Question about Lexmark X2500 All-In-One Printer

1 Answer

Problem with printing page

My printer prints perfectly fine on the first half of the page but the ink dies off on the second half of the page on certain lines. however, it does not tell me to replace my ink cartridge, and i believe the ink was not bought that long ago. i have the same problem prints only half page

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Lexmark Master
  • 684 Answers

In this case what i would request u to do is.......
Take out both the catridges from the Printer.........
Take 2 Paper Towels one should be wet with Luke warm water and the other one should be dry...........
Take the Colour catridge first turn it upside down and u will see a small copper plate on the catridge from where the ink comes out.......
Place the wet paper towel using ur thumb on the Copper plate and press it a lit bit for 10 Seconds......
Now remove it and see whether u see any ink on the paper towel..........
U should see some ink on it now place the dry paper towel on the ink catridge in the same way........
Now do the same procedure again..........
Do the same procedure twice on the Black Catridge.................
Now take the dry paper towel and turn the direction of the cartridge so that u can see a Copper plate on it with small boxes just clean that copper plate with the Dry Paper Towel..........
Know insert both the catridges inside the Printer the Colour Catridge should go in the right side and the black on the left........
Unplug the Power Supply from the printer.......
Replug in the Power Supply......
Try to Print it will work fine..........

Posted on Jan 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My HP deskjet 2050 all-in-one printer only shoots out blank paper and won't print. It used to say there was no paper in it, which there was. It scans & prints just fine - just won't print...


Any error messages on the printer digital screen or the desktop? I take it the "The ink is fine" means that there is ink in the cartridges!

Try a test print via the Control Panel> Printers and Faxes> properties > Print test page.

May 31, 2011 | HP PSC 2210 All-In-One InkJet Printer

2 Answers

My CLP-350 Samsung printer only prints black ink on half the page! While the other colours all print perfectly, the black ink prints strong and clear on the right side of the page but as you approach the...


Here is my solution, hope it will solve your problem.

From your post, I believe your CLP-350N printer has enough black toner. The black cartridge is on the far right side of the printer, so the black toner is harder to go to left side of the roller than right side. Everytime we start the printer, it will move some toner of each color to the roller before it shows ready to print.

Because we always use B&W printing when we start the printer, but less Color printing. The result is there are always enough toner on the 3 color rollers, but the black toner is lean on the black roller. When this gets worse, the left side of the black roller may hardly get any toner at all -- so it only print black on the right side fo paper.

Step by step solution
(CAUTION: Never loss balance while tilting printer! You may drop and damage your printer! Hold the printer firmly all the time! Ask someone to help you if needed!)

Here, front of the printer is where you can access the cartridge, back of the printer is where you connect the power cord and USB cable, left is your left, right is your right.

1.Lift the front to keep the printer tilt to its back at about 45 degree
2.Power on printer while it's tilted back, wait untill green light is on
3.Open the front door, red light will be on, then close the door, printer will start up again,wait untill green light is on
4.Repeat step 3 once again, then put the printer back to level position
5.Lift the right to keep the printer tilt to its left at about 45 degree
6.Open the front door, red light will be on, then close the door, printer will start up again, wait untill green light is on
7.Repeat step 6 once again, then put the printer back to level position
8.Print some test page to see if there is any improvement of black print quality.(Hold the printer button for 3-5 seconds, it will print the test page.)

You may try several times and print several pages each time before you finally cure the problem.

Good luck! And do it safely!

Jan 09, 2010 | Samsung CLP-350N Laser Printer

1 Answer

Problem with printing page


Normal 0 Driver could be corrupt.
Disconnect the printer or at least be sure it is turned off. I'd do both and reinstall the CD software program that came with the printer. When the software program asks you to connect the printer to the USB port, do so and it should again work properly.
Hope this helps. Bud

Jan 02, 2009 | Lexmark X2500 All-In-One Printer

2 Answers

Lexmark z845 ink refill problem


i need adisk to install z645 printer towindows vista couputer

May 08, 2008 | Lexmark Z645 InkJet Photo Printer

2 Answers

Full ink cartriges print a few lines and skip a few lines


well..did you run a test page?

or clean the print heads?

or recalibrate them?

recommend all these steps for you

and as my 2200th solution, you are entitled to a FREE tuneup for good. find out more about that service here

Mar 23, 2008 | Canon PIXMA iP90 Mobile Printer

1 Answer

Printing Photos


I refilled color ink for Dell Photo 924 but some reason it showing it me low ink.

Dec 09, 2007 | Dell 924 All-in-One InkJet Printer

1 Answer

Stops printing a full page picture half-way through and prints the rest on the next page in some random place. I have also had some problems printing text in the same way. The picture I am trying to print...


I noticed that when I restart Windows, I can print one sheet fine, the second sheet prints only half. Restart again, and I can print one more sheet.
My local Canon helpdesk proves as unhelpful as all helpdesks these days.

Dec 07, 2007 | Canon PIXMA MP600 all-In-One InkJet...

1 Answer

Deteriorating Print Quality


This is Maltesecross. Turns out that the faintness of my printed pages was in fact due to a low ink cartridge, even though some pages printed out fine and others half-good. Eventually, all pages turned faint, and upon re-installing the driver, I got a low-ink warning (the first one ever). Putting in a new ink cartridge solved the problem for me.

Oct 21, 2007 | HP Photosmart C3180 All-In-One InkJet...

3 Answers

Printer problem


on photos, If you have a laser printer with half a meg of RAM and you try and print a full page graphic at 300dpi you only get half a page because the printer runs out of RAM. You can get a full page by printing at 150dpi. could also be that the encoder strip has become fogged with aerosol, and needs gentle cleaning. Good luck

Mar 25, 2006 | Dell Inkjet 720 Printer

Not finding what you are looking for?
Lexmark X2500 All-In-One Printer Logo

129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexmark Printers & Copiers Experts

Roopesh S
Roopesh S

Level 2 Expert

228 Answers

Sanath Kumar V

Level 3 Expert

684 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18298 Answers

Are you a Lexmark Printer and Copier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...