Question about Kenmore 40494 / 40495 / 40499 Electric Single Oven

1 Answer

My oven flashing F11 and beeping. - Kenmore 40494 / 40495 / 40499 Electric Single Oven

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 262 Answers

You have a shorted key pad turn off power and wait 30 seconds turn back on if it return you will need to replace oven control

Posted on Jan 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to fix frigidaire wall oven beeping error message f11


Good Morning Friend,

I understand that your Frigidaire wall oven is beeping and showing an F11 error code. Typically an F11 error code states that there is a shorted key, or a button has been detected as pressed for a long time. I suggest hard resetting your appliance, by cutting the power at your homes circuit breaker for 3-5 minutes. While you are resetting your oven, make sure to wipe down the control panel. The panel is very sensitive and could be detecting something that has splashed or spilled onto it, even dust. When you bring power back to your appliance you will need to start by setting the clock. Turn your oven on any cycle at any temperature. If you are still receiving an F11 error code, I suggest contacting your local authorized technician for further assistance. Hope this is helpful.

-Best Regards-
WP

May 14, 2014 | Frigidaire 30 in. Electric Gallery Series...

1 Answer

I get a F11 code with beeping noise and the oven controls won't work? what can i do?


Hi Ken Kazemi - Typically error code F11 indicates a shorted keypad. Try resetting the range by unplugging it or flipping the household circuit breaker off. This usually will clear most false error codes. Wait approximately ten minutes and if it proves to be ineffective contact a professional to move forward accurately. Most likely the EOC on the range will need replacing.

Feb 03, 2013 | Frigidaire 30" Self-Cleaning Freestanding...

1 Answer

I have a frigidaire model fef364dsa and it blew circuit braker and now beeps and flashes f 11


F11 is for the clock/timer board error and will need to be replaced. Here is the part to order.
Be sure the unit is unplugged before replacing the part!
Also, take note of the wire harness connections.

Nov 05, 2012 | Frigidaire Ovens

1 Answer

What is the EOC and how much does it cost to replace? Can I replace it myself or do I need a professional to replace it?


kenmore stove model #c970635326 serial #nf70205945 is showing f11 on the clock and a constant beeping noise.
when you unplug and plug it back on the clock show 12:00 for a few seconds then the f11 shows again and the continuing beeping noise
how much is an eoc to replace....can i do it myself....

Jan 09, 2011 | Kenmore Ovens

1 Answer

I have a Kenmore gas built in oven, model number 790.30179400. It's 5 years old. I just used the oven and it wouldn't turn off. It seemed to be hotter than the temperature I had it on. I have a fuse box in...


Usually F11 is a comunication error and the initial fix is to remove all power for 30 seconds then try it again.

The oven element that did not turn off is a sticking relay on the Electronic Range Control (ERC) board /clock timer that did not open the relay electrical contacts when the power was removed from the relay coil. Or there was an on the printed circuit board (PCB) fault in the ERC that allowed power to remain on the relay coil until you removed power by pulling the fuse.

The most probable cause below with the cheapest source being Sears Direct in 2nd link.

http://www.repairclinic.com/SSPartDetail.aspx?s=t-316418553-%3d%3di1064462&PartID=1064462

http://www.searspartsdirect.com/partsdirect/getSubComp.pd?modelNumber=79030179400&productCategoryId=0125200&brandId=0582&brandDescription=KENMORE&modelName=GAS-WALLOVEN&diagramPageId=00001&componentDescription=CONTROLS&documentId=R0409085&blt=06


Thanks for using FixYa!

Kelly

Jan 20, 2010 | Kenmore 40494 / 40495 / 40499 Electric...

1 Answer

Stove flashed F11 and then locked the oven door


HI, this is control failure. the logic chip set is damaged. this is causing these erratic commands and the unauthorized locking of the oven door. you will need ot replace the control in this case.(EOC/clock)

May 29, 2009 | Frigidaire FEB27S5A Electric Single Oven

1 Answer

Oven beeping


hi my kenmore stainless steel black top keeps making a beeping sound and says F11

Sep 03, 2008 | Kenmore 40494 / 40495 / 40499 Electric...

1 Answer

Oven


I used the self cleaning mode for 2 hours and the error f2 keeps flashing and beeping, I did try to power off with the breaker and left it off for about a half hour and it still continues to beep and flash f2, what should I do?

Aug 07, 2008 | Ovens

Not finding what you are looking for?
Kenmore 40494 / 40495 / 40499 Electric Single Oven Logo

Related Topics:

178 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenmore Ovens Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

Michael Thomas
Michael Thomas

Level 3 Expert

3051 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Kenmore Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...