Error sending end of post message to me - Computers & Internet

should not apply to a HD.
Power-down and remove power cord from pc.
Check that the Power and Data cable for the 2nd drive are properly connected by removing them and reconnecting them at BOTH ends.
Reconnect the Power cord and restart the PC
Instead of Booting normally, enter the PC's BIOS instead. You never stated what make/model you have so I can not tell you what key to press to do that with....but it is usually F1, F2 or Del
You will need to go through the BIOS menus and ensure that the 2nd HD port is turned-on and is, in fact, recognizing the drive as being present.
post back with what you find.

Possible error in the operating software or there are files which are missing in the registry due to a virus .
You can try and restore or use the recovery to reset the PC to avoid the errors coming up .

Please post the exact error message and post some system info!

Yep, checked the number and it means nothing.
More detail please.

Correct.
Outlook is not the problem here.
Report this problem to your ISP.
Its very likely that a setting must be changed on their end.

In your email program once you send a message it will go from the outbox to the sent items. if there was any problem it would not appear in the sent items box, but would remain in the outbox and would post an error to you.
Now- go to tools,options, receipts tab, and put a check mark in the first box. And send your email as normal. That way when they open the email at their end you get a message that says they opened your email at their end.

please leave rating

what program are you using to send/capture your video?

have you tried to uninstall the cam software and reinstall?

try the latesd driver for the cam from HERE

you will need to select the options from dropdowns as you did not post the OS you are running

post back results and I may be able to assist more

Code 43 is a line error according to Panasonic.

I had this issue trying to send to a client yet I could send faxes to other #'s. So in my case it was a dead fax on the other end of the line.

I NEED A AARDVARK, DIRECT PRO Q10 INTERFACE (CONNECTOR) HOST TO BUY. CAN YOU HELP ME FIND ONE?
THANK YOU,
BRIAN MCBEAN

i had the same problem and i could not find any source to solve it. At the end I found a way to solve this naked problem. I put the the simcard to another mobile and send a message to any number and it was sent. And then ı had delete the mobile center number and retype again and save. And then take sim card out and put it in the Iphone... The happyy End.. :)))) its start to sending the messages... HURRAYYYYYYYYY :)))))))))