Question about Korg PS60 61 Portable Performance Synthesizer KEY ESSENTIALS BUNDLE

1 Answer

My Korg PS60 sounds veey low with Headphones . i didnt plug it to an Amp yet ( Id just receve it yesterday ). Headphones Sounded also just in one side. I had to buy a Plug Stereo converter . Is this normal .?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Korg Master
  • 5,603 Answers

It is NOT normal... Apparently one side of the audio drive is bad, Take it in for WARRANTY repair immediately. Also read your manual in regards to "Panning" and any settings for it.

Posted on Nov 08, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: Korg mini kp only some effects working. Low sound output

I have the same Kaoss Pad mini and have exactly the same problem. I have asked for a solution as well!

The only way I have been able to use live is to turn up master on mixer to compensate, but this is incredibly hard to do if you're not always going through the KP as you have to adjust master volume each time up or down.

I haven't heard any volume problems with the full size Kaoss Pads, think it might just be a KP mini problem.

johnclark

Posted on Aug 22, 2009

  • 5603 Answers

SOURCE: i have a concert 2500...and

The power amp driving the dead speaker has gone bad or if you are lucky only a cable has fallen off. Open and inspect unit.

Posted on Mar 05, 2011

  • 5603 Answers

SOURCE: The pitch bend of my

The first thing is to verify that it is supposed to work with a particular performance. NOT ALL voices support modulation as well as pitch bend and with an arranger you can turn this feature on and off, usually in the utility functions and then save the setting for each performance/song. Read you user manual about modulation. On page 271 of your manual they show that the joystick is assignable. You have to assign the functions to the effect you want.

Posted on Jul 30, 2011

m_peel
  • 76 Answers

SOURCE: my ps60 has a high

Hello Brian, It could be a ground loop problem, I usually get something similar when connecting a laptop to an amplifier. You can purchase ground loop isolators from car hifi places which are used to take ground loop problems out of car audio systems. They are very cheap so maybe worth trying this first. I got one for £12. They have stereo RCA input/outputs and require no power.

Hopefully this is of help to you.

Posted on Aug 09, 2011

jaronium
  • 2 Answers

SOURCE: I have a new kaoss kp and when I put headphones in

The Mini KP is an effect processor primarily. Sound passes in and through either with or without processing and effecting. Due to this fact you must have an incoming signal to process, or you wont hear anything. However there are a few settings that act more like a synth and tone generator.To initiate an effect you must touch the pad and hold contact. There is a hold button on the lower left side facing down. If you hit this button while an effect is being created, then you can let go without the effect stopping. You can adjust the effect in real time as well. Out of the 99 presets if you have tried them all with absolutely no sound output, then the problem is physical and will need a repair man/woman.

Posted on Sep 28, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

The line output of the Korg pa 50sd is not clear.It trembles.Can any body give a solution?


If the problem still exists after trying multiple cables and speakers then the problem is either the jack itself or the amplifier in the unit. This should easily be fixed by an authorized service center.

Jan 01, 2015 | Korg Pa50 Professional Arranger Keyboard...

1 Answer

My korg ps60 shuts off after using it for a while . The led screen goes white with no response


Open it up feel the transistors and chips one is getting hot make a cool element for it from aluminium or use ney arctic silver padte between the transistors and the cooling plates

Nov 08, 2014 | Music

1 Answer

I can hear only one side of the sound coming out from Korg triton extream keyboard. It's not the cable problem for sure. i tested both the earphone out put and the Left and right out put. Did a


So you're saying with headphones you also only hear one side? I would suspect the internal amp is panned all to one side. There are also several other settings in this unit where pan can be set so you may have to check several areas. If you don't have any specific custom settings made I would try a restore to factory defaults. If that doesn't resolve it you likely have a hardware failure which is likely not repairable. I strongly suspect a panning issue though.

Aug 18, 2012 | Korg Music

1 Answer

My ps60 has a high freq noise with a regular pulse pattern it does this thru mymixer and also when i plug it direct into amp cheers Brian Garbutt


Hello Brian, It could be a ground loop problem, I usually get something similar when connecting a laptop to an amplifier. You can purchase ground loop isolators from car hifi places which are used to take ground loop problems out of car audio systems. They are very cheap so maybe worth trying this first. I got one for £12. They have stereo RCA input/outputs and require no power.

Hopefully this is of help to you.

Aug 08, 2011 | Korg PS60 61 Portable Performance...

2 Answers

How to perform a factory reset?


1. Power-off the PS60.
2. While holding down the four PERFORMANCE buttons and the OCTAVE DOWN button, power- on the PS60. The PS60 will be initialized, and the factory-set data will be written into internal memory. The display will indicate "Initializing..." while data is being written. Never turn off the power while this indication is shown.

Manual available here:
http://www.korg.co.uk/downloads/ps60/docs/PS60_OM_E1.pdf

Jun 24, 2011 | Korg PS60 61 Portable Performance...

1 Answer

The amp power light comes on but there is no power / sound .


Do some tests: Plug a set of headphones into the line outs and tell us which ones if any have sound. Note that only one side of the headphones may have sound and it may be low volume. We need to know if anything is coming fromt he preamp. Makesure the output switch is set to one of the speaker on positions and not just phones.

May 14, 2011 | Roland KC550 Amp Keyboard

1 Answer

My Korg CX-3 Combo Organ turns on, but when it's plugged in to an amplifier, I don't hear anything and it doesn't generate any sounds except for a clicking noise when hitting the key. I hope you can help...


From the user manual troubleshooting:

No sound

• Are the other devices or headphones connected

correctly?

Check the connections. ........................................ (see p.6)

• Is the power of your amp or mixer turned on?

• Is the [MASTER LEVEL] knob raised?

• Is the Global mode Group 4 "MIDI Local" parameter

turned On?

Check the setting of this parameter.

• Are the bars of Drawbar 1 or 2 pulled out?
Pull out some of the bars.

Also check out this site and scroll down and do the "Factory reset" by holding down the buttons they say... AND please note that you have to hold them for a while during this.

Mar 08, 2011 | Korg Cx3 61Key Modeled Combo Organ

2 Answers

No sound


1. plug in some headphones into the jack.
2. connect to an amplifier or external source.
3. connect midi to a midi-compatible device and determine if device receives signal by pressing keys

If #1 or #2 passes, your speakers are bad.

If #1 & #2 fail, but #3 passes, your setting are set so that there is no sound, but the keybourd still recognizes input.

If all three fail, the keys do not send a signal at all, you should replace the keyboard.

Dec 19, 2008 | Korg Pa800 Synthesizer

Not finding what you are looking for?
Korg PS60 61 Portable Performance Synthesizer KEY ESSENTIALS BUNDLE Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Korg Music Experts

Vito Vacirca Jr.

Level 2 Expert

140 Answers

J.D. Browning
J.D. Browning

Level 3 Expert

2760 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

14921 Answers

Are you a Korg Music Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...