I have no display and i checked the braker box

unplugging it while it was runnong shouldn't damage it, probably just the circuit braker. check to see if there is a button or some type of circuit braker on the unit and reset it, if it does not have one check the circuit braker that supplies it power. (in your braker box)

Sound you have a big problem on electric system,Check with a qualified mech. or elec.to avoid setting fire on bike.

Did you reset the house circuit breaker to the oven. If the stove is only getting 120 volts instead of 240 the display will light but no heat. A remote possiblity could be a burned wire at the power connector where the main powewr comes in to the stove of a bad comnnection in the junction box.

You may have a bad heating element. But first make sure you have power to the gfci. (check the braker) You can test this by disconnecting the heater leads and see if it will reset. If it still trips try disconnecting your equipment one at a time, ie. blower, ozone, circ pump, booster pumps. If nothing solves the gfci issue you need to replace the gfci. All of this is assuming you have a blank gfci receptical monted to your spa pack.

If your talking about the 50 amp gfci at the braker box try pushing the braker all the way to the off position then back to the on possition. If it trips right away do the above.

Call a licensed and experienced electrician. Most ranges run at 240 volts (hence the 4 wires). Inexperienced persons working on electrical wiring can result in injury, fire and even death.

sounds to me that the breaker is getting weak,try replacing breaker with new one,if it still trips then you have electrical problem in a circuit.

The V1500 is in essence the same as Infinity 26. Rinnai have manuals on their website.

Here's a link

http://www.rinnai.com.au/images/stories/operating_instructions/Hot_Water/All_Continuous_Flow.pdf

If you have any specific problems or queries just post them on this site. I check it every few days.

Cheers

they ussually have a circuit braker, some times built into the switch sometimes circuit braker is in the fuse box. also look under the hood for a burnt fuse link. yhey are usually in a little plstic box mounted on the fender

There is a red reset on the outdoor unit, near where the copper lines connect to it, also there should be fuses in the disconnect box, near the outdoor unit, that the electrician installed.

The orange wire is the power wire for both seats.It gets its power from the power seat circuit braker (20 amp) located at the body relay block.It is located behind left side of dash near fuse block. Remove circuit braker and check for power in body relay cavity that you pulled the relay out of if power is on one side change circuit braker and if no power on either side then you have a bad main fuse near battery or under hood in main fuse block. Joe ASE Master Tech