Question about Dean Vendetta XM Electric Guitar

Open Question

Wiring diag for a marlin sidewinder

1973 model 1 humbucker 2 single coil with toggle switch and 5 way switch,plus 2 tone contol and one volume control

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 10 Answers

SOURCE: Problem with volume dials in an electric guitar.

If you can't clean the pots or if you just want to try replacing them, try using
500k pots again, in case one or both of the pots is worn or dirty or
defective. If that doesn't work, and cleaning or replacing the
switches doesn't work, then the problem is probably elsewhere.
You could put a 500k resistor (with a sufficiently-high power rating of at least half the power rating (Watts) of the pot) in parallel with the pot, or, to cover all bases, put a 500k resistor from each of the two outer lugs of the pot to the middle lug. That should change it into the equivalent of a 250k pot. You could even just temporarily clip the resistors on, with alligator-clip leads, if you're very careful, just to test it.

Good luck,

The dude.

Posted on Aug 07, 2008

Ad
  • 5603 Answers

SOURCE: I need a wiring diagram for a dean v bass (ev or

Match your resources of your guitar at this site to find typical schematic:

http://www.guitarelectronics.com/c=t6JiCQzmaFtGBjJUnATWv1XQ2/category/wiring_resources_guitar_wiring_diagrams/

Posted on Jul 30, 2010

  • 94 Answers

SOURCE: Dean Bass , single pick

GO TO KIJJI

Posted on Oct 25, 2010

sparky1500
  • 1066 Answers

SOURCE: i recently purchased a dean "dime-razorback"

here is a wiring diagram for another washburn. its not gonna be exactly like your set-up, but it should be pretty close. its really not that hard to rewire a guitar, i did it when i was like 12 years old, and the worst thing i did- wired the volume pot backwards. the diagram im seeing is differrent from any guitar ive prevously worked on, but it should be pretty accurate for a washburn.

http://i83.photobucket.com/albums/j298/BlueBuddhaibanez/Picture12-1.png

those dimabag darryl guitars, lke the bronze ones, are really cheaply made.

Posted on Nov 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where can I find a wiring diagram?


if your replacing the existing pots. the values should be on the
backs of them. usually 500k for volume if using humbuckers and 100k for the tone pots. if your using single coil pick ups. its usually 100k across the board. but if you still need a diagram. what is the make and model of the instrument?

Aug 16, 2014 | Music

1 Answer

Tone changes in pearly gates pick up


What you describe sounds like pickups fighting against each other meaning, does this occur when using pickups individually or together? This is normal when using more than one pickup together, if it occurs in single mode, something is wired wrong. Another thing is, If using single, are you splitting coils? Individual coils wired wrong can do this, a bad pickup selector switch can also. A loose wire or fiber touching the tone pot capacitor or ground could also. A dead coil on a humbucker can as well. I'm guessing that you are using these in combo meaning a possible pickup selector switch may not be switching properly. The player's level of experience is also in my mind since, all of my guitars do the exact same ONLY when I use more than one pickup. I hardly ever use more than one at a time unless I'm playing a strat.

Mar 28, 2014 | Seymour Duncan ShPg1 Pearly Gates Pickup...

1 Answer

Guitar pickup wiring diagrams


That guitar features two single coil pickups when stock. If, however, you or someone else installed a 4 conductor humbucker in the neck and you want to access other tonal options, check out the Seymour Duncan web site- they have tons of easy to understand diagrams- you just need the soldering skills to make use of them!
Make your selections on this page and good luck!
http://www.seymourduncan.com/support/wiring-diagrams/

Dec 08, 2013 | Fender Squier Classic Vibe Telecaster 50s...

1 Answer

My Dean Dave Mustaine signature V will not produce any sound


It looks like you have 2 humbuckers (how many wires on each?), one 3 way selector and 1 volume and 2 tone controls, plus the output jack. Tell me how many wires on these humbuckers and what colors and I can help you wire it.

Mar 28, 2013 | Dean Guitars Dean V Dave Mustaine Guitar,...

1 Answer

Wire diagram samick gregg bennett guitar


Here is the wiring diagram for a 2 humbucker, 2 volume, 2 tone, 3-way switch setup. The wires off the pickup may be a little different. Just attach the lead wire to the arm of the pot and the ground to the ground on the top of the pot. Should be very strait forward.

http://www.seymourduncan.com/pdfs/support/schematics/2h_2v_2t_3w.pdf

Nov 07, 2011 | Samick Greg Bennett Avion AV-3 (Black)...

1 Answer

I did not get a manual with my Evo XM guitar and amp pack, and my experience with electric music making is limited at best, so here is my basic question; what are the functions of the two knobs and the...


I don't know precisely, but since it is a dual humbucker and only has 1 switch and 2 knos, the knob nearest the neck is probably the volume, and the other is the tone. The switch should select which pickup is in use, towards the neck for the neck or rythym pickup, and the other way for the bridge or lead pickup. If it has a centre click position, that will be both pickups on together. If one of the knobs has a pull position, that will likely be a single coil switch for the lead pickup.

May 03, 2011 | Dean Evo Xm Electric Guitar Natural...

1 Answer

How to add a tone control to a Rare Earth humbucking acoustic pickup?


here is a diagram on how to add a tone control to humbuckers.

http://sthac.free.fr/pictures/sthac-HSH-wiring.jpg

for your set up, all u have to do is to do is wire the positive parallel form the pick-up or volume knob into the middle lead of the pot, wire the negative parallel to the casing of the pot, and put a .022- .033 ohm capacitor from the casing to the pot lead on the right, when viewed from the bottom. wiring parallel means "tapping into" the circuit, not rerouuting the circuit.

Nov 30, 2010 | Fishman Rare Earth Pro-Rep-102 Humbucking...

Not finding what you are looking for?
Dean Vendetta XM Electric Guitar Logo

Related Topics:

356 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dean Music Experts

Michial Gueffroy

Level 3 Expert

1138 Answers

Rick Moore
Rick Moore

Level 2 Expert

66 Answers

Matthew Spark
Matthew Spark

Level 3 Expert

1066 Answers

Are you a Dean Music Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...