Question about Dayton G73 Utility Heater

1 Answer

Heater location I have a 20 by 20 garage. Can this heater be ceiling mounted in the corner of the garage, with the heat direction blowing straight forward and still adequate heat the garage? My only other option would be to use the single bolt mounting application, and change the direction of the airflow to the center of the garage. However, a single bolt application concerns me with a 20lb plus heater. Any idea of the length of lag bolts to be used with this heater?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 96 Answers

Your best way is get all thread rod and cut to size

Posted on Jan 06, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Repairman can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Repairman (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When the heat is turned on only the passenger side gets warm. All the vents (defrost, vent, and floor) on the driver side only blow out cold air.


check the actuator motor on the heater. It is on the bottom of the heater inside mounted to the heater box. The motor moves the arms on the heater doors and directs the heat.

Jan 08, 2016 | 2007 Lincoln MKX AWD

2 Answers

Why won't my heater in my 2001 chevy suburban wont blow hot air


The heater control operates a valve in the engine compartment allowing an adjusted amount of hot engine coolant to circulate thru the heater coil located in the heater fan box. If the valve is stuck in a closed position it will not let heated coolant pass thru the coil. Most often on vehicles with some age, the heater coil gets clogged by residue from heated coolant. If this is the case, try to back flush the heater coil. I have used a small pump and a coffee canister for a reservoir and attached temporary hoses and flushed a mixture of water and a type of radiator cleaner thru mine with much sucess. Try flushing for a few hours in one direction ...then, switch the hoses and flush in the other direction. It takes awhile , but is much cheaper than buying and installing a new heater core.

Sep 26, 2014 | 2001 Suburban 1500 Heater/AC Control...

2 Answers

Where can i buy a thermostat for my heater fhu5-4b part # 5813-2050-000 Thanks Tom


Northern Tool sells ceiling mount Fahrenheat Heaters Try them, they may have it as an accessory or optional item.

Feb 09, 2011 | Fahrenheat Ceiling-Mount Industrial Heater...

2 Answers

Installed my second Fahrenheat FUH 724 7500W heater in another garage. Installed same as previous heater that works perfectly. used 10 Gage wire and 40A 240V breaker (2-20A). Wiring is correct. Heater...


Could be either. But, I suspect that wiring is getting hot enough to trip the breaker. Check all of your wiring to see if there is a hot spot or insulation melted.

Feb 05, 2011 | Fahrenheat Ceiling-Mount Industrial Heater...

1 Answer

Hello I have a Fahrenheat Ceiling-Mount Industrial Heater 240v rated. Can I use a 220 plug to wire it and connect it to my 220 aux plug in my garage? If so how should I wire it to the heater itself?


Sorry to read about your problem, I hope this helps you out.

you will have to install a 30 amp breaker, and make sure the wire is rated for 40 amps, or 110% of 30 amps, you can wire direct to the heater if you wish.

I tried to help you. Please help me and Rate/Vote on my response. We take the time to answer your question's. take the time to rate us.Thanks and good luck

4 Thumbs - Very Helpful
3 Thumbs - Helpful

Jan 03, 2011 | Fahrenheat Ceiling-Mount Industrial Heater...

1 Answer

I have a 724 heater7500 w 28x32x10 garage with dog door it will only keep garage at 40 degree not 50 like i want in minnesota what are my options


Hi,

The heater is too small for the space you are heating....

You need to get a second heater or get a bigger heater to get more heat...


Heatman101

Nov 30, 2010 | Fahrenheat Ceiling-Mount Industrial Heater...

2 Answers

Laser 30 model won't heat my 24'x24' Garage?


heating and cooling is rated in btu.or could be watts.for your space to be heated quickly to say 70 deg f. you may need a heater with a rating of 36000 btu.it will heat u up then shut off.if you use a smaller heater it will take longer to heat thus using more energy for the same results.

Jan 07, 2008 | Rinnai Toyostove Direct Vent Heater: Laser...

Not finding what you are looking for?
Dayton G73 Utility Heater Logo

Related Topics:

139 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dayton Heating & Cooling Experts

Paul Carew

Level 3 Expert

3083 Answers

Mack Baxter

Level 3 Expert

383 Answers

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Are you a Dayton Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...