Question about Toto Toilets ST753S 01 Cotton Dartmouth Toilet with Traditional SoftClose s

1 Answer

Toto Toilet - no water flow to refill tank after flush

I am not familiar with the Gmax system. Toilet is about 2 years old. After flushing the water flow to refill the tank does not flow. Other toilets in house work fine. . . What can you tell me to do?

Posted by on

  • 8 more comments 
  • Anonymous Jan 19, 2009

    toilet tank water level goes down by an inch and stops

    its a Dalton Round ToTo Model

  • Anonymous Mar 12, 2014

    the tank gsge was at 100psi, and you flush toilet you could air skushing or when turning on the shour.

  • Anonymous Mar 12, 2014

    third floor toilet does not flush good it seems to have a big bubble when it flushs 7 year old house

  • Anonymous Mar 12, 2014

    third floor toilet does not flush good it seems to have a big bubble when it flushs 7 year old house

  • Anonymous Mar 19, 2014

    tank keeps refilling without being flushed

  • Anonymous Mar 20, 2014

    NO water comes into the toilet tank after flushing.

  • Anonymous Mar 20, 2014

    float moves fine, flapper fits fine, with no water running. there is no water returning to the tank. none. sink works fine. shower too. little tube from pole assembly to refill tower is flowing. Where did the water go? Shut off has not been shut off. No water in cellar.. How to make the water flow again?

  • Anonymous Mar 25, 2014

    water does not flow when toilet is flushed

  • Anonymous Mar 30, 2014

    After flushing there is a moaning sound when the toilet is refilling and the valve coming from the wall vibrates

  • Anonymous Mar 31, 2014

    How do the inside mechanisms go together

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

Remove the tank lid and look at the fill valve. Is it a yellow valve?
This fill valve is common on the Toto Toilets and can easliy plug with debrie.

They can be disassmbled and cleaned. however, I usually just replace the valve with Fluid Master Fill valve.
You will also want to check the water coming into the toilet by turning off the water that supplies the toilet and disconnecting the water supply line. After removing the water supply line turn on the water at the valve to make sure that the water is flowing properly. Check the supply line also to make sure it is not plugged.
Be sure and place a small container to catch the water that will come from the valve. A towell will also help from making too much of a mess.
If the Supply line and the valve are clear the problem is in the fill valve.
The G-Max system denotes the Flushiing system which is a 3" flapper that allows the water from the tank to flow into the bowl quicker.
Good Toilets!

sanray

Posted on Jan 10, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I get the water to stop filling the tank on my toto ST794S toilet?


there should be a screw adjustment on the ballcock or fill assembly...screw that down some to adjust...that regulates your tank water level....that screw goes in or out to adjust...one or other should do the trick...may have to do this a few times to get proper adjustment...good luck..

Jul 07, 2014 | Toto St794s-12 Nexus Tank With G-max...

1 Answer

It takes a long time to fill the tank


There could be partial blockage of the water supply line causing a slow fill.

Feb 20, 2014 | Kohler Cimarron Comfort Height elongated...

1 Answer

The toilet tank does not refill automatically once the lever is pushed and the water flushes out of the tank. In order to get the tank to fill with water again after the toilet is flushed, I have to take...


Just replace the whole assembly. It only costs 12-15 dollars. Water contains so many minerals that just clog up lines like cholesterol. Just be done with it. It is not worth the effort to try to clean all that out . Plastic is sometimes not very forgiving.

Jan 28, 2013 | Toto Drake ADA Compliant Toilet with...

1 Answer

Toilet tank fills slowly


My sister has a two year old Jacuzzi toilet that worked fine until a few months ago. Then it started to take 10 minutes to shut off after each flush. I lifted the tank cover and immediately saw the problem; at least 90% of the refill water was going into the refill pipe instead of the tank. Upon examination I discovered that the plastic part that holds the flexible refill tube to the vertical refill pipe was broken. This part not only holds the refill tube in place, it also has a small orifice at the end to restrict the flow into the pipe. The part was broken in such a way as to let nearly all the water go into the refill pipe instead of the tank, hence it would run for 10 minutes after the toilet bowl was full and waste all that water. I found a small coarse thread stainless steel screw that fit into the plastic attachment piece to help plug the orifice and cut down the amount of water going to the refill pipe. Now the toilet flushes and refills in less than 2 minutes. I'm in the process of trying to find a replacement for that part but so far no luck.

