Error code f 50 - Whirlpool WTW6400SW Cabrio Washer

Question edited for clarity and spelling of Rieju / Reiju.
Question moved from Cars and Trucks.

This is your Workshop Manual and the section on errors.

https://www.manualslib.com/manual/1088567/Rieju-Mrt-50.html?page=68&term=error&selected=1#manual

Owners manual and equally as useless, although it does give some maintenance tips.

https://www.manualslib.com/manual/1079411/Rieju-Mrt-50.html

This gives some clues in the Aprilia Forum.

https://www.apriliaforum.com/forums/showthread.php?320791-Electrical-issue

It is often a problem buying unknown makes and trying to get support. None of the manuals give contact information.

https://www.google.com/search?q=2013+rieju+mrt+50%2C+error+code+05

..

If you are facing Fix Error Code -50 In Windows issues, simple visit website for online solution by Error Support expert.for More Information Visit: https://www.errorcodeexpert.com/how-to-fix-error-code-50-in-windows/ Our Call for Help +1-866-748-5444

Precor Error 50, Too Much Brake (Magnet) Current Probable Cause 1. Shorted or damaged wiring between the lower PCA and the eddy current magnet is the most common cause for this error.
2. Bad eddy current magnet.
3. Bad lower PCA.
Corrective Action

1. Thoroughly inspect the eddy current wiring and connections ensuring that the wires are not shorted to the frame or shorted together. Repair or replace damaged wiring as necessary.
2. Disconnect the wires from the eddy current magnet. Using an ohm meter, check for approximately 100 ohms across the eddy current magnet terminals. If the reading is considerably low, replace the eddy current magnet. Measure ohms between each eddy current magnet terminal and the frame ground. You should have no resistance between the eddy current magnet terminal and the frame ground. If resistance is present this would indicate a partial short, replace the eddy current magnet.
3. If the eddy current magnet wiring and the eddy current magnet are both good from the above tests, replace the lower PCA.

Error 50 Too Much Brake Current on Precor Cardio Equipment

hi good day! the printer is error 50 due to a paper or some sensor error.. open the printer, or dismantle, clean the sensor and wash the pump of water and change the waste pad of new absorber. locate the sensor under the pump, clean it of alcohol.

On Hewlett Packard printers a "50" error code is a fuser error.

Precor uses the same error codes for all of their units. Error code 50 is for excessive brake (eddy current magnet) current.

Machine error 50 is a error in Purge unit.You can't fix it by yourself and your printer need service.In most case the cost of repair is more than cost of new printer.

I am not sure this will stay fixed but after i cleaned the pcb's and checked the connections and let the unit sit overnight the printer works just fine. If this does not stay fixed I will contact you again.
Thank you,

50 error is the fusing assm. You need to replace the fuser then the error will go away.
hope this helps.