H3y i have a sansa clip mp3 player and i was outside and then it froze and it dont wanna turn on but it is frozin please help me what can i do

try removing the battery and putting it back in and see what happends. i not sure this will work

Sansa Mp3 player frozen? How to reset and...
Check out this tip posted here on this site.

You can't play a video on your Sansa Clip/sansa clip plus (based on pic you showed).
If your device is froze, press and hold power button untile device turn off (about at least 10 seconds); then turn it on and check it. If it's still frozen, turn it off again, plug it into computer and delete the video which makes it froze

Hi.

You have two Solutions.

Solution 1:

Resetting the player:
1. Slide and hold the Power switch up for approximately 20 seconds.
2. Release the Power switch.
3. To turn the player on, slide the Power switch up then release instantly.

****************************************************************

****************************************************************

Solution 2:
Updating the Sansa Clip Firmawre:

1. If it's not installed yet, download and install the Sansa Firmware Updater.
2. Connect your Sansa Clip to the computer.

3.1. Assuming there's a new firmware available, the following message will appear on your lower right task bar. Click on the balloon message:

*************************************

*************************************
3.2. 3b. OPTIONAL: You can also manually run the SansaUpdater from your programs files. Most likely it will be under All Programs > SanDisk > Sansa Updater > Sansa Updater.

4. Select the Firmware check box.
********************************************************************************************

********************************************************************************************

5. Click Download Now. Firmware downloads and updating starts.

********************************************************************************************

********************************************************************************************

6. Click Finish after the firmware has been downloaded.

********************************************************************************************

********************************************************************************************
7. Disconnect your Sansa Clip from the computer.
8. A "Firmware upgrade in progress" message will appear on the Sansa Clip's display screen. The device will turn itself off after the firmware is updated.

Additional Help:
Sansa Clip Manual Guide.


If you need any Further Help Just don't Hesitate Asking me.
Thank You For Using Fixya.
Good Luck.

To reset your Clip, try holding the power slider switch in the "On" position for 15-30 seconds. Release the power switch once the unit begins to power down.

the problem is when the computer freezes it sometimes can wipe the hard drive and can damage the mp3 player for good thus freezing it from turning it on and clearing the memory and thats it

Washed? Water damage is irreversible - that player needs to be replaced. Call Sansa and say your player won't turn on - don't mention water. See what they say.

Kindly provide me a driver of sanDisk Sansa® Clip MP3 Player driver for window xp as it is not found in installation CD.

Sansa Clip Player has some problem. I tried 4 sansa clip players (I purchased at Best Buy for Thanksgiving), and none of them work. Dont even try to exchange them, just return them back.

if you find out whats wrong tell me i have the same problem e-mail me at zdittric@telus.ent