Question about Ovens
Heated when demoed but after install ,no heat. All function buttons work. Clicking happens and fan is blowing, but still no heat
1.Check sensor connection. 2.Measure sensor resistance (1080 Ohms at 70 degrees F. Add 2 Ohms per degree F). 3.If resistance is not valid, replace sensor. 4.If sensor resistance and connections are good, then check for welded-closed relays on the control.
Here is the sensor to order if it is bad.
Posted on Nov 28, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
It is likely that the convection element is burned out and needs to be replaced. If all other functions are working then this is the place to start. Teh back panel inside of the oven can be removed by removing the 4 visible philips screws on it. The element should look smooth and round, if not then it needs to be replaced. Be sure to turn power off to the oven before replacing it. Remove the screws that fasten the element to the back wall and gently pull the element away from the wall an inch or so. the wires will be exposed and can be unclipped from the element do not let them fall inside of the back of the oven or you will have to remove the oven from the wall to get at the back panel. Install the new element in the reverse procedure. If the element looks good then it will have to be tested with a multimeter to verify that it is still good before proceeding to check the selector switch for burn marks.
Posted on Mar 11, 2007
SOURCE: bottom oven not working
If its brand new, most possibly the electrician did not bridge the mains connection. It sounds like an installation fault. There is usually a jumper between 1-2-3 on the L connection on the mains, and a jumper between 4-5 on the N connection. Oshie
Posted on Jun 26, 2007
SOURCE: No heat in the main oven
We had the same problem - turned out to be the fan oven element - simple to fit - remove the back plate around the fan (6 screws) to expose the element. Remove screws securing element and disconnect wires (mark wires before removing) Our replacement was £40, but take the original as there are quite a few variants - you will also need the full ENR number (on side of housing) However, be aware that if this does not work, the thermostat may also have blown with the element. We were lucky as replacing the elelment fixed the problem.
Posted on May 09, 2008
If the oven is electric and fan assisted,then I would suggest that the oven fan element is faulty.
Plz rate this solution.
Posted on Dec 17, 2008
Tips for a great answer:
Oct 22, 2016 | Ovens
Oct 26, 2012 | Frigidaire 30" Self-Cleaning Freestanding...
May 28, 2012 | Hotpoint SY36 Style Line Stainless Steel...
Aug 28, 2011 | Ovens
Jul 31, 2011 | Ovens
Jun 15, 2011 | Magic Chef 9112 Gas Double Oven
Feb 07, 2011 | Smeg SE399X/5 Stainless Steel Electric...
Jan 30, 2010 | Stoves Ovens
Dec 14, 2017 | Smeg Ovens
49 people viewed this question
Usually answered in minutes!