Question about Sylvania LC-225SL9 22 in. LCD TV

Open Question

Sylvania lc225sl9 22in lcd, power but no picture or sound

The power indicator light is blinking, yet no picture or sound

Posted by on

5 Suggested Answers

SOURCE: no picture and no sound just a blinking stand by light on front of my sony kdl40s2000 lcd tv

I have a Sony KDL40S2000 and three months out of manufacturer warranty my TV made a clicking noise similar to feedback in a bad sound system and went to black screen. The error was not recoverable and four blinking lights were seen by a technician. I bought the extended warranty from my store, so I was covered. After one month in the shop, the technician brought my TV back today and told me the panel was replaced which would have cost me 1000 dollars if I wasn't covered by the store warranty. I read on another site the four flashing lights can mean a bad inverter. I don't know enough about TVs to tell you if the panel and inverter are one in the same, I just know you need to get it repared if you get four blinking lights at a huge cost!

Posted on Jan 30, 2008

  • 2 Answers

SOURCE: Samsung LTN1765 has blinking green power indicator, but no picture or sound

Try replacing C51, a 10 microfarad 16v. surface mount electrolytic. It's near IC23 on the upper center of the board.
This part had high ESR on a couple of sets I serviced which
kept the power supply from starting.

Posted on May 10, 2008

  • 2 Answers

SOURCE: Polaroid LCD FLM-3232 Television

Go to http://www.fixya.com/support/r741402-polaroid_flm_373b_lcd_tv_black_screen. Stiv0 posts the fix at the top, but go down about 10 posts or so and read mine (BlakeFromGa). I have some slight differences to my fix and a list of what you'll need.

Posted on Sep 29, 2008

  • 3 Answers

SOURCE: Sylvania LC225SL9 LCD TV have RCN cable would like code 4 remote

Unfortunately, there are no compatible universal remotes with this television.

Posted on Feb 22, 2009

budmrtn
  • 11361 Answers

SOURCE: power light just blink on my sylvania lc320ss9a lcd

It can be the power supply is unstable due to bad DC filter caps, or it is sensing short circuits caused by backlight board, you will have to take it apart and start by visual inspection first, look for bad caps iwth leaking/bulging tops (caps can look OK but can have high ESR). Then you need to do voltages checking.
If you are going to DIY and have proper tools, electronics knowledge, and know safety precaution then please read on:

Please see my basic troubleshooting guide here:
http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide

http://s807.photobucket.com/home/budm/allalbums

http://en.wikipedia.org/wiki/Capacitor_plague

Parts: www.shopjimmy.com

Posted on Jul 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you fix a flashing green light and no picture or sound?


These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices.
http://electro-medical.blogspot.com/

Jan 10, 2016 | Sylvania Televison & Video

1 Answer

Our sharp tv model # LC-42D72U power light flashes green but there is no sound or picture. Looking for your expert opinion on what could be wrong so we can get the part ordered. The board with the power...


Green on light is blinking, but no picture - Television - iFixit

https://www.ifixit.com/.../Green+on+light+is+blinking,+but+no+pict..
iFixitOct 3, 2014 - The Sharp LCD TV LC37SB24U set worked until off button on remote ...The green light is blinking any time power cord is plugged into the wall outlet. ... It does sound like either a bad inverter board or a bad power supply. .... On the clad sidethere is no connections or ribbons that indicate hard current draw ...

Oct 20, 2015 | Sharp LC-42D72U 42 Flat Panel 1080p...

1 Answer

Tv turned off. Will turn on to standby light. Green powerr light flashes and then tv turns off back to red standby light. No picture. What to do?


These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices. http://electronicshelponline.blogspot.com/
Blinking codes details to many popular brand TVs are given. Surf the site with patience.

May 26, 2015 | Sylvania LC420SS8 LCD TV

2 Answers

Samsung LA40A550 no picture and sound


Power supply board is dead.That the board,the power a/c cord go into it.Replaced the power supply board will solved ur tv power lite LED light indicator blinking and ur tv power will be stable and work again.Tries websites like Shopjimmy.com,Ebay.com to buy a whole refurbish power supply board for the replacement.

Jun 04, 2010 | Samsung LA40A550 40 in. HD-Ready LCD TV

3 Answers

My tv will not pwr up. grn light flashes then turns red.


I have a Sylvania LD320SS8A and I turn it on and the green light comes on and no picture???? Just black... I can hear some sound but no picture...

Feb 12, 2010 | Sylvania LC320SS8 32 in. LCD Television

2 Answers

Picture goes out after 3 seconds then may come back on then off again


Hi,
If green light in front of TV blinks while picture goes off and comes back then its symptom of weak lamp that need to be replaced.
And if green light does not blink in above process then let me know.
Thanks.

Nov 23, 2009 | Sony KDF-E60A20 60 in. LCD HDTV

2 Answers

Picture & sound go on & off every sec, red light blinks 5 times


helloFive blinks - AKB circuit (automatic kine bias), the timer/standby indicator blinks for about 30 seconds then goes to the self-diagnosis function. Something is wrong with the video. Check video out, Q705, 732, 761 and other components on the C board, also check Q218, 219, 220 on the A board. In addition, unit could be in IK blanking, try turning up screen slightly.

shaun

Oct 25, 2009 | Sony Grand WEGA KDF-55XS955 55" Rear...

1 Answer

Ilo 27" lcd tv


If your LCD has a defective power supply module will cause the following symptoms:
No Display and no Sound, Then Power indicate light changes from Green to Red.

Apr 29, 2008 | iLO LCT32HA36 Television

Not finding what you are looking for?
Sylvania LC-225SL9 22 in. LCD TV Logo

Related Topics:

130 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sylvania Televison & Video Experts

The Knight
The Knight

Level 3 Expert

71117 Answers

matt martin
matt martin

Level 3 Expert

1207 Answers

Dave Naylor
Dave Naylor

Level 3 Expert

834 Answers

Are you a Sylvania Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...