Question about Refrigerators

1 Answer

I need a service manual on a Kenwood chef A 901. The speed control does not work, and the pc board components info cannot be seen.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 700 Answers

Http:// try this link for the manuel and then you should be good to go. Thanks for using FixYa.

Posted on Jan 09, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Samsung RS253BASB SidebySide Fridge Not being Cooled

Probably bad fridge tstat sensing bulb (tstat)
possibly bad open heater in area of fresh vegetable bin
or damper assy not set correctly

Dec 08, 2007 | Samsung RS2534 Side by Side Refrigerator

1 Answer

Frigidaire defrost control board p/n: 241508001 Like seen on the picture had a piece burned , i want to know what is that compnent name and the component number or name. I'm electronics technician and...

we call that a bad board... you dont get to replace components on an appliance control board. just look for the least expensive place to buy a new board and order it.

Nov 02, 2013 | Refrigerators

1 Answer

Jen-Air JSD2989 AE, freezer works but the frig doesn't

Lets make sure that there are no frost build up on the freezer back wall like this=> HERE If there is a problem with frost building on the rear wall of the freezer the most likely reason will be the=> 61005988 Defrost Control Board

The defrost control board can be found behind the control panel inside the fresh food compartment just above the top chef. It is listed as part location 13 in this photo here=> JSD2989AEW Control Components
The next possibility will be the auto damper listed as part location 8 and that part number is=> 61005989 Auto Damper

Instructions on testing and removal of the auto damper and other repairs can be found here=> JSD2989AEW Service Manual
The other two possibilities are the=> 61006199 Defrost Heater and Defrost Thermostat

I will be here should you have questions, Thanks Sea Breeze

Dec 11, 2012 | Refrigerators

1 Answer

GE Adora model #DSS25KSRASS side-by-side - the refrigerator side is not staying cold and periodically quits working

This is a very common problem that comes with your model refrigerator. I need you to pull the refrigerator away from the wall, unplug power, remove the panel covering the compressor and feel the top of the compressor. Is the compressor too hot to keep your hand on the top? What I believe is happening is the control board or the start components are defective causing the refrigerator to cool off and on or periodically as you said. The solution may require a new control board=> WR55X10942 Main Control Board

and new compressor start components=> WR62X79 Run Capacitor


and the=> WR07X10057 Start Relay
Should you choose to repair your refrigerator I will happy to answer your questions. This model GE refrigerator has caused many complaints because of the expense and frequency of this type of repair. Many home owners are better off with a refrigerator that does not have a motherboard and uses simple defrost timers or defrost control boards. Here nis a link to a=> DSS25KSRASS Service Manual
GE ARTICA PROFILE TECHNICAL INFORMATION If you have questions please let me know, Thanks Sea Breeze

Nov 29, 2012 | Refrigerators

1 Answer

After a power outage the ice make didn't work. We defrosted and cleaned out all of the ice in the freezer and it still didn't work. Now there is water leaking out of the freezer and the fridge is...

The E/F error code is indicating a problem with the evaporator fan motor inside the freezer. It could be caused by a failed fan motor, control board or a loose wiring connection between the two components. The control board monitors the evaporator fan motor operation and speed. If the control board does not receive information from the fan motor or receives incorrect information because the fan motor has stalled out or is not running correctly "E/F" will display. This type of error code will require a service technician in order to diagnose the failure. I recommend calling a service technician to repair your refrigerator.

Sep 24, 2011 | Refrigerators

1 Answer

Model GSS25SGMCBS coil freezes.heater checkedout ok service man changed the circuit board for $312.After 3 days, same problem again. Freeze temp ok but refrigirator sectio quit working after coil freezes....

Control board is new, heaters ok, Check defrost thermostat and thermisters located on evaporator.
PC board not getting information to defrost properly.See site below

Also check the fill tube at ice maker . Iv'e seen these get loose and fill evaporator with water causing ice block

good luck

GE Refrigerator Repair Guide

Aug 16, 2011 | GE GSS25SGMBS Side by Side Refrigerator

1 Answer

Error code in the top zone E3

An E-3 error code on your product indicates a problem with the DC fan in the upper zone. Your issue could be with the fan motor, control board or connecting wire harness. A DC motor can not be ohmed out like an AC motor, so if you detrmine the motor is not running, check for DC voltafe at the motor connections. If there is 12 to 24VDC, then you have a bad motor. If no voltage is present, check the output on the board. Before replacing an expensive circuit board, you may want to have a professional service tech come out and diagnose your problem. ***ALWAYS remove electrical power from the product when removing panels to gain access to components, and also when putting the panels back in place.

Nov 04, 2009 | Magic Chef Refrigerators

1 Answer

The refrigerator is not keeping cool. The freezer is working fine

HI, ok, you have sated that the freezer is holding a proper temp. this will confirm proper compressor function. there are only two other problem areas that could cause the fridge to not cool properly. the diffuser and, the cold control device(thermastae). Have both components check for there operational value.

The most common issue here will eb a damaged cold control device(thermoste or , control board)

Jul 09, 2009 | Magic Chef CTB1821AR Top Freezer...

1 Answer

Ice will not eject from door.

their is a control board on back of the ref. this board controls most of the components to ref.i have seen alot of the ge ref. with same problem.replacing control board should solve problem but the board is very ice coming thru door worth a couple hundred dollars?

Jan 10, 2009 | GE Profile PSI23NCR Side by Side...

Not finding what you are looking for?
Refrigerators Logo

Related Topics:

156 people viewed this question

Ask a Question

Usually answered in minutes!

Top Refrigerators Experts

John Tripp
John Tripp

Level 3 Expert

4636 Answers

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides