Question about Nixon Player NIX0003 Wrist Watch
You may have
arrows inside bracelet.Arrows are pointing the way the pins must come
First you have to find out what sort of pins or even screws are used to keep links together.
Examine both bracelet sides and find the side where pin ends have a groove.
Start with a tiny screwdriver and start to unscrew one of the screws. If it turns, but doesn't come out, that means you have a pins instead.
For removing pins the best would be pin removing tool (approx.5GBP on ebay), but it's possible to do the job without it.
Take a hardened steel needle and blunt the sharp end to the approx. size of pin end diameter using any sharpening stone or sandpaper. Get an old towel and fold it to make a soft base for work (like small cusion). As you don't have a special bracelet holder you will need a pair of helping hands to hold the bracelet steady upright. You will need small hammer and pair of flat nose pliers as well.
NOTE: The pins MUST be driven split end out first, not vice versa. Make sure that the grooved pin ends are facing towel, not the needle and hammer!!!
Now place the watch on the folded towel, take that needle and smallest hammer you have and start driving the pin out using light blows. Do Not hit hard, as you will brake the needle, scratch your watch or even injure yourself. Watchmakers are using 45 gram hammer, so, calculate your strength of blows.
After a few blows check if the split end is coming out and when you see that the end is long enough to grab it with pliers, pull the pin out with pliers. When pulling, do NOT turn pliers, as pins tend to brake when twisted. Use firm grip and your strength to pull the pin without twisting.
After shortening the bracelet or adding extra link(s) make sure that the pins go back EXACTLY the same way as they came out- the blunt end first in the hole and the split (grooved) end last. Before doing that check remaining pins in bracelet to make sure that you put them back from the right side of bracelet.
It is recommended to use plastic hammer to drive pins back in or you will scratch or damage bracelet. If plastic hammer is not available use an old toothbrush handle (or some plastic item) as an absorber. Simply put pin into the hole as deep as you can with your fingers, put the toothbrush handle on split pin end and hit handle, not the pin.
Make sure that pin ends are flush with bracelet. If needed- hit few more times.
Don't forget to rate, please.
Posted on Jan 10, 2009
Tips for a great answer:
Feb 05, 2016 | DKNY Watches
Dec 15, 2011 | Timex Watches
Nov 29, 2011 | Casio Watches
May 23, 2011 | Timex 1440 Nylon watch
May 19, 2011 | Timex T5K018 Ironman Triathlon 30 Lap Flix...
May 19, 2011 | Watches
Aug 18, 2010 | Watches
Mar 05, 2010 | Watches
Jul 08, 2009 | Timex Ironman Triathlon 50 Lap Digital...
May 23, 2008 | Timex Advanced Data Link 53722 Wrist Watch
Aug 15, 2009 | Nixon Player NIX0003 Wrist Watch
719 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: