Manual for eclipse 36401 4 ch amplifier - Car Audio & Video

Only link I could find: https://vnykhzi.files.wordpress.com/2015/04/manual-for-eclipse-amp-36201.pdf

You can bridge the speaker outputs; positive from channel two(2) , and negative from channel one (1) : Positive from channel four (4) and negative from channel three (3).

I believe this will provide 140 watts from each bridged channel.

If it doesn't say call the mafactor

My advice is to get some one that noe,s what there doing, That you don,t fry the amp, End this advice is from a person ,That installed car audio equipment for over 40 (Years)

Here.

this is the manual and you will find all you need in it.

http://www.fixya.com/support/p78783-eclipse_ea3422_car_audio_amplifier/manual-18248#

google it most will give it for free

Eclipse 36401

• 105W x 4 Channel Max. Power Output at 2 Stereo
• 60W x 4 Channel 0.1% THD at 2 Stereo @13.8V (RMS Continuous Power)
• 40W x 4 Channel 0.1% THD at 4 Stereo @13.8V (RMS Continuous Power)
• ChannelFlex Crossover
• Adjustable High-Pass Frequency (50-200Hz, L/R Independent)
• Low-Pass Frequency (120Hz)
• Adjustable Bass-Boost Level (45Hz, 0-9dB, F/R Separate)
• High-Current, High-Speed Output Devices
• High-Efficiency, High-Energy MOS-FET Power Supply
• Audiophile Grade Component Selection
• Intelligent 7-Way Discrete Protection Circuitry
• Noise Reduction with Low Distortion & Ultra-Low Negative Feedback
• High-Level Input - Add on Capability
• Epoxy Composite PCB
• 2 Stable Design
  

Each 6 1/2" speaker will see 40 Watts
Each 6"x9" will see 521/2 Watts

Yes your solution is correct. Front wired in stereo, bridge rear.

hello. you can find what your manual at this linkhttp://www.eclipse-web.com/us-index.html.!!! hope this help's you. let me know "GOOD LUCK"

If I'm reading the amp manual right, you should be able to connect the amp in 3 channel mode. To do this:

• Connect both left door speakers in parallel to Ch A Left.
• Connect both right door speakers in parallel to Ch A Right.
• Bridge Ch B and connect it to the new 8" sub.
• Set the Ch A LPF/HPF to HPF.
• Set the Ch B LPF/HPF to LPF.

This should allow you to run all 4 door speakers and the sub from the amp. It will also automatically route non-bass to the door speakers and "only bass" to the sub.