Sole f80 stuck elevation - Fitness Giant Sole Fitness F80 Folding Treadmill

1st most likely: walking belt and deck.
2nd most likely: motor control board
3rd most likely: drive Motor
4th most likely: no/off switch.

if you sole f80 is less than 5 years old you have parts warranty.

1( test the voltage to the terminal , if there are voltage the FAN is faulty, change it.
2( if there are NOT voltage to the terminal FAN, test the line why are NOT coming voltage, test some fuse, or c. breaker, tight any plug, connector, or loose wires.
3( Try again.
see the block di attached. and fix it.
God bless you

adjust the REED SWITCH, see the diagram attached, clean it and tight the wires connector very well.
tight the ribbon cables insides from keypads +tight the wires connector from display board vs lower board and clean it.

God bless you

1) Lube the deck belt, this problem is lack of maintenance, maybe the deck belt is worn.
2) You must align the deck belt see the diagram
3) Lube the rollers bearing very well very important too
see the video: God bless you

Dear Sir:
1) Lube the deck belt very well, as your instruction manual indicate for maintenance.
2) Try to Run software calibration after you fix it. For easy diagnose and troubleshooting.
3) The elevation motor can be faulty for lack of maintenance too, again Run the software calibration.

sincerely. God bless you

hai , check communication cable, speed sensor

hi, check incline sensor wire may be discount

hi, please check 12 pin cable form controller to console

John what are you talking about. All that's gonna do is give a LS error if you disconnect the motor.

It sound like the motor control board is the culprit. Unplug unit then remove shroud then find the 2 leads that connects the motor to the motor control board disconnect them then plug in unit and see if the display blackout after programing the display then hitting start.