series...

1 Answer

How do I fix the on/off switch for and ATW-T202?


Had the same problem - faulty switch. The switch was labeled ALPS so did some searching and found a replacement switch at Mouser Electronics. P/N SSSS928200. Switch is $.64 + shipping. So I ordered 3.

Best way to replace it is destroy the old switch in place careful not to damage the solder lands on the PCboard. Then unsolder each pin using minimum heat to not damage the PC board. Insert new switch an resolder. Note carefully the routing from the pins so if you do damage a land a short piece of wire to its destination will replace the damaged routing.

May 05, 2009 | MCM Audio-Technica ATW-T202 Microphone

1 Answer

Two diffrent units with two diffrent frequincys . i wantto change


I hate to be the bearer of bad news but those units are fixed frequencies and cannot be changed. You either have to find a mic that matches your receiver or vice-versa. The freeway 200 series comes in 3 freqs. two of witch you have with the addition of 170.245. Maybe you can find someone who has a damaged mic but still has the receiver with the freq. that you need for your mic.

Apr 11, 2009 | Audio Technica Audio-Technica ATW-T202...

2 Answers

Wireless noise


the unit I'm using is old and is on a 200mhz frequency and it uses Vhf, so I have to buy a new unit.....nothing can be done to fix the problem....

Jan 21, 2009 | Audio Technica Audio-Technica 200 Series...

Not finding what you are looking for?
Audio Technica Audio-Technica 200 Series Freeway ATW-252 Professional Microphone Logo

Related Topics:

395 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audio Technica Microphones Experts

Brad Brown

Level 3 Expert

13577 Answers

Rick

Level 2 Expert

611 Answers

Ben Armstrong

Level 2 Expert

332 Answers

Are you an Audio Technica Microphone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...