- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Start/Control Panel/Network Connections and right click on Wireless Connections then left click on Repair
This works sometime. Also you might want to restart your modem as well as your computer to get everything in sync.
The issue I see is that the lights all are lighting up. I'd bet it is caused by some type of short or like a power outage or surge (remember surge protectors basically do nothing at all). If I were to guess, that's it. Other than that, I would flash the firmware back to original if it lets me.
Reboot your modem, router, and computer. Power them all down (unplug the modem and router if necessary) then boot the Modem, then after a minute boot the router, then your PC and see if all is well, it should be.
You need to reset the router if the lights are flashing. Press the reset button at the back of the router for about 20 seconds then release it. Now unplug the power for 20 mins as well and plug it back in. Make sure your connection is right. PC connected to port 1 and modem to WAN or Internet port.
You dont need both. Do the following: Unplug your speedtouch from the phone line at the back of the speedtouch unit. Plug that cable into your Zoom. Then plug one end of an ethernet cable into router and one end into your PC.
Type http://10.0.0.2 into a web browser (eg. Firefox or Internet
explorer) username/password is admin/zoomadsl go to basic setup and
input your ISP username and password (the one given to you by your
internet provider) under PPP. Click configure my connection. Save
changes and then write to flash (both buttons on bottom of page)
the inter net light should blinks dont worry>
delete all teh temp cookies and files and clear history>and change the ether net cable
change the dns to global like
start-->control panel-->network conn-->right click on local area conn-->click on properties-->and highlight tcp/ip-->click on properties-->and select use the current following dns
DNS 1) 18.104.22.168
DNS 2) 22.214.171.124
click ok>and restart the pc and rate me solved if its help full thx