Lexmark 352dn 31 missing or defective cart - Lexmark E352dn Laser Printer

Please verify the firmware code on your printer. If its lower than the code below and the printer can go into a ready state after POR, I would suggest you contact Lexmark Technical Support and update the firmware of your printer.

Base Code br.h.p204
Engine code br.mp.e202


Hope this helps.

31.05 Missing or invalid print cartridge

Check connection J14

Connector name and description SC (smart chip)

The cartridge toner chip no work, change it.

En este art?culo se describen los pasos para solucionar problemas, por favor visite el enlace http://bit.ly/l7yPlU

Para m?s informaci?n, p?ngase en contacto con Lexmark Soporte T?cnico

Traducci?n con traductor Google

Hello

need more clarificaton!!!!

Service Fuser Error appears when the fuser does not warm to the required temperature. For this error on this Lexmark model T632, the manual states you should power off the printer and power it back on, and if it is not plugged into a wall power point, change it to a power point mounted directly on the wall. Personally, I never got a Lexmark printer to work doing this, but this is in the manual. If this won't help, and the printer is under warranty, you should log it in with the servicing company.

If the printer is out of warranty, your next option is to change the fuser which costs around $90 on Ebay.

y lexmark x73 manual de impresora lexmark t612 lexmark z710 free driver lexmark cartouches imprimantes gros lexmark 4270 error 1203 tiger direct lexmark fax ...
www.chippewacountyabstract.com/.../information.php?id=lexmark -

Possible causes here are;

Most likely, the contacts in the printer not touching the chip properly (hence why it works in another printer). A simple gentle 'tweak' would work in this case.

The other possibility is the firmware version of the (offendig) printer being incompatible with the version of the after-market chip you are using. No solution here, other than trying a DIFFERENT MAKE of chip.

Hello there,

In my experience I've never come across an error #12 on a X4270. I've seen an error 1200 & error 1203 a couple of times. Did you get this error after installing a new cartridge? then there are chances that the new cartridge that you installed is defective. The best way to figure if out is to take both the cartridge out and power recycle the printer with the cartridge out. Check out if the operator panel says "cartridge missing" when it is powered back on. If it doesn't say "cartridge missing" then the printer hardware is defective. You would need to get it serviced. If the printer comes up with "cartridge missing" message, then either one of the two carts that you have is defective. I would suggest you to insert one cart first and close the cover and check if it says "cartridge missing" If it does come up with that message then insert the other cart too.. If you get Error 1203 on after inserting a cart, then that cart is defective and needs to be replaced.

Merry Christmas!

Error code 31 is displayed when the top front cover is closed and a defective print cartridge is detected. It may take the printer 10-20 seconds to determine if the print cartridge is defective.

Replace and reinstall the defective toner cartridge.

Try changing the photoconductor kit