Question about Projection Televisions

1 Answer

Color bar I just bought a 42 inch Panasonic 1080p plasma HDTV. Just turned it on today and a 1 inch blue/green bar is running down the center of the screen on all inputs/componets

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 33 Answers

Sounds like the TV is defective, if I were you I would take it back. There probably isn't much you can do on your own to fix it.

Posted on Jan 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

TC-P42ST30 power light blinks twice,replaced power supply board,no change.What to replace next?


Are you SURE you get 2 blinks? I show NO 2 blink code in the 011 model Pana plasma sets. Anyway...if you replaced the PS board and still get a code, unload the VS supply from the SC board and re-check--see if the VS supply comes up--even for a couple of seconds...about 205 volts or so. If it does--re-connect and see if it then does not come up. If not--then the SC board is likely bad (THE most common failure on ANY plasma set is the Scan board ).

Nov 24, 2014 | Panasonic VIERA TC-P42ST30 42-Inch 1080p...

1 Answer

JVC Hd56fn97 56-inch 1080p Hdila Rear Projection Tv with all blue color green


Talk to JVC as I have suggested and this is likely a known problem: loss of any color, picture upside down etc requires a upgrade to correct and I have seen about twenty sets with their name like this with this kind of problem.

Dec 11, 2012 | JVC Hd56fn97 56-inch 1080p Hdila Rear...

1 Answer

I have a 42" Hitachi HDTV Model Number 43UWX10B which I bought 12 years ago. I was having problems with the color about 2 years ago, and replaced the part, but now I am having similar problems where...


Over time a thin layer of fungi grows over the top of your BLUE CRT preventing light fronm shining through. This causes you to loose the blue color in your set. Check and clean. Also when the back is off your set check to see if your blue CRT is on. If not you may need to replace it.

Aug 14, 2010 | Hitachi 42V710 42" Rear Projection HDTV

1 Answer

Red color woun't converge


Needs convergence amp circuits repaired.

Apr 12, 2010 | Panasonic PT-53WX53 53" Rear Projection...

1 Answer

42 inch hitachi plasma


the more the tv remains on the picture gets out of focus mainly in the midle of screen. Sure sounds like tv needs some light engine repair or replacement.

Aug 11, 2009 | Hitachi 60V500 60" Rear Projection...

1 Answer

Panasonic Plasma TH-42XVS30U, turning on the unit, blue light comes on the screen, the box blinks red twice, the screen shuts down. :(


There is a problem with scan drive 3 boards involved. Best solution and least expensive is call a authorized panasonic service center.

Apr 25, 2009 | Panasonic PT-50DL54 50" Rear Projection...

1 Answer

Projection tv 42" panosonic hdtv. to much green in the picture. Jeff


this unit may have a resistor on the green crt-board that has increased in value. check ohms(resistance) on all crt boards and compare to one another. these will have color bands that inicate value of resistance. you do not need to know color code, just match colors of resistors on each board then measure. you could also have weak green tube. turning down the master screen control located on the fous/screen block can reduce grn. drive. to adjust proper drive for each so the grey scale is correct, turn color to tv all the way down then adjust screen controls on block for black & white picture. when color is turned all the way down, you should not have any green, red, or blue over cast on screen. mch

Feb 20, 2009 | Panasonic PT-51G35 51" Rear Projection...

1 Answer

Setting Color on TV


Hi Amber3,

I would recommend reading the information available on Panasonic's website. There are links for Frequently Asked Questions (FAQ) which may be helpful.

The manufacturer's website lists in their FAQ the Panasonic plasma TVs include an enhancement feature for blue and green colors, and instructs how to turn the feature off if needed. Visit http://www2.panasonic.com/webapp/wcs/stores/servlet/vSupportFAQDetails?idval=UCM_PRD_CNT_001993&pagetitle=FAQs+for+Plasma+TVs&contentType=FAQ#tv17 to see what Panasonic recommends.

Thank you,
Jason,
Go Ahead. Use Us.

Jun 13, 2008 | Panasonic PT-47WX49 47" Rear Projection...

2 Answers

42 inch sony grand wega


http://www.somelifeblog.com/2007/06/sony-projection-tv-red-line-repair.html

Jan 14, 2008 | Sony Grand WEGA KDF-42WE655 42" Rear...

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

yadayada
yadayada

Level 3 Expert

60867 Answers

Are you a Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...