2006 ford escape immobilizer problems I unlockt my truck got in put the key in the ignition and turned the key forward one click to turn all the Electracul stuf On every thing came on and then shut off with a constant clicking sound the seat belt light comes on and the immobilizer light flashes none of the door Locks work key fob does not work and other stuf please help

2008 Ford Escape Have To Push Key In Ignition Very Hard ...

www.carcomplaints.com/Ford/Escape/2008/.../have_to_push_key_in_ig...

push key switch in hard to start 2nd time (3 reports) ... Our next step is to replace the lock housing assembly or the ignition lock cylinder. ... The ignition switch on my 2008 Ford Escape randomly turns over -- apparently when it feels like it.

Ford Escape ignition switch no start switch replac - YouTube

? 1:10
https://www.youtube.com/watch?v=bv8tDCf83Vc
Jan 28, 2014 - Uploaded by mosaitogo
Sometimes vehicle would not start when crank/start pos. ...having to push in on the key because the tip of rod is jumping out of switch . .... I currently have my ignition switch dangling down, and I just manually turn it with a screw driver .... Thanks I had this issue since last year with My Ford Escape 2008 but ...

22 Ford Vehicles No crank/ No Start Trick - YouTube

The motor can be replaced without touching the immobilizer system. There may be no problem with the immobilizer system as it only turns off power to the fuel pump or ignition spark.
better yet just re-seed the immobilizer ECM with the dealer

had the same problem on a 99 buick regal no power going to starter silinoid and dash lights went out when key is put in start position.turns out it was the ignition switch.95.00 at auto zone

cant turn off problem you can try another key.put key in the ignition turn on position for 3 seconds the security light should turn off.then turn off ignition switch wait 5 to 10 seconds try start vechicle if still fails to start.problem in the theft security system.dealership has to code scan problem could be in the ignition switch which is antenna ring.problem could be transponder key or problem could be in the immobilizer control module and ECM.

Hi,
Your Escape's battery is dead and needs replaced.

GL,
Td

Cv axles normally click repetedly when moving ,doesn't sound like an axle,more like a motor mount or brake calpier .If you put your foot on the brake with the hood open ,put the truck in reverse and put a load on it and then in drive and load it you will be able to see the engine rock excessivly if a mount is bad.

Safely secure the parking brake put a 12 Volt test light on the starter wires at the starter have someone help you by turning the key to the start position , if the test light lights replace the starter , if the test light don't light check your fuse if it is good replace the relay .

has the key been programmed?

The steering wheel lock may be putting pressure on the lock mechanism. Try turning the steering wheel a little either way as you turn the ignition key.