Question about BellSouth 2250BK (22 Channels) 2-Way Radio

1 Answer

YAESU FT-897D EXTENDED TRANSMISSION

Can anyone email me or post a photograph or link of the actual jumper mod as the diagrams online are pretty scrappy at best.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 52 Answers

The Webiste
http://www.rigpix.com/yaesu/ft857-897_modcollection.pdf
has pretty good information.

Good luck !

(http://www.eham.net/forums/ModsAndRepairs/5635 is an alternative)

Posted on Jan 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Refuses to power on


Have you checked the fuses? Yaesu typically means a fuse on the power lead and the ground wire.

Jun 04, 2015 | Yaesu FT-897D Transceiver

1 Answer

How ti unlock transceiver radio Yaesu FT 1900R to transmit beetwen 136 to 174 Mhz


Here is a link to a forum that has instructions for how to make the modification: http://www.worldwidedx.com/threads/expanded-tx-mod-for-ft-1900r.37171/

Aug 19, 2014 | Yaesu Ft 1900r Vhf Mobile 55 W Two Way...

1 Answer

How yaesu 897d main dial disconnect


If you are asking How do you remove the knob? Carefully remove the rubber ring from the outside of the knob. This is called the Sleeve in the Manual. You will then see one or 2 set screws inside the holes which must be loosened. The knob should then slide off.
73 from Wade/KJ4WS

May 16, 2014 | Yaesu FT-897D Transceiver

1 Answer

Need to couple Astatic D-104 mike to Yaesu FT-847 Radio


Check the wiring diagram online for both. It's a pretty simple connection setup.. Look at mods.dk for possible answers.

Feb 12, 2014 | Yaesu Two-Way Radios

1 Answer

My 857 receives fine, but when I key the mic it turns off. The 857 works fine on HF both receiving and transmitting.


I would have a look at the FT-857's extended service menu by holding in A, B, C buttons and pressing power button for a couple seconds. The default setttings are on the mods.dk website. Should also ensure regular menu settings are correct/appropriate. I can tell you that it is possible to change extended menu settings by getting RFI into radio. Also, although unlikely, it sounds like you could inadvertently have done a write to the radio's EEPROM, which can be determined by using a program such as Ham Radio Deluxe, a CAT cable, and procedures also posted on mods.dk website under how to open radio up for 60m, ext tx/rx, without any hardware mods. As to whether you can do all this while still mounted mobile,,,,,maybe with a laptop? Good luck, Link, WV4I....

Oct 22, 2013 | Yaesu FT-857D transceiver

1 Answer

Yaesu ft 416 ver a2 need reset to get extended receive


You may find detailed instructions for this on www.mods.dk

Jul 03, 2011 | Vertex FNB-27SM,...

1 Answer

Yeasu ft270r handheld do u have a mod for this


Check on www.mods.dk. Pretty sure you'll find one there - you may have to join and pay a small fee but, worth it.

Oct 09, 2009 | Vertex FNB-26,...

1 Answer

How do i get expanded freqs on my ft1802 yaesu tranceiver


The FT-1802 is a 50 watt 2 meter FM transceiver. It can transmit anywhere between 144 - 148 Mhz (the FM portion) of the 2 meter ham band. It can receive anywhere between 136 - 174 Mhz without any modifications. There is a modification to enable transmit "out of band" below:

http://www.ham.dmz.ro/yaesu/ft-1802-extended-transmit-modification.php

There are few details about the results of this mod - typically these provide for transmitting on frequencies outside (above, below or both) of the 2 meter ham band. Transmitting outside of the ham band without a proper license for the frequencies in the U.S. is a violation of FCC rules.

Sep 08, 2009 | Yaesu Two-Way Radios

2 Answers

Yaesu FT 11R


figured out how to solve this, with the radio off, push and hold both up and down scan buttons, while powering the radio on. This will fix the problem.

Sep 28, 2008 | Vertex FNB-33, YAESU,FT-11R,FT-41R,FT-51R,...

3 Answers

Yeasu FT 897D


Hi,

I suspect that the extended transmit will really allow you TX on 2 Meter from 136-174 or thereabouts even with modifications.

At any rate, Air Bands are amplitude modulated, have you tried switching mode to "AM" when operating 116-136MHz??

Would you post back please on how the modification (extended transmit) was done; software programming of the EEPROM or jumpers (JP1001-1009).

Good luck and kind regards.

Nov 22, 2007 | Two-Way Radios

Not finding what you are looking for?
BellSouth 2250BK (22 Channels) 2-Way Radio Logo

Related Topics:

1,588 people viewed this question

Ask a Question

Usually answered in minutes!

Top BellSouth Two-Way Radios Experts

Cindy Wells

Level 3 Expert

4761 Answers

Steve

Level 3 Expert

3287 Answers

Iron
Iron

Level 3 Expert

3018 Answers

Are you a BellSouth Two-Way Radio Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...