A901 has stopped working

Https://www.Youtube.com https://www.youtube.com/watch?v=k6KnyKq6gCU

the speed control on my kenwood chef A901 is not working
how do i fix this.

Hi there I am trying to get hold of a copy of the service manual for the A701A mixer.
Would someone be able to send me a copy please....
email is simon@locom.co.uk
thank you to anyone that can help.

Check your brushes on the motor, if they are good then its the windings that are burning out.

Mezo.

My chef A901 started to smell and leak oil. I started to dismantle it but found that a service manual is needed. Kenwood will not supply this for "Health an safety" reasons. can anyone help please.

I sent to the UK for the replacement parts

Found a kit on ebay for 9.99 which fixes the speed cntrol problem on 901 chefs do a search for kenwood motor repair comes with instructions you would need to be ok with a soldering iron

there is a kit on ebay for both 701 and 901 kenwoods requires use of soldering iron do a search for Kenwood motor repair it is unlikely to be the motor usually the speed contoller components

I have just had the exact sme problem.
It is caused by a 1 watt resistor on the board.
You will also find that very possibly the large capacitor, a 0.1uF, has aso burnt out. This capacitor would have cracked open down the side and that is where the smoke came from.
parts can be replaced by a repair man and possibly a better solution is to have the board replaced, They are availiable still.

It is possible that the drive belt has broken. It is located under the housing on top of the mixer but you need to remove 2 screws under the housing then remove the 3 retaining screws on the drive mechanism. The top of the housing will then lift off and reveal the drive belt. Caution this is not a DIY job for non mechanically minded persons and as always make sure the equipment is disconnected from the power supply. If in doubt seek qualified assistance.