Question about Televison & Video

1 Answer

Grren light flashes, then turns red. No picture, only sound

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Televison & ... Master
  • 14,553 Answers

A brand and model number are needed for a possible answer or help please.

Posted on Nov 07, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

SOURCE: samsung hcm4216w

The most common problem for those symptoms are convergence amps. That unit takes two stk392-040 Sanyo Ics and will most likely require that several low ohm resistors (3.9 ohm-2w) be tested and possibly replaced.. There is one last thing also, a pico fuse at Fd102 (3.5a) that sometimes opens and would need to be replaced..
The convergence board in these is easily removed, so an in-house service call could be done...
Hope this helps

Posted on Jan 19, 2008

djnick989
  • 1067 Answers

SOURCE: my toshiba wont turn on but red light come on an green light flashing no picture or sounds

yes ill got remote link for u here give me one sec

Posted on Jan 29, 2008

SOURCE: KDF-60sbxr950 red light flash 4 times

Your projection bulb blew out.

Posted on Sep 19, 2008

  • 210 Answers

SOURCE: the lamp red light is flashing when shut off if i

replace lamp located behind cover on side of tv

Posted on Dec 13, 2009

  • 1 Answer

SOURCE: hitachi 53uwx10ba turns on & off when off red flashing light/clic

Same problem. Replaced both convergence ICs about 5 months ago. Worked fince since then and just recently no sound, no video, blinking red on front panel and clicking sound. I suspect that the ICs went bad again and blew a resistor or two. I used cheap Chinese ICs instead of the Sanyo ones and thing this is why. I'll be looking at it again and post solution.

Posted on Jan 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a sanyo tv model number is DP42849. when i turn it on the grren light comes on and about every few seconds it shuts off and comes back on but no picture or sound


That flashing light is called blink code and identifies the fault to a service engineer. Take it for repair. Don't try and fix it yourself unless you have done the 2 year full time television engineers course or you will end up buying every circuit board in there!

Mar 11, 2018 | Sanyo Televison & Video

1 Answer

No picture or sound


Hi,

Looks like a power supply issue the only solution to fix this up is to get it repaired.

Goodluck..

May 03, 2008 | Toshiba 32HFX72 32" TV

4 Answers

Tv tunrns on then goes to stand by flashes 4 times & repeats


turn tv on picture comes up 2to3 seconds later tv blacks out then stand by red light flashes 4 times in a row repeatedly..can not turn on or off when stand by light starts flashing but before tv blacks out you can turn tv on and off repeatedly and picture and sound work.You have to unplug power cord for 30 seconds after stand by light comes on to get tv to turn on.

Mar 13, 2009 | Sony BRAVIA KDL-32S2000 32 in. LCD HDTV

1 Answer

Standby/timer light stays on red. no picture or sound on tv.


my sony red light flash.but it will not turn on just clicks

Nov 26, 2008 | Sony KP-48S75 48" Rear Projection...

1 Answer

Changed bulb, now tv does nothing. . .please help


same problem. TV turns on but no picture or sound. when i press power button on the remote control orange light flashes for about a minute and goes back to red.
TV won't turn on. It iz frustating me a lot ay !

Mar 07, 2008 | Televison & Video

1 Answer

Fujitsu Plasma 42' approx 4 yrs old


HI , i have the same problem . it is either the power supply unit or the plasma display panel . I am problem solving it currently . generally the cost is about $1000 (aus) to fix . it is worth doing as fujitsu are outstanding plasmas .
if u need service manual pls email me at all_ps2_sales@hotmail.com and will send service manual .it has the the checks to do so u know which part needs replacing . U need some experience to do the checks
hope this helps

Dec 12, 2007 | Fujitsu Plasmavision PDS-4221 42 in....

1 Answer

Please Help


Is the red light flashing a code ? exaple 4 blinks pause 4 blinks ?

Apr 07, 2007 | Sony KV-27FV16 TV

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

75581 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

yadayada
yadayada

Level 3 Expert

80407 Answers

Are you a Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...