Mar 29, 2012 | Jacuzzi BK37959 White Era?? Two-Piece...

1 Answer

Howdy, the tank on my Baden dual flush toilet out of blue eill not refill after being flushed. The water is not filling the tank. Can you help me, this toilet is not even one year old. Thank you. Sue


We have replied that it sounds as if your internal flush kit button is stuck in the down position. If you continue to have problems please contact us for a replacement flush kit for free. Thank you.

Aug 20, 2011 | Dmm Baden Bath One-piece Toilet

1 Answer

After a water main problem in the neighborhood was worked on with my home losing water pressure the water in the house became airborne. My toto gmax flushed once or twice with brown water and then...


turn off water to toilet.Take the three top screws out of the flush valve .Which is that valve the water pours out from to fill the tank.clean the diaphram inside.Probably see alot of dirt inside.You'll probably want to take all your aerators off your faucets and flush the dirt out of them too

Jan 21, 2011 | Home

1 Answer

The toilet takes a long time to refill after a flush would there be a certain part that is plugged or wore out ?


Is the flapper valve slow to return to the closed postion allowing water to flow through the flush valve? Make sure the toilet flapper is moving freely and is sealing properly against the flush valve. If there is no lengthy or continual water flow in to the toilet bowl then this is not the problem.

Is the water valve on the water fill line to the toilet tank fully open? This may seem silly but it could be this simple.

Check to make sure your fill valve is opening fully. If you have an older toilet there may be some deposits that need to be cleaned way to allow free movement.

If toilet does eventually fill to the desired level, there is no leakage, water valve on fill line is fully open and fill valve is opening fully then recommend you shut off water supply, drain toilet and disconnect water fill line from the water valuve and toilet tanke to make sure there is not a blockage. If the water line and connections are clear you may need to remove the fill pipe in the tank and check for blockage. If this is very old, conisdering the cost and effort, it may be simpler to replace at this time rather than trying to extend the life.

Jan 15, 2011 | American Standard Home

1 Answer

I have a toto toilet that doesn't start to refill until a couple of minutes after I flush. Any ideas. Thanks.


Several ideas. Start to fill? Have you looked inside the tank to see what's going on? If it just filling very slowly, then you most likely have some calcuim build up inside your flush valve blocking some flow, if this is the case you will have to clean the flush valve. If your flush valve is staying up and the toilet is "running" unitil the float drops. The float (either the arm ballcock style, or newer fluidmaster) is rubbing on either the flush lever or side of the tank, and taking longer to drop to let the water start flowing. I

Jun 23, 2010 | Toto Toilets ST784S 12 Sedona Beige...

1 Answer

Toto Dorian toilet does not flush clean


Don't know if you have calcium build up problems. If you do you could pour a calcium cleaner into the tank to try and clear up the problem. This would be the only way to possibly clean the enclosed area. Good Luck. Jeff

Apr 05, 2010 | Toto Promenade, 1.6 GPF, Elongated...

3 Answers

Gmax flushing system won't stop


WATER LEVEL IS NOT PROPERLY ADJUSTED. REDUCE WATER LEVEL TO FILL LINE

Jan 07, 2010 | Toto Drake Tank W/GMAX RH COTTON WHITE...

Not finding what you are looking for?
Toto Toilets ST753S 01 Cotton Dartmouth Toilet with Traditional SoftClose s Logo

4,859 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toto Home Experts

Donni Steen

Level 3 Expert

659 Answers

john h

Level 3 Expert

7836 Answers

Mike

Level 3 Expert

4332 Answers

Are you a Toto Home Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...