Question about Onkyo TX-DS575 Receiver

1 Answer

I have an onyko receiver tx ds 575 the sound from my tv to receiver to speaker is very low can't figure out why need help thanks

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

Have you ckeck the tv config??

sometimes u need to select in the tv menu, in audio option to have continue output, otherwise when you turn the volume up in the tv the amplifiers sounds more, have you try this??

or check the cable maybe is damaged.

Good Luck

Posted on Jan 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Onyko TX-NR828 - no sound.


Hi, hope you tried to checked wires for short,speakers for short if its ok,factory reset again ,and then try Firmware update ,if it dont help contact your nearest Onkyo dealer :)

Oct 04, 2014 | Onkyo TX-NR828 7.2-Channel Network A/V...

1 Answer

Onyko tx nr616 receiver keeps shutting off. Only stays on for approximately 3 seconds. Can you help?


The amp protection circuit has been activated. Remove the power cord from the wall outlet immediately. Disconnect all speaker cables and input sources, and leave the AV receiver with its power cord disconnected for 1 hour. After that, reconnect the power cord and reconnect an input and a pair of speaker wires onto the unit. If the receiver still does not turn on than you will have to bring it in for service. Turn up the volume and if the receiver doesn't shut down, power off the receiver and add another pair of speakers. Power up the unit again and turn up the volume. If it doesn't shut down, power off the unit again. Now connect all your input sources and turn on your receiver. If the unit shuts down again, your unit will need to be further serviced at an authorized Onkyo service center.

Sep 30, 2014 | Onkyo Tx-nr616 7.2 Thx Certified Network...

1 Answer

Is it possible to get an instruction manual for the tx ds 575 reciever? thanks.


Onkyo? Like most Fixya requests it's as hard as Googling "tx ds 575 manual".

Aug 26, 2011 | Audio & Video Receivers

1 Answer

I would like to configure my receiver tx-sr303 to use the 5.1 configuration?


I'm assuming Onyko.

Get the manual out and assemble the necessary source(s) and speakers. They'll come with manuals, too.

Register and download the manual for free at retrevo.com

http://www.retrevo.com/support/Onkyo-TX-SR303-Receivers-manual/id/365ag207/t/2/

Jun 19, 2011 | Onkyo Audio & Video Receivers

3 Answers

I have a TX-DS575 receiver and RC-391M remote control and the remote no longer controls the receiver, but it still controls all the other components (dvd, tv, etc). How can I get it working with the...


Replace the IR receiver diode on the front panel. Try HERO HIM602H from farnell.com, i used that one for my TX-DS 777. (i guess 575 using same stuff)

Nov 27, 2010 | Onkyo TX-DS575 Receiver

1 Answer

VERY LOW VOLUME FROM SORROUND SPEEKERs


some surround sounds do not put out loud sounds except from the front speakers only. Try using different inputs to see if it makes a difference.

Jun 17, 2009 | Onkyo TX-SR605 Receiver

1 Answer

Woofer assistance


You need to buy an active (self-amplified) subwoofer. Attach it to the Subwoofer Preout connector.

Go into Speaker Setup (SP SYS/SETUP Button near upper right side of Op Panel) and follow the prompts.

The parameter we're most interested in is the question "Subwoofer Yes" or "No".

Some guidance when selecting speaker parameters for the rest of the channels:

SMALL vs LARGE: This has nothing to do with size so much as it deals with the BASS handling capacity of the speakers. If you say SMALL, most low frequencies from those channels will be re-routed from them to the Subwoofer. If you say LARGE the channels will still get the low frequencies they deserve.

I imagine you would be able to answer LARGE for all of your speakers.

Even if you have all LARGE speakers defined the Sub will still have work to do as it will be dealt the LFE (Low Frequency Effects) from encoded movies and all or most of the content below certain frequencies.

Mar 27, 2009 | Onkyo TX-DS575 Receiver

1 Answer

Onkyo tx ds 575 shuts down


What preceded the problem starting? Was it spontaneous or human caused?

The age of the wires is less relevant than A) they're connected correctly; B) they're not shorting to anything.

You need to isolate the cause.

Disconnect all speakers and attach just one. Try it somewhere. If it works, use it to test all other speaker connections. Do they all work? No = isolate.

Yes - Add a second speaker to pair A or B. Still working? Move them to the other pair. Still working? Try the second set of speakers.

Not working? Isolate.

Mar 21, 2009 | Onkyo TX-DS575 Receiver

Not finding what you are looking for?
Onkyo TX-DS575 Receiver Logo

Related Topics:

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Onkyo Audio & Video Receivers Experts

D. E. Hev

Level 3 Expert

1059 Answers

gbob59

Level 3 Expert

2963 Answers

Matthew Spark
Matthew Spark

Level 3 Expert

1042 Answers

Are you an Onkyo Audio and Video Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...