Question about Hotpoint 18 in. DC28 Slim-Line Built-in Dishwasher

1 Answer

Diplomat Dishwasher ADP8352 Will not complete wash Cycle

Water will drain on initial start up and will Pump into unit as part of the cycle then stops you can hear the pump as if siezed. Inspection of the proved pump free to turn pump capacitor checked good. after inspection and returning Dishwasher to upright position it went through full cycle without a hitch. on second attemp dishwasher failed produced same symptons. Could this be a fault with the Control PCB

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My Diplomat ADP8352 when running a cycle it will run for ages, doesn't seem to get hot. If i switch off the m/c then switch it on again it dumps the water left in the m/c?

any ideas?

Posted on Aug 18, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

LG dishwasher LD1419W2 which would not fill -error code IE. I replaced the inlet hose complete. Now it has the error code FE and the water overflows onto the floor when in wash cycle. Peter

Try resetting by:
turn off dishwasher
trip circuit breaker to remove all power to unit
wait 30 seconds
restore power
start dishwasher
the drain pump should start and drain all water then start a cycle. Good luck

Nov 14, 2017 | LG Dishwashers

2 Answers

Diplomat intergrated dishwasher error code FA

FA is a problem with the tubidity sensor. By holding down the power button, it stops, but just repeats everytime you try a new wash cycle. So keep doing it and you can atleast use it. If you want to go one step further and find a permanent solution try feeling around in the sump (where the filter slots in) being careful for any broken glass. Other than that it will probably be a strip-down job to examine the internal hoses and the pump; not a DIY job to be honest.

Feb 03, 2008 | Dishwashers

1 Answer

My dishwasher will not drain

could be a blocked drain or faulty drain pump or faulty controller.

Do you have a model no.
Also confirm if the wash cycle did start correctly and it ran through it according to the time. Does the dishwasher stop in the middle of the cycle or it completes the cycle with lights turning off but water still inside.
Did the drain pump actually run?

Sep 06, 2010 | Frigidaire Dishwashers

1 Answer

My Diplomat dishwasher ADP8352 keeps stopping

Switch off the machine at your plug end and switch ON.

Check incoming water flow. Check and fill rinse-aid liquid in the dispenser. Check dish washer salt dispenser and fill.

These are the only actions an user can try.

May 27, 2010 | Dishwashers

1 Answer

I have a Diplomat Fully integrated dishwasher model ADP 8242 when put on any program it fills and seems to be washing then stops after 5 minutes and the dispenser door has not opened. There is a lot of...

Check the small drain pump. Possibly its asking the pump do drain to allow for fresh water, but because low level is not detected it shuts down. The dispenser draw normall opens when the hot wash cycle starts.When you think its washing,briefly open door and see if eater is spraying out of the nozzels.If no water visible, check the main wash motor for sticking

Sep 24, 2009 | Dishwashers

2 Answers

Bosch dishwasher has water in bottom after cycle is complete


Kindly check for the following :

Check for hose kinks or food plugging drain hose. Start at the drain port exit.
Check the check valve and drain hose for debris.
Check pump motor for reversing during the pump out make sure the dishwasher is pausing between the wash and drain cycles letting the pump/motor reverse for the drain cycle.
Check pump motor assembly for a drain solenoid, during the pump out make sure the solenoid makes that distinctive "clunk" noise
If you have recently installed a new garbage disposal, check knock-out plug at connection.


Check pump impeller for damage.
Check that the water inlet valve isn't seeping fresh water into the dishwasher when off.

Please contact for any further clarifications.

A Fixya Rating would be appreciated if.


Feb 13, 2009 | Bosch 24 in. SHU53 Built-in Dishwasher

3 Answers

Bosch Dishwasher wont drain

have you removed the filter? if it gets clogged the dishwasher wont drain. other wise is sounds like a faulty drain pump

Nov 17, 2007 | Bosch 24 in. SHY56A05 Stainless Steel...

1 Answer

GE Nautilus won't drain after Rinse Cycle

Check disposer plug. If a garbage disposer has been recently installed, it is possible the disposer drain plug was not removed. The drain plug is a plastic piece in the disposer that blocks the hole where the dishwasher hose connects. Also check the hose connected to the disposal. Mine apparently had a kink in it. When I straightened the hose the dishwasher drained at full speed (I recently had a plumber re-route a hot waterline. He must has bent the hose). Hope this helps. If not go to the GE website. That's where I found my answer.

Nov 03, 2007 | GE 25 in. Nautilus GSC3400J Free-standing...

Not finding what you are looking for?
Hotpoint 18 in. DC28 Slim-Line Built-in Dishwasher Logo

2,225 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hotpoint Dishwashers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers


Level 3 Expert

77939 Answers

Brad Brown

Level 3 Expert

16841 Answers

Are you a Hotpoint Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides