Question about Kenmore 36 in. 33212 / 33214 / 33219 Gas Cooktop

Open Question

Need Model number Kenmore 36 range with griddle

Can't find model number or it's worn away. trying to order a spark module to fix it (obviously no pilot on this model) range has an analog clock, timer, start, and stop cooking timers. there is a timed oven light next to the oven temp dial and a fluorescent light across the top of range. oven light and fluorescent switches are on the top left of unit.

Posted by on

4 Suggested Answers

  • 1 Answer

SOURCE: Both burners turn on when only one is needed

I just had the same problem- when I replaced the whole cartridge.
I repalced the infinite switch- do the one that gets the hottest- or do both.
It is easy to do- just write down the wiring diagram - make sure all power is off- cost of new switch was about $37.00
This solved the problem- however make sure to check the sizng on the new switch shaft as my old knob would not fit properly on the shaft of the new switch.
good luck

Posted on Jul 14, 2008

blueextc3221
  • 15935 Answers

SOURCE: have kenmore glass top cook top light remains on

Thanks for your question!

I'm sorry that you haven't received an answer yet.

The response rate on FixYa FREE questions is usually over 80%, but sometimes questions go un-answered when:
1. the question is unclear, incomplete, or poorly worded...
2. the question is mis-categorized - so the correct experts aren't viewing it...
3. the question requires an answer for something that cannot be explained online adequately...
4. specific training, tools, or equipment are required to avoid injury or death...
5. the Experts that are online simply don't have the resources to answer your question fully...

Please feel free to re-work your question if you feel one of these may be the reason.
Of course you are not required - but converting your question to a PAID one usually increases the reply rate as well.

Normal rates for FixYa are...
$ 9.99 answer for one question.
$12.99 Live Real-Time online chat or premium e-mail support.
$29.99 Live Real Time phone support
Sometimes FixYa will run specials for unlimited questions via monthly subscription or reduced rates for limited periods.


Consider the savings that can be had when an informed Expert can save you a $100 service call, or a $350 trip to the car dealership.
Your problem solved - guaranteed! Or your money back!!

If you don't want to pay - feel free to re-submit your question so it returns back to the top of the work queue if you still need help.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for helping with your FREE question

Posted on Sep 05, 2010

  • 1 Answer

SOURCE: kenmore elite 36'' glass top cook top beeps and displays eo 11

so does mine

Posted on Oct 02, 2010

  • 1 Answer

SOURCE: Kenmore flattop stove

how do I change the eye on my electric 2000 kenmore smooth top electric range

Posted on Jun 24, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I continue to get code F11 on my Kenmore Elite Gas Range Oven and therefore, I am unable to unlock / open my oven door. I have pressed and held down the STOP button as well as the oven light button.


Your model number should be much longer than 790 30 Open drawers and doors to look for the whole model number around the frame.

With the whole model number you can get more information at Sears Parts Direct. There are parts diagrams and user manuals and you can order parts.
http://www.searspartsdirect.com/



This site gives instructions for repairing F11 and recommends checking the temperature probe and tells how to do it.

How to fix Frigidaire oven error code F10 F11 F30 F31 etc AskGene com

Sep 10, 2014 | Kenmore ELITE 790 30 FREESTANDING DUAL...

1 Answer

Frididaire electric stove the oven has stopped working


Good Afternoon Friend, thank you for allowing me to assist you!

I understand you are experiencing an issue with the oven of your Frigidaire range. May I have your model number please? You can normally locate the serial tag (which provides your model number) in the storage drawer, on the right side. Also, think about what may have happened prior to this occurrence. For instance, did you notice any strange functions or any other error codes prior to this issue? Do the burners/elements work? With this information I can assist you better in pinpointing the problem.

Meanwhile, let's try resetting your range by either unplugging it or flipping the household circuit breaker to the off position. It is important to wait approximately ten minutes and then turn your range on. If resetting the power does not correct the issue, could you please advise me if the issue continues or provides an error code. Thank you! -Z

Sep 05, 2014 | Frigidaire Gas & Electric Stove/Oven/Range...

1 Answer

F14 Error


First please get the full model number of the range. Kenmore products are made by other manufacturers and the error codes will depend on the manufacturer.

Most likely, you have a Frigidaire range (for example a 970. model). Then the F14 code could indicate a problem with the P12 ribbon cable connector tail, a bad EOC (control unit), or touchpad. First try disconnecting and reconnecting that cable. Next the EOC should be replaced. Finally the touchpad should be replaced.

If this is a brand new range, contact Sears to get a repair person to fix the range. If you bought it used, see the above possible solutions.

I hope this helps.

Cindy Wells

Dec 24, 2013 | Kenmore 30" Electric Double Oven...

2 Answers

Looking for a manual for Russell Range cooktop Model #SFC-36-6.


I have the same Cook Top RUSSELL RANGE 36-6 with a defective spark Module. part # kool lite 6521
I found the owner in SAN FRANCISCO Russell Zipkin
Now under SELECT APPLIANCES 1 888 235 0431
They were of no help at all.

Feb 26, 2010 | Cooktops

1 Answer

Thermador cooktop ignitors won't stop clicking


I have the same range top. I am looking for the switch assembly. Do you know where I can buy this part? Please email me if you do. prboardman@yahoo.com

Dec 30, 2009 | Cooktops

1 Answer

I need a Thermador griddle control/ignitor & a light switch knob


We are Thermador factory authorized service and parts suppliers. Just contact us at:

http://www.fixya.com/repair/d499389-accurate_appliance_repair_service
and we can get your ignitor and light switch out to you asap.

We look forward to working you. Thanks, Ella

Nov 10, 2009 | Thermador 37 in. SGSX365 Gas Cooktop

2 Answers

Viking Burners keep on clicking! Anoying!


The causes to the clicking is that the ignitors could be wet, dirty (with grease caked on them or cleaning products or a bad spark module). The ignitors are the little white things on the side of each burner with a metal piece on top. If they are wet (let them dry out for 20 - 30 min on a high flame, if dirty sand the metal piece on top with sand paper or nail file. And if it is the spark module and u are technical, order one from the parts department for Viking. You will need ur model and serial # then find out if it is located under the burners or the rear of the range. There are several wires going to the spark module. Best way is to disconnect one by one and connecting it to the new box until all wires are switched from old to new module. Remember to unplug the unit before doing this because you may get shocked. Also if it is a sealed burner system that means that the burner bowls cannot be lifted from the range and water cannot seap under the burners then you could just change all 4 or six burner bases. Viking has adapted them throughout the many complaints and they are better now. Typical cost is: $350 - $400 if spark module is under burners, in rear = $500 - $600. Burner bases = 400 - 600 depending on number of burners and if it is with a venturi or screws. Good luck.

Aug 23, 2009 | Viking 31 in. VGSU101 Gas Cooktop

1 Answer

Thermador Gas Range - Griddle ignition will not spark


I have a Thermador Gas Range PG364GDBS - Oven, 4 burners, and center griddle. All are gas. The four burners and gas oven work fine. The griddle just stopped working, no spark. Turning on the griddle control, the gas valve opens(hear it), gas flows (smell it), but the ignitor will not spark (no loud or faint spark that I can hear). I got a replacement ignition device (mount at the burner) thinking it might be the problem, but still no spark. I checked the AC voltage at the terminal and measured 39 VAC between the terminal and ground. Not sure if that is the correct voltage. Any insights or advice would be great.

Dec 07, 2008 | Thermador SGS36GS Gas Cooktop

1 Answer

Broken griddle control


Hello
It sounds like you have a short. Replace the switch is very simple. Here are the Owners Manual and the Instalation Instructions.
  • Owners Manuals (1)
  • CCGP2720P.pdf (942.48 KB)
  • Jun 28, 2008 | Jenn-Air 36 in. CCGP2720P Gas Cooktop

    1 Answer

    Old kenmore gas cooktop with griddle


    If the knobs will not push down and turn, this indicates the gas valve stem has become contaminated with cooking debris. The only solution to this, would be to replace the gas valves. With the cooktop more than 10ys old, parts may be difficult to find. If you can find parts, they will probably be prohibitively expensive.

    Jun 28, 2008 | Kenmore 36 in. 33212 / 33214 / 33219 Gas...

    Not finding what you are looking for?
    Kenmore 36 in. 33212 / 33214 / 33219 Gas Cooktop Logo

    Related Topics:

    452 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Kenmore Cooktops Experts

    Dan Webster
    Dan Webster

    Level 3 Expert

    8205 Answers

     Fix Your Board
    Fix Your Board

    Level 3 Expert

    310 Answers

    Kolbrun...

    Level 3 Expert

    1184 Answers

    Are you a Kenmore Cooktop Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